Fellowes Powershred HS-440 Bruksanvisning

Fellowes Inte kategoriserad Powershred HS-440

Läs nedan 📖 manual på svenska för Fellowes Powershred HS-440 (8 sidor) i kategorin Inte kategoriserad. Denna guide var användbar för 7 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF
Sida 1/8
Quality Office oducts Since 1917Pr
POWERSHRED
® HS-440
Please read these instructions before use.
Do not discard: keep for future reference.
Veuillez lire ces instructions avant d’utiliser l’appareil.
Ne pas jeter : conserver afin de consulter les directives
ultérieurement, en cas de besoin.
Lea estas instrucciones antes del uso.
No las deseche: consérvelas como referencia futura.
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
• Keepawayfromchildrenandpets.Keephandsawayfrom
paper entry. Always set to off or unplug when not in use.
• Keepforeignobjects–gloves,jewelry,clothing,hair,
etc.–awayfromshredderopenings.Ifobjectenterstop
opening, switch to Reverse ( ) to back out object.R
• Neveruseaerosolproducts,petroleumbasedlubricantsor
other flammable products on or near shredder. Do not use
canned air on shredder.
• Donotuseifdamagedordefective.Donotdisassemble
shredder. Do not place near or over heat source or water.
• ThisshredderhasaDisconnectPowerSwitch(C)inthedoor.Thedoor
must be closed to operate shredder. In case of emergency, open door.
This action will stop shredder immediately.
• Avoidtouchingexposedcuttingbladesundershredderhead.
• Shreddermustbepluggedintoaproperlygroundedwalloutletor
socket of the voltage and amperage designated on the label. The
grounded outlet or socket must be installed near the equipment and
easily accessible. Energy converters, transformers, or extension cords
should not be used with this product.
• Donotoperatethemachinewithoutthesafetyflapclosed(A).
Will shred: Paper only
Will not shred: Adhesive labels, continuous form paper, transparencies,
newspaper, junk mail, credit cards, CD/DVDs, staples, paper clips,
cardboard, laminates, file folders, X-rays or plastic other than noted above
Paper shred size:
High Security Micro-Cut (Din 6) 1/32 in. x 3/16 in. (0.8mm x 5.0mm)....
Maximum:
Sheets per pass ...................................................................................4*
Paper entry width 9-1/2 in. (241mm) ......................................................
* 8.5 in. x 11 in., 20lb., (75g) paper at 120V, 60 Hz, 3.2Amps; heavier
paper, humidity or other than rated voltage may reduce capacity.
Recommended maximum daily usage rates: 1,000 sheets per day.
4 sheets per pass.
*In order to perform at capacity, shredder must be plugged into
a dedicated 15Amp, 120V outlet and oiled every 15-30 minutes
of continuous use.
Stops automatically
when door is
opened. Symbols
flash alternately
Stops automatically
when bin is full.
Empty bag when
bag full indicator
lights up
H. Control Panel and LEDs
1. ON/OFF
R
2. Reverse
3. Bin full
4. Door open
5. Safety Flap Open
A. Safety Flap
B. Paper entry
C. Disconnect switch (open door)
D. Door
E. Wire Frame - paper (inside)
F. Casters
G. See safety instructions
R
Sleep Mode
Energy saving feature shuts down
the shredder after 1 hour of inactivity
2
ENGLISH
Model HS-440
KEY
INDICATOR LIGHTS
A
.
B.
G.
H
.
F.
E
.
D
.
C.
Stops automatically
if too much
paper is inserted.
Automatic reverse
if paper jams
Stops automatically
if safety flap is
opened. Symbols
flash alternately
Overload protection.
Machine stops to cool
down- approx. 10-15
minutes. Symbols
flash alternately
CAPABILITIES
ADVANCED PRODUCT FEATURES
All high security shredders require oil for peak performance. If not oiled,
a machine may experience diminished sheet capacity, intrusive noise when
shredding and could ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty your waste bin or
every 15-30 minutes of continuous use.
OILING SHREDDER
R
R
3
2
*Apply oil
across entry Press Reverse (R)
Set to Off ( )
and unplug
Important: For optimal shredding perfomance, use Fellowes High
Security oil (3505701). *Use of standard shredder oil is not
recommended.
SHREDDER SET-UP PAPER
Ensure access
to a dedicated
15Amp, 120V
outlet
R
41 3
R
2
Paper detection sensors are designed for maintenance free operation. However, on
rare occasions the sensors may become blocked by paper dust causing the motor to
run even if there is no paper present (Note: two paper detection sensors are located in the center
of the paper entry).
Turn off and
unplug shredder Locate Auto-start
infared sensor Clean any
contamination from
the paper sensors
12 3 4
Use thin, long-handled
brush to clean sensors.
Make sure brush is
clean and dry
Set to Off ( ) and empty bin. Replace bin and follow the below
procedures.
Stops automatically
if too much paper
is inserted.
Automatic reverse
if paper jams
2 3
Gently pull uncut
paper from
paper entry.
Machine runs for
a short time in
reverse. Repeat if
necessary
Fellowes is committed to giving our customers the support and service they deserve. That is why we offer several options for you to find technical
information, step-by-step assistance and personal attention.
•www.fellowes.com features an extensive on-line support section with a number of self-service options
•Ourcustomerserviceprofessionalsarededicatedtoresolveanyofyourissues
Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.
1
1
Open the door
1 2 34
o
5
3
In sleep mode To get out of sleep
press ON ( ) insert paper
or
R
2
1
Shred One Sheet
3
BASIC SET-UP
BASIC PRODUCT MAINTENANCE AND TROUBLESHOOTING
CLEANING AUTO-START INFRARED SENSORS
PROBLEM STILL NOT SOLVED?
BASIC SHREDDING OPERATION
Place cutter head
into top of cabinet,
use 2 people
Plug in and make
sure door is closed Press ( ) ON to
activate When finished
shredding set to
( ) OFF
Feed paper
straight into paper
entry and release
Do nothing and
shredder will go
automatically to
sleep mode after
1 hour
Make sure safety
flap is securely
in place
PAPER JAM
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
WHEN IN SLEEP MODE
TO CLEAN THE SENSORS

Produktspecifikationer

Varumärke: Fellowes
Kategori: Inte kategoriserad
Modell: Powershred HS-440

Behöver du hjälp?

Om du behöver hjälp med Fellowes Powershred HS-440 ställ en fråga nedan och andra användare kommer att svara dig


Inte kategoriserad Fellowes Manualer

Fellowes

Fellowes 8038201 Bruksanvisning

20 September 2024
Fellowes

Fellowes Metal 100r Bruksanvisning

15 September 2024
Fellowes

Fellowes Office Suites 9140303 Bruksanvisning

29 Augusti 2024
Fellowes

Fellowes Hana Bruksanvisning

27 Augusti 2024
Fellowes

Fellowes Powershred HS-440 Bruksanvisning

24 Augusti 2024
Fellowes

Fellowes 56211-73 TB 450 Bruksanvisning

21 Augusti 2024
Fellowes

Fellowes 8043401 Bruksanvisning

20 Augusti 2024
Fellowes

Fellowes Astro A4 Bruksanvisning

18 Augusti 2024
Fellowes

Fellowes I-Spire 94735 Bruksanvisning

15 Augusti 2024
Fellowes

Fellowes Partition Additions 77032 Bruksanvisning

6 Augusti 2024

Inte kategoriserad Manualer

Nyaste Inte kategoriserad Manualer

Philips

Philips 43PUL7672 Bruksanvisning

27 Oktober 2024
Manhattan

Manhattan 461504 Bruksanvisning

27 Oktober 2024
Sungrow

Sungrow SG125HV Bruksanvisning

27 Oktober 2024
Schneider

Schneider CCT724319 Bruksanvisning

27 Oktober 2024
Technoline

Technoline WS 250 Bruksanvisning

27 Oktober 2024
Livarno

Livarno IAN 354423 Bruksanvisning

27 Oktober 2024
Kupper

Kupper 12152 Bruksanvisning

27 Oktober 2024
JennAir

JennAir CARBON24L Bruksanvisning

27 Oktober 2024
Medion

Medion Life E74001 (MD 81035) Bruksanvisning

27 Oktober 2024
POLARIS

POLARIS Sportsman Touring 850 SP (2015) Bruksanvisning

27 Oktober 2024