Fellowes Array AR2 Bruksanvisning

Fellowes Luftrenare Array AR2

Läs nedan 📖 manual på svenska för Fellowes Array AR2 (16 sidor) i kategorin Luftrenare. Denna guide var användbar för 12 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/16

PLEASE READ THESE INSTRUCTIONS BEFORE USE.

DO NOT DISCARD: KEEP FOR FUTURE REFERENCE.

VEUILLEZ LIRE CES INSTRUCTIONS AVANT D’UTILISER L’APPAREIL.

NE PAS JETER : CONSERVER AFIN DE CONSULTER LES DIRECTIVES

ULTÉRIEUREMENT, EN CAS DE BESOIN.

LEA ESTAS INSTRUCCIONES ANTES DEL USO.

NO LAS DESECHE: CONSÉRVELAS PARA REFERENCIA FUTURA.

Array AR2

Recessed Air Purier

Puricateur d’air encastré

Puricador de aire empotrado

Install Guide

Guide d’installation

Guía para la instalación

ENGLISH

TOOLS REQUIRED FOR INSTALLATION

• Air Purifier (1X)

• Hybrid Filters w/ Pre-Filter (1X)

• 16ft mounting cables with clutches (4X)

• Centering Blocks (4X)

• User Manual (1X)

• Gloves

• Ladder/Step Stool

• Straight or 90° Conduit Connector

• Wire Nuts

• Level

• Tape

• Two adjacent, unobstructed 24” x 24” drop ceiling tiles with at least 18”

clearance above the drop ceiling

• Mounting hooks or location installed to local code and capable of holding

the weight of the system

• For ease of installation and optimal placement of unit in the grid, it is

HIGHLY RECOMMENDED that either hooks be drilled into the ceiling, or strut

channels be used to loop cables if there are no existing mounting points

available above the perimeter of the housing.

PACKAGING CONTENTS

NOTE: Two people are required, three people recommended, for

easy and proper installation.

NOTE: We recommend removing additional adjacent ceiling tiles for

easiest installation.

NOTE: It is required to remove one cross-tee in the ceiling grid.

NOTE: Do not install next to a return or register.

NOTE: Shut off circuit breaker to installation area before

beginning installation.

INSTALLATION INSTRUCTIONS

Before beginning installation, ensure that a

qualified electrician has run a 120V circuit

to the installation area. Remove unit from

packaging and stage on a tabletop or other

surface under or near installation area with

door facing upwards.

Open unit door by depressing the latch button

and pulling upward. Have one person hold

the door open while filter and hardware are

removed.

NOTE: Do not remove corrugate support trays

attached to the door yet.

Disengage the filter clamp lever until a click

is heard.

NOTE: Locking/ unlocking motions are in

opposite directions between left and right

filter changing mechanisms.

123

Pull filters out by the straps and set aside

for now.

Close the door until a click is heard. Depending on

type of ceiling, attach proper mounting hardware

above installation area per local regulations for

supporting a 92 lb (42kg) fixture. Ideally the

mounting locations would be at the four corners of

a 23" x 46" rectangle.

Remove mounting hardware and verify included

part quantities.

Loop open end of cables through intended

support or hardware.

Use provided cable clutch hardware to secure

each cable.

Remove cross-tee where unit will be installed.

Raise the unit until the top of the housing is just

below the grid.

NOTE: If unit is raised too high, have one person

raise the unit while the other depresses the

spring section on the wire clutch, allowing the

cable to be loosened.

Have one or two people slowly lifting the

machine while the other pulls the free end of

the cables to keep them taut.

Alternate slowly raising each side to keep the

unit relatively level during lifting.

WARNING: During lifting ensure hooks stay

oriented correctly and do not get misaligned or

they may not hold properly.

CAUTION: To reduce the risk of injury to

persons, install fan at least 2.1 m (6.9 ft) above

the floor.

Lift and rotate unit before setting door-side down

on the provided trays. Determine which electrical

knockout will be used and remove it.

WARNING: do not place directly on any flat

surface as this will damage the sensor that sticks

below the bottom surface.

Secure the hooks from the provided

aircraft cabling to the housing through the

mounting holes.

456

8A 8B

10 11

Produktspecifikationer

Varumärke:	Fellowes
Kategori:	Luftrenare
Modell:	Array AR2
Enhetsplacering:	Vrijstaand
Typ av operation:	Touch
Inbyggd display:	Ja
Vikt:	36500 g
Bredd:	448 mm
Djup:	600 mm
Höjd:	845 mm
Nettoskatt:	2100 W
Antal platsinställningar:	9 couverts
Dörrfärg:	Wit
Sladdlängd:	1.5 m
Fördröjd starttimer:	Ja
Startfördröjning:	24 uur
Indikering av återstående tid:	Ja
Barnlås:	Ja
Cykelns längd:	235 min
Ljudnivå:	49 dB
Energie-efficiëntieklasse:	F
Vattenförbrukning per cykel:	9.5 l
Bulleremissionsklass:	C
Antal tvättprogram:	6
Energiförbrukning per 100 cykler:	78 kWu
Produktstorlek:	Slimline (45 cm)
Färgkontrollpanel:	Wit
Saltindikator:	Ja
Sköljmedelsindikator:	Ja
Antal temperaturinställningar:	5
Extra torr:	Ja
Halvlastad:	Ja
Tvättprogram:	Auto, Eco, Glass/delicate, Intensive, Silent
Energiförbrukning per cykel:	0.78 kWu
Avloppsslangens längd:	1.38 m
Vattentillförselslangens längd:	1.5 m
Certifiering:	GS; CE; EMC; LVD; CB
Temperatur (max):	65 °C
Strömförbrukning (när avstängd):	0.49 W
Inbyggd vattenavhärdare:	Ja
AC-ingångsspänning:	220 V
AC-ingångsfrekvens:	50 Hz
Type beeldscherm:	LED
Energieffektivitetsskala:	A tot G