Hoover HL V9DG-80 Bruksanvisning

Hoover Torktumlare HL V9DG-80

Läs nedan 📖 manual på svenska för Hoover HL V9DG-80 (6 sidor) i kategorin Torktumlare. Denna guide var användbar för 12 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/6

OPERATION

Do not open the door during the automatic

programs in order to obtain a proper drying.

1. Open the door and load the drum with

laundry. Ensure that garments do not

hinder closure of the door.

2. Gently close the door pushing it slowly

until you hear the door 'click' shut.

3. Turn the Programme Selector dial to

select the required drying programme (see

Programme Guide).

4. Press the button. The dryer will start

automatically and the indicator above the

button will be continuously lit.

5. If the door is opened during the

programme to check the laundry, it is

necessary to press to recommence

drying after the door has been closed.

6. When the cycle is nearing completion

the machine will enter the cool down

phase, the clothes will be tumbled in cool

air allowing the load to cool down.

7. Following the completion of the cycle the

drum will rotate intermittently to minimize

creasing. This will continue until the

machine is switched OFF or the door is

opened.

DOOR and FILTER

Pull on handle to open the door.

To restart the dryer, close the door and press

Start / Pause button.

WARNING! When the tumble dryer is in

use the drum and door may be VERY HOT.

Filter

IMPORTANT: To maintain the efficiency of

the dryer check that the fluff filter is clean

before each drying cycle.

1.P u l l t h e f i l t e r

upwards.

2.Open filter as shown.

3.Gently remove lint

using a soft brush or

your fingertips.

4.S n a p t h e f i lt e r

together and push

back into place.

Filter Care Indicator

Lights when the filter needs cleaning.

If the laundry is not drying check that the filter

is not clogged.

IF YOU CLEAN FILTER UNDER

WATER, REMEMBER TO DRY IT.

CONTROLS AND

INDICATORS

A-Programme Selector - Rotating the knob

in both directions it's possible to select the

desired drying program. To switch or cancel

off the dryer rotate the knob on OFF.

B- Display Digit - The display shows the

remaining time for drying, the postponed

time in case of delayed start selection and

other notifications setting.

C-Buttons -

1.Start/Pause Button

To start the selected program and/or

suspend it.

2.Delay Start Button

It allows to delay the start of the program

from 1 to 24 hours in 1-hour intervals. The

delay selected is shown on the display.

After pressing the START button the time

showed decrease hour after hour.

Opening of the porthole with delayed start

set, after re-closing the porthole, press start

againg to resume the counting.

3.Time cycle selection

It's possible transform a cycle from automatic

to programmed, up to 3 minutes after the

start of the cycle.

The progressive pressure increases the

time in 10-minute intervals.

After this selection to reset the automatic

dying functioning is necessary to switch

off the dryer In case of incompatibility, all

LEDs flash quickly for 3 times.

4.Drying Selection Button

It allows to set the desired dryness level

editable option up to 5 minutes after the

starting of the cycle:

- It leaves the Ready to Iron :

garments slightly wet to facilitate ironing.

- To get garment ready Dry Hanger :

to be hang.

-Dry wardrobe : For laundry that can

be directly stored

- To get completely dry Extra-dry :

garments, ideal for full load.

This appliances is equipped with Drying

Manager Function. On automatic cycles,

each level of intermediate drying, prior to

the reaching the selected one, is

indicated by flashing the light indicator

corresponding to the degree of drying

reached

5.Rapids Button

It's possible switch an automatic

program to RAPID program, up to 3

minutes after the start of the cycle. The

progressive pressure increases the time

(30-45-59 minutes).

After this selection to reset the automatic

dying functioning is necessary to switch

off the dryer In case of incompatibility, all

LEDs flash quickly for 3 times.

6.Anti crease

This option allows to activate an anti-

creases movement of the drum pre cycle

in case of activation of the delay and at

the end of drying cycle. It is activated

every 10 minutes, up to 6 hours after the

end of the drying cycle. To stop the

movements set the knob to OFF.

Useful when it's not possible to remove

immediately.

7. Keylock

This function allows to block unwanted

changes of the set options on the bezel ,

during drying phase.

Activation/ Inactivation: Push 4 and 5

buttons simultaneously for two seconds .

The sign "LOC" appears on the display.

Unlocking the option, on the display

appears the sign "Unl", only once.

123456

Produktspecifikationer

Varumärke:	Hoover
Kategori:	Torktumlare
Modell:	HL V9DG-80
Färg på produkten:	Zilver
Inbyggd display:	Ja
Bredd:	550 mm
Djup:	90 mm
Höjd:	64 mm
Förpackningens vikt:	4150 g
Förpackningens bredd:	735 mm
Djuppackning:	170 mm
Förpackningshöjd:	160 mm
Blåtand:	Ja
Automatisk avstängning:	Ja
Bluetooth-version:	3.0
Anslutningsteknik:	Bedraad en draadloos
Genomsnittlig effekt:	120 W
Inbyggda ljudavkodare:	DTS TruSurround, Dolby Digital
Equalizerinställningar:	Ja
Ljudutgångskanaler:	2.1 kanalen
Upphängningssystem för väggen:	Ja
AUX ingång:	Ja
Basreflex:	Ja
Soundbar högtalare RMS effekt:	- W
Digitalt ljud optiskt in:	1
Soundbar vikt:	3000 g
Antal basförare:	2
Antal mellanklassförare:	4
Diameter förare i mellanregister:	2 "
Fjärrkontroll ingår:	Ja
Digital ljudingång (koaxial):	1
Justering av basnivå:	Ja
AC-ingångsspänning:	100 - 240 V
AC-ingångsfrekvens:	50 - 60 Hz
Batterier-ingår:	Ja
Type beeldscherm:	LED