JennAir JMW3430HS Bruksanvisning

JennAir Ugn JMW3430HS

Läs nedan 📖 manual på svenska för JennAir JMW3430HS (16 sidor) i kategorin Ugn. Denna guide var användbar för 5 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Sida 1/16
INSTALLATION INSTRUCTIONS
27" (68.6 CM) AND 30" (76.2 CM) ELECTRIC
BUILT-IN MICROWAVE/OVEN COMBINATION
INSTRUCTIONS D’INSTALLATION
ENSEMBLE FOUR À MICRO-ONDES ET FOUR
CONVENTIONNEL ÉLECTRIQUES ET ENCASTRÉS
DE 27" (68,6 CM) ET 30" (76,2 CM)
W10768184C
BUILT-IN MICROWAVE/OVEN COMBINATION SAFETY 2 .......
INSTALLATION REQUIREMENTS 2 ..........................................
Tools and Parts 2 ....................................................................
Built-In Microwave/Oven Combination
Location Requirements 2 .......................................................
Electrical Requirements 3 .......................................................
INSTALLATION INSTRUCTIONS 4 ...........................................
Prepare Built-In Microwave/Oven Combination 4 ..................
Remove Oven Door(s) 4 ..........................................................
Replace Oven Door(s) 5 ..........................................................
Make Electrical Connection ................................................. 6
Install Oven 7 ...........................................................................
Install Warming Drawer Deflector Kit (Only for Ovens
Installed Above Warming Drawers) 8 ......................................
Complete Installation 8 ............................................................
SÉCURITÉ DU FOUR À MICRO-ONDES ET DU FOUR
CONVENTIONNEL COMBINÉS ET ENCASTRÉS 9 .................
EXIGENCES D’INSTALLATION 9 .............................................
Outillage et pièces 9 ...............................................................
Exigences d’emplacement de l’ensemble four
à micro-ondes et four conventionnel encastrés 9 ...................
Spécifications électriques 10 ..................................................
INSTRUCTIONS D’INSTALLATION. 11 ....................................
Préparation de l’ensemble four à micro-ondes
et four conventionnel encastrés 11 ........................................
Dépose de la/des porte(s) du four 11 .....................................
Réinstallation de la/des porte(s) du four............................. 12
Raccordement électrique 13 ...................................................
Installation du four 14 ..............................................................
Installation de l’ensemble de déflecteur pour
tiroir-réchaud (uniquement pour les fours installés
au-dessus d’un tiroir-réchaud) 15 ...........................................
Achever l’installation 16 ..........................................................
Table of Contents/Table des matières
IMPORTANT:
Save for local electrical inspector’s use.
IMPORTANT :
À conserver pour consultation par l’inspecteur local des installations électriques.
2
BUILT-IN MICROWAVE/OVEN COMBINATION SAFETY
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
listed here.
Tools Needed
Phillips screwdriver
Measuring tape
Drill (for wall cabinet installations)
1" (2.5 cm) drill bit (for wall cabinet installations)
Level
Flat-blade screwdriver
Parts Needed
UL listed or CSA approved conduit connector
UL listed wire connectors
Warming Drawer Deflector Kit (for ovens installed above
a warming drawer)
Order Part Number W10489566B for white 27" (68.6 cm) kit
Order Part Number W10489564B for black 27" (68.6 cm) kit
Order Part Number W10489568A for stainless steel
27" (68.6 cm) kit
Order Part Number W10489567B for white 30" (76.2 cm) kit
Order Part Number W10489565B for black 30" (76.2 cm) kit
Order Part Number W10489569A for stainless steel
30" (76.2 cm) kit
Order Part Number W10727416A for stainless steel/black
30" (76.2 cm) kit.
To order, see the “Assistance or Servicesection of the
Use and Care Guide.
Flush Installation Kit (for Combo installed at
flush installation)
Model JMW2427DB:
Order Part Number W10801483 for black
27" (68.6 cm) kit
Model JMW2427DS:
Order Part Number W10801481 for stainless steel
27" (68.6 cm) kit
Model JMW2430DB:
Order Part Number W10801484 for black
30" (76.2 cm) kit
Models JMW2430DS and JMW2430DP:
Order Part Number W10801482 for stainless steel
30" (76.2 cm) kit
Model JMW3430DB:
Order Part Number W10837589 for black
30" (76.2 cm) kit
Models JMW3430DS and JMW3430DP:
Order Part Number W10837591 for stainless steel
30" (76.2 cm) kit
To order, see the “Assistance or Service” section of the
Use and Care Guide:
Parts Supplied
#8-14 x 1" screws (4)
Bottom vent
#8-18 x ³ " screws – bottom vent (2)8
Check local codes. Check existing electrical supply.
See “Electrical Requirements.”
It is recommended that all electrical connections be made
by a licensed, qualified electrical installer.
Built-In Microwave/Oven Combination
Location Requirements
IMPORTANT: Observe all governing codes and ordinances.
Cabinet opening dimensions that are shown must be used.
Given dimensions provide minimum clearance with oven.
3
Recessed installation area must provide complete
enclosure around the recessed portion of the oven.
Grounded electrical supply is required. See “Electrical
Requirements” section.
Electrical supply junction box should be located
3" (7.6 cm) maximum below the support surface
when the oven is installed in a wall cabinet. A 1"
(2.5 cm) minimum diameter hole should have been
drilled in the left rear corner of the support surface to
pass the appliance cable through to the junction box.
Oven support surface must be solid, level and flush with
bottom of cabinet cutout. Floor must be able to support
a total weight (microwave and built-in oven) of 208 lbs
(95 kg) for 27" (68.6 cm) models or 249 lbs (113 kg)
for 30" (76.2 cm) models.
IMPORTANT: To avoid damage to your cabinets, check
with your builder or cabinet supplier to make sure that
the materials used will not discolor, delaminate or sustain
other damage. This oven has been designed in accordance
with the requirements of UL and CSA International and
complies with the maximum allowable wood cabinet
temperatures of 194°F (90°C).
Product Dimensions
27" and 30" (68.6 cm and 76.2 cm) Ovens
27" (68.6 cm) models
A. 433/ " (111 cm) overall height4
B. 257 " (64.6 cm) recessed 16
width
C. 41" (104.1 cm) recessed
height
D. 23¹⁄4" (59.1 cm) max. recessed
depth
E. 27" (68.6 cm) overall width
F. 48" (121.9 cm) flexible conduit
length measured from the
conduit clamp located at
the rear of the oven. Do not
remove the conduit clamp.
30" (76.2 cm) models
A. 433/ " (111 cm) overall height4
B. 287 " (72.2 cm) recessed 16
width
C. 41" (104.1 cm) recessed
height
D. 23¹⁄4" (59.1 cm) max. recessed
depth
E. 30" (76.2 cm) overall width
F. 48" (121.9 cm) flexible conduit
length measured from the
conduit clamp located at
the rear of the oven. Do not
remove the conduit clamp.
B
A
C
D
E
F
Cabinet Dimensions
27" and 30" (68.6 cm and 76.2 cm) Ovens
F
E
A
D
G
B
C
27" (68.6 cm) models
A. 27" (68.6 cm) min. cabinet width
B. 214" (5.7 cm) top of cutout to
bottom of upper cabinet door
C. 19¹4" (48.9 cm) bottom of
cutout to floor is recommended.
4"–19¹⁄ " (10.2–48.9 cm) bottom 4
of cutout to floor is acceptable.
D. 25¹ " (64.8 cm) cutout width2
E. 2" (3.8 cm) min. bottom of
cutout to top of cabinet door
F. 41516" (105 cm)* recommended
cutout height
G. 24" (60.7 cm) cutout depth
30" (76.2 cm) models
A. 30" (76.2 cm) min. cabinet width
B. 2
1
4" (5.7 cm) top of cutout to
bottom of upper cabinet door
C. 19¹⁄4" (48.9 cm) bottom of cutout
to floor is recommended.
4"–19¹⁄ " (10.2–48.9 cm) bottom 4
of cutout to floor is acceptable.
D. 28¹ " (72.4 cm) cutout width2
E. 2" (3.8 cm) min. bottom of
cutout to top of cabinet door
F. 41
5
16" (105 cm)* recommended
cutout height
G. 24" (60.7 cm) cutout depth
* NOTE: The cutout height can be between 41" and 41½"
(104.1 cm and 105.6 cm) for microwave/oven combination.
Electrical Requirements
If codes permit and a separate ground wire is used, it is
recommended that a qualified electrical installer determine
that the ground path and wire gauge are in accordance with
local codes.
Check with a qualified electrical installer if you are not sure
the oven is properly grounded.
This oven must be connected to a grounded metal, permanent
wiring system.
Be sure that the electrical connection and wire size are
adequate and in conformance with the National Electrical
Code, ANSI/NFPA 70 – latest edition or CSA Standards
C22.1-94, Canadian Electrical Code, Part 1 and C22.2 No.
O-M91 – latest edition, and all local codes and ordinances.
A copy of the above code standards can be obtained from:
National Fire Protection Association
1 Batterymarch Park
Quincy, MA 02169-7471
CSA International
8501 East Pleasant Valley Road
Cleveland, OH 44131-5575

Produktspecifikationer

Varumärke: JennAir
Kategori: Ugn
Modell: JMW3430HS

Behöver du hjälp?

Om du behöver hjälp med JennAir JMW3430HS ställ en fråga nedan och andra användare kommer att svara dig




Ugn JennAir Manualer

Ugn Manualer

Nyaste Ugn Manualer