Honeywell COB02 Bruksanvisning

Läs nedan 📖 manual på svenska för Honeywell COB02 (9 sidor) i kategorin Inte kategoriserad. Denna guide var användbar för 13 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Sida 1/9
Charge-Only Base
COB02
Installation Guide
Rev B
9/15
Introduction
Honeywell’s Charge-Only Base can fully charge an industrial
wireless area-imaging scanner in 5 hours, maximizing uptime in any
application.
Note: When a scanner is placed into the Charge-Only Base, the
battery will charge. Please note that the Charge-Only Base
will not facilitate communication with the host system or other
scanners.
Installation
Connect the power adapter to the Charge-Only Base, then plug the
power supply into an AC power outlet. Make sure the AC power
outlet voltage is the same as the power supply.
Use only a Listed Limited Power Source (LPS) or Class 2 type
power supply with output rated 5 to 5.2Vdc, 1A. We recommend
use of Honeywell power adapters. Use of any non-Honeywell
power adapters may cause damage not covered by the
warranty.
Mounting a COB02 Base
The COB02 Base can be mounted on either a horizontal or vertical
surface. The cable can be routed through either the top or the bottom
of the base.
The cable can be routed down through the bottom of the base,
securing the cable in the wireway.
The cable can also be routed up through the top of the base, but must
be crossed over and secured in the wireway.
When routing the cable up through the top of the base, be sure to
cross the cable over before placing in the wireway. If not, too much
strain is placed on the cable connector.

Produktspecifikationer

Varumärke: Honeywell
Kategori: Inte kategoriserad
Modell: COB02

Behöver du hjälp?

Om du behöver hjälp med Honeywell COB02 ställ en fråga nedan och andra användare kommer att svara dig




Inte kategoriserad Honeywell Manualer

Inte kategoriserad Manualer

Nyaste Inte kategoriserad Manualer