Da-Lite Tensioned Professional Electrol Bruksanvisning

Da-Lite Projektionsduk Tensioned Professional Electrol

Läs nedan 📖 manual på svenska för Da-Lite Tensioned Professional Electrol (12 sidor) i kategorin Projektionsduk. Denna guide var användbar för 7 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Sida 1/12
INSTRUCTION BOOK FOR
Tensioned Professional Electrol®
2
Important Safety Instructions
When using your video equipment, basic safety precautions
should always be followed, including the following:
1. Read and understand all instructions before using.
2. Position the cord so that it will not be tripped over, pulled, or
contact hot surfaces.
3. If an extension cord is necessary, a cord with a current rating
at least equal to that of the appliance should be used. Cords
rated for less amperage than the appliance may overheat.
4. To reduce the risk of electric shock, do not disassemble this
appliance. Contact an authorized service dealer when repair
work is required. Incorrect reassembly can cause electric
shock when the appliance is used subsequently.
5. The use of an accessory attachment not recommended by
the manufacturer may cause a risk ofire, electric shock, or
injury to persons.
6. Failure to provide adequate structural strength for this
component can result in serious personal injury or damage
to equipment! It is the installer’s responsibility to make sure
the structure to which this component is attached can
support the weight of all equipment. Reinforce the structure
as required before installing the component.
7. Use this projection screen only for its intended use as
described in these instructions. Do not use attachments not
recommended by the manufacturer.
Save These Instructions
Pre-Installation
1. Carefully unpack screen.
2. Make sure to recheck measurements of screen location
before installation.
3. Remove instruction cover plate (Fig. 1). Do not remove
wrapping paper until screen is installed.
4. Remove the retainer screws from the slat bar before the
case has been installed (Fig. 2).
Figure 2
Slat Retainer Bracket
(3 Screws)
1 On Bottom of Slat
2 On Inside of Case
Figure 1
Instruction Cover
Case
Original Instructions
Disclaimer
Milestone and its ailiated corporations and subsidiaries
(collectively "Milestone"), intend to make this manual accurate
and complete. However, Milestone makes no claim that the
information contained herein covers all details, conditions or
variations, nor does it provide for every possible contingency in
connection with the installation or use of this subject to change
without notice or obligation of any kind. Milestone makes no
representation of warranty, expressed or implied, regarding the
information contained herein. Milestone assumes no
responsibility for accuracy, completeness or suiciency of the
information contained in this document.
Da-Lite® is a registered trademark of Milestone AV Technologies.
All rights reserved.
3
Hangers (If required)
1. See Figure 3 for hanger placement.
2. Make sure hangers are placed to it into notches of
ironing board..
Installation
11
1
2
"
11
1
2
"
Screens Over 22' Wide
Figure 3
11
1
2
"
11
1
2
"
Screens 22' Wide And Under
Case Length ÷ 2
Case Length ÷ 2
(Case Length – 23") ÷ 3
(Case Length – 23") ÷ 3
(Case Length – 23") ÷ 3

Produktspecifikationer

Varumärke: Da-Lite
Kategori: Projektionsduk
Modell: Tensioned Professional Electrol

Behöver du hjälp?

Om du behöver hjälp med Da-Lite Tensioned Professional Electrol ställ en fråga nedan och andra användare kommer att svara dig




Projektionsduk Da-Lite Manualer

Projektionsduk Manualer

Nyaste Projektionsduk Manualer