Jawbone Up2 Bruksanvisning

Jawbone Up2

Läs nedan 📖 manual på svenska för Jawbone Up2 (7 sidor) i kategorin . Denna guide var användbar för 5 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Sida 1/7
6/29/2015 https://help.jawbone.com/articles/en_US/PKB_Article/setupup2
https://help.jawbone.com/articles/en_US/PKB_Article/setupup2 1/7
JAWBONESUPPORT>SETUP UP2
Setup UP2
Step 1: Charge your band*
1. Your band takes approximately one hour to fully
charge. Connect the charging cable to your band by aligning the pins on the
charger with the band. A magnet will hold the charger in place.
2. Insert the charging cable into the USB drive on
your computer or a standard USB wall adapter.
3. Icons on the face of the band will light up and
pulse while the band is charging.
6/29/2015 https://help.jawbone.com/articles/en_US/PKB_Article/setupup2
https://help.jawbone.com/articles/en_US/PKB_Article/setupup2 2/7
4. When the band is fully charged the icons will stop
pulsing and the runner icon will glow solid.
* Band shown is an UP3.
Step 2: Size it for your wrist*
1. The band should be worn on your non-dominant
wrist. Place the band on your wrist and rest your wrist on a flat surface.
2. Thread the strap through the loop and tighten the
strap so that all of the sensors are touching your skin. The band should be snug,
but not tight.
6/29/2015 https://help.jawbone.com/articles/en_US/PKB_Article/setupup2
https://help.jawbone.com/articles/en_US/PKB_Article/setupup2 3/7
3. Use your finger to hold the loop in place and fold
the strap over. Note where the clasp lands.
4. Remove the band and adjust the buckle by sliding
it in place.
5. Put the band back on and insert the clasp into the
buckle.
*Band shown is an UP3.
Step 3: Check your band's mode to get started*

Produktspecifikationer

Varumärke: Jawbone
Kategori:
Modell: Up2

Behöver du hjälp?

Om du behöver hjälp med Jawbone Up2 ställ en fråga nedan och andra användare kommer att svara dig




Jawbone Manualer

Manualer

Nyaste Manualer