Honeywell Easy-To-See T87F Bruksanvisning

Honeywell Termostat Easy-To-See T87F

Läs nedan 📖 manual på svenska för Honeywell Easy-To-See T87F (32 sidor) i kategorin Termostat. Denna guide var användbar för 2 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/32

Owner’s Manual

English: Page 1

Mode d’emploi

Français: Page 6

Manual de Uso

Español: Página 11

T87N Easy-To-SeeTM

The Round®

® U.S. Registered Trademark. Patents pending.

•

69-1840EFS-1

The Round® Easy-To-SeeTM

Check package contents:

• Thermostat

• Wall anchors & screws (2 each)

• Owner's Manual

• Braille Card

• Large Print Subbase Switch Labels

• Coverplate

Before you begin, make sure

you have:

• No. 2 Phillips & small pocket screwdrivers

• Hammer

• Level (optional)

• Pencil

• Drill and bit (3/16” for drywall, 7/32”

for plaster)

MERCURY NOTICE

If this product is replacing a control that contains mercury in a sealed tube, do not

place the old control in the trash. Contact your local waste management authority for

instructions regarding recycling and proper disposal.

CAUTION: ELECTRICAL HAZARD

Can cause electrical shock or equipment damage. Disconnect power before

beginning installation.

Must be installed by a trained, experienced technician

Read these instructions carefully. Failure to follow these instructions

can damage the product or cause a hazardous condition.

Pre-installation checklist

T87N Easy-To-See

• Owner's Manual

System Types

• Gas, oil, or electric heat with air

conditioning

• Warm air, hot water, high-efficiency

furnaces, heat pumps, steam, gravity

• Heat only

• Heat only with fan

• Cool only

System Settings

• Heat, Off, Cool

Fan Settings

• Auto, On

Specifications

Temperature Range

• 40° to 90°F (4.5° to 32°C)

Shipping Temperature

• -20° to 120°F (-28.9° to 48.9°C)

Operating Relative Humidity

• 5% to 90% (non-condensing)

Electrical Ratings

• Voltage: 20–30 VAC

• Running current: 0.02–1.0A

Install the thermostat about 5 feet (1.5 m) above the floor in an area

with good air circulation at average temperature.

Do not install in locations where the thermostat can be affected by:

• Drafts or dead spots behind doors and in corners

• Hot or cold air from ducts

• Sunlight or radiant heat from appliances

• Concealed pipes or chimneys

• Unheated/uncooled areas such as an outside wall behind the thermostat

NO NO

Installation tips

Product application

This thermostat provides electronic control of 24 VAC single-stage heating

and cooling systems.

English: Français: Español: Page 1 • Page 6 • Página 11

1. Pull wires through wire

hole. Position coverplate

on wall, level and mark hole

positions.

2. Drill holes (3/16” for drywall,

7/32” for plaster) and tap in

supplied wall anchors.

3. Pull wire through coverplate

and subbase, position over

anchors, then insert and

tighten mounting screws.

Check level if desired.

4. Apply the large-print labels

to the coverplate, matching

the labels on the subbase.

1. Loosen screw terminals, insert wires

into terminal block, then re-tighten

screws.

2. Push excess wire back into the wall

opening.

3. Plug the wall opening with

nonflammable insulation to prevent

drafts from affecting thermostat

operation.

Terminal Designations

W Heat relay.

Y Compressor contactor.

G Fan relay.

O Heat pump changeover valve

energized in cooling.

Rc Cooling power. Connect to

secondary side of cooling system

transformer.

R Heating power. Connect to

secondary side of heating system

transformer.

B Heat pump changeover valve

energized in heating.

Wiring

NOTES

R & Rc terminals

In single-transformer system, leave metal

jumper in place between & . Remove R Rc

metal jumper if two-transformer system.

Heat pump systems

If wiring to a heat pump, use a small piece

of wire (not supplied) to connect terminals W

and .Y

Wire specifications

Use 18- to 22-gauge thermostat wire.

Shielded cable is not required.

Coverplate

Subbase

Large-print

subbase switch

labels

Subbase and base installation

Produktspecifikationer

Varumärke:	Honeywell
Kategori:	Termostat
Modell:	Easy-To-See T87F
Färg på produkten:	Zwart
Inbyggd display:	Ja
Vikt:	180 g
Bredd:	58 mm
Djup:	21 mm
Höjd:	109 mm
Förpackningens bredd:	100 mm
Djuppackning:	40 mm
Förpackningshöjd:	160 mm
Integrerad klocka:	Ja
Kraftkälla:	Batterij/Accu
Batterikapacitet:	1800 mAh
Typ av förpackning:	Doos
På / Av knapp:	Ja
Skärm diagonal:	1.8 "
USB-kontakttyp:	Micro-USB
Typ av anslutningskontakt:	3,5 mm
Medföljande kablar:	Micro-USB
Varningssignal:	Ja
Batteri/Batterispänning:	3.7 V
Snooze-funktion:	Ja
Klockläge:	12/24 uur
Inbyggda högtalare:	Ja
Genomsnittlig effekt:	10 W
Antal inbyggda högtalare:	1
Antal batterier/batterier som stöds:	1
Hörlursutgångar:	1
Batteritid/batteritid:	8 uur
Ljudlarm:	Ja
Hållbarhetscertifikat:	CE
Indikation på lågt batteri:	Ja
Batteriindikator:	Ja
Typ av tuner:	Analoog & digitaal
Typ av antenn:	Intern
Väckarklocka:	Ja
Bakgrundsbelysning:	Ja
Bakgrundsbelysning-färg:	Wit
USB-laddningsport:	Ja
Överensstämmelse med hållbarhet:	Ja
Frekvensband som stöds:	DAB+, FM
Antal förinställda kanaler:	60
Radio:	Persoonlijk
Utsprång:	Nee
Levensduur batterij:	8 uur
FM-band:	87.5 - 108 MHz
Antal-larm:	2
Typ av ljudlarm:	Radio/Zoemer
Tuner förbättringar:	Auto scan, Auto tuning
AC-ingångsspänning:	5 V
Strömförbrukning (typiskt):	5 W
Type beeldscherm:	LCD
Batterityp:	Ingebouwde accu
Wekmodus radio:	Ja
DAB frekvensområde:	174.9 - 239.2 MHz