JL Audio Evolution TR350-CXi Bruksanvisning

JL Audio högtalare Evolution TR350-CXi

Läs nedan 📖 manual på svenska för JL Audio Evolution TR350-CXi (2 sidor) i kategorin högtalare. Denna guide var användbar för 19 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/2

Thank you for choosing JL Audio Evolution TR Coaxials for your

automotive sound system. With proper installation, your new

speakers will deliver years of listening pleasure.

We strongly recommend that you have your new Evolution speakers

installed by your authorized JL Audio dealer. The installation

professionals employed by your dealer have the necessary tools and

experience to disassemble your interior panels, install your new

speakers and reassemble your vehicle properly. Also, keep in mind

that your warranty coverage doubles to 2 years if your system is

installed by your authorized JL Audio dealer. If you prefer to perform

your own installation, please read this instruction manual

completely before beginning the process.

TR350-CXi

3.50-inch (90 mm) Coaxial Loudspeakers

o w n e r ’ s m a n u a l

JL AUDIO LIMITED WARRANTY (USA)

Evolution Speaker Systems

JL AUDIO warrants these speakers (and crossover networks, where applicable) to be free of defects in

materials and workmanship for a period of ninety (90) days from the original date of purchase. The warranty

term is extended to one (1) year if installation is performed or approved by an authorized JL AUDIO dealer

(proof of installation or approval required on purchase receipt).

This warranty is not transferrable and applies only to the original purchaser from an authorized JL AUDIO

dealer. Should service be necessary under this warranty for any reason due to manufacturing defect or

malfunction, JL AUDIO will, at its discretion, repair or replace the defective product with new or remanufactured

product at no charge.

Damage caused by the following is not covered under warranty: accident, misuse, abuse, product modification

or neglect, failure to follow installation instructions, unauthorized repair attempts, misrepresentations by the seller.

This warranty does not cover incidental or consequential damages and does not cover the cost of removing or

reinstalling the unit(s). Cosmetic damage due to accident or normal wear and tear is not covered under warranty.

Any applicable implied warranties are limited in duration to the period of the express warranty as provided

herein beginning with the date of the original purchase at retail, and no warranties, whether express or implied,

shall apply to this product thereafter. Some states do not allow limitations on implied warranties, therefore these

exclusions may not apply to you. This warranty gives you specific legal rights, and you may also have other rights

which vary from state to state.

If you need service on your JL AUDIO product:

All warranty returns should be sent to JL AUDIO freight prepaid through an authorized

JL AUDIO dealer and must be accompanied by proof of purchase (a copy of the original sales receipt.) Direct

returns from consumers or non-authorized dealers will be refused unless specifically authorized by JL AUDIO

with a valid return authorization number. Warranty expiration on products returned without proof of purchase

will be determined from the manufacturing date code. Coverage may be invalidated as this date is previous to

purchase date. Return only defective components. If one speaker fails in a system, return only that speaker

component, not the entire system. Non-defective items received will be returned freight-collect. Customer is

responsible for shipping charges and insurance in sending the product to JL AUDIO. Freight damage on returns

is not covered under warranty.

For Service Information in the U.S.A. please call:

JL Audio customer service: (954)443-1100

during normal business hours (Eastern Time)

JL Audio, Inc

10369 North Commerce Pkwy.

Miramar, FL 33025

(do not send product for repair to this address)

International Warranties:

Products purchased outside the United States of America are covered only

by that country’s distributor and not by JL Audio, Inc.

Printed in Taiwan JLTR350CXi-01-2003

INSTALLING YOUR TR350-CXi

COAXIALS IN CUSTOM LOCATIONS:

Run speaker wire to the desired mounting

location. If you are running wires into a door, use

existing factory wiring boots whenever possible. If

you are drilling new holes,file their edges and install

rubber grommets into each hole. Then, cover the

wires with a protective PVC sleeve and run them

through the door jamb. Make sure that the wires

will clear door hinges and other structures in the

door. If you are unsure about any part of this

process, please contact your JL AUDIO dealer for

installation help.

Double check the clearance for both speakers

before proceeding.

Cut a 3 3/16-inch (81mm) diameter hole.

Before drilling or cutting, use a utility knife to cut any

fabric, vinyl or leather from hole locations. These

materials can easily be snagged by a drill or a saw,

causing damage to the panel and possible bodily

injury.Then, using a saber saw, hole saw or nibbler,

make the circular cut out for the speaker. File any

rough edges.

Once the hole is cut, place the speaker into

the hole and mark the screw positions through

the mounting tabs. Drill two 1/8” (3 mm) holes

for the speaker’s mounting screws at the positions

you have marked.

Insert the mounting clips with the flat side

towards the speaker as shown in the diagram.

It is absolutely vital that the speaker frame fits

into the mounting hole cleanly. This must be

checked prior to tightening the screws. Do not

force the frame into a hole that is too small! Do

not tighten the speaker onto an uneven surface! This

will damage your speakers. The speaker should also

fit so that no air leaks around the mounting flange.

Air leaks will cause a severe degradation in sound

quality. Seal any air leaks with silicone, rope caulk or

similar sealant material.

Connect the speaker wires, observing correct

polarity, and install the speaker as shown. Hand-

tighten the screws evenly to avoid bending the

speaker frame!

Because 3.5-inch speakers are rarely used for

custom mounting, grilles are not supplied with the

TR350-CXi speakers. Should you need them, you

will need to purchase aftermarket grilles

separately.

JL AUDIO TR350-CXi 3

TR350-CXi SPECIFICATIONS:

Woofers: Injection-molded, mica-filled, polypropylene

cone body, 0.75-inch (19mm) voice coil, symmetrical-

roll spider, polyether foam surround.

Tweeters: 0.5-inch (12 mm) textile dome tweeter

with integral phase plug, neodymium magnet,

ferrofluid cooled and damped.

Continuous Power Handling:

25 Watts (RMS Method)

Frequency Response: 130 Hz - 22 KHz (± 3 dB)

Efficiency @ 1W/1m: 83.0 dB

Nominal Impedance: 4 ohms

Included Components and Parts:

• Two TR350-CXI 3.5-inch (90mm)

Coaxial loudspeakers

• Four #8 x 1 inch (25mm) sheet metal screws

• Four Mounting Clips

• Two 5.2 mm female crimpable connectors

• Two 2.8 mm female crimpable connectors

GETTING STARTED:

• Turn off the audio system. It is also advisable to

disconnect the negative (-) terminal of your

vehicle’s battery whenever performing

installation work.

• Before cutting, drilling or inserting any screw,

check clearances on both sides of the planned

mounting surface. Also check for any potential

obstacles, such as window tracks and motors,

wiring harnesses, etc. Check both sides of the car,

many cars are not symmetrical!

• Always wear protective eyewear.

INSTALLING YOUR TR350-CXi

COAXIALS IN FACTORY LOCATIONS:

If you will be using the factory speaker wires, it

may be necessary to change the terminations. This

may be accomplished by using an adaptor plug or

simply by cutting the factory connector off and

using the supplied crimp connectors to terminate

the speaker wires.The large connector is for the

positive terminal and the small connector is for the

negative terminal of each TR350-CXi. You may also

choose to run new speaker wires...refer to the

custom installation section for details. Whichever

method you choose, observe correct polarity in

your connections. If you are unsure about any of

these issues, contact your JL AUDIO dealer for

installation assistance.

Your new speakers have been designed to install,

without modifications, into most vehicles that accept

a 3.5-inch speaker. Most factory 3.5-inch speakers

use two mounting screws which will line up with

the mounting holes on your TR350-CXi speakers.

It is absolutely vital that the speaker frame fits

into the mounting hole cleanly. This must be

checked prior to tightening the screws. Do not

force the frame into a hole that is too small! Do

not tighten the speaker onto an uneven surface! This

will damage your speakers. The speaker should also

fit so that no air leaks around the mounting flange.

Air leaks will cause a severe degradation in sound

quality. Seal any air leaks with silicone, rope caulk or

similar sealant material.

Install as shown in the diagram here. Use the

supplied mounting clips unless the factory holes

already feature threaded inserts. Hand-tighten the

screws evenly to avoid bending the speaker frame!

2 JL AUDIO TR350-CXi

Produktspecifikationer

Varumärke:	JL Audio
Kategori:	högtalare
Modell:	Evolution TR350-CXi
Färg på produkten:	Orange, White
Bredd:	168 mm
Djup:	55 mm
Höjd:	241 mm
Snäll:	Draadloze sirene
Kraftkälla:	Batterij/Accu
Internationell säkerhetskod (IP):	IP44
Batteri/Batterispänning:	1.5 V
Antal batterier/batterier som stöds:	4
Frekvens:	868 MHz
Maximalt avstånd:	120 m
Wifi:	Nee
Batterityp:	D
Larm decibel:	100 dB
Placering tillgänglig:	Binnen/buiten
Sabotagekontroll:	Ja