Joovy Peg Perego Car Seat Adapter Bruksanvisning

Joovy Babyprodukter Peg Perego Car Seat Adapter

Läs nedan 📖 manual på svenska för Joovy Peg Perego Car Seat Adapter (2 sidor) i kategorin Babyprodukter. Denna guide var användbar för 5 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/2

!WARNING

This infant car seat adapter is for use ONLY on the Joovy Zoom Joggers. DO NOT use on other stroller models.

This infant car seat adapter is for use ONLY with the Peg Perego® infant car seat models identied below. DO NOT use other infant car seat

models.

ALWAYS install the infant car seat so that the child is facing toward the rear (handlebar) of the stroller.

ALWAYS position the infant car seat so that it securely snaps into place inside the infant car seat adapter frame.

!WARNING

Before each use, check to make sure all four clamps are secure and all Velcro® straps are fully attached.

Installing/Using the Infant Car Seat Adapter

• UnsnapthevesnapslocatedonBOTHsidesoftheseat.See Figure 1.

• Foldthefabricinsideandunderthestrollerframetubessothatthetubesareclearlyexposedonbothsidesofthestroller.See Figure 2.

• Positionthecanopysoitisopenedhalfway.Reclinetheseattoitsmaximumreclineposition.See Figure 3.

• RemovetheVelcro®strapsfromeachclamp,thenopenallfourclampsontheadapter.

• Placethecarseatadapteronthestrollerframetubessothatthecanopyhingebracketsarebetweentheadapterclamps.See Figure 4.

DO NOT allow any of the seat fabric to be captured by the clamp.

• Closeallfourclampsaroundthestrollerframetubes.See Figure 5. Makesurethatallfourclampsarefullyclosedandnoseatfabricis

capturedbytheclamps.

• InserttheloopendofoneVelcro®strapbetweenoneadapterclampandtheseatfabric.Attachthelooparoundthetabontheclamp.

See Figure 6.

• WraptheVelcro®straptightlyaroundtheclamp.See Figure 7.

• EnsurethatthemiddleloopoftheVelcro®straptsovertheclamptab. See Figure 8.

• ContinuewrappingtightlyuntiltheentirelengthoftheVelcro®strapissecuredtogether.MakesuretheedgesoftheVelcro®strapare

alignedformaximumstrength.See Figure 9.

• RepeatfortheotherthreeclampsandVelcro®straps.

• Closethecanopycompletely.

NOTE: Tomaximizespaceforyourbaby,attachthetwosetsofsnapsfoundontheundersideofthecanopy.See Figure 10.

• PlacethePegPerego®infantcarseat(sothecarseatfacesthehandlebar)intotheadapteruntilthecarseatsnapsintoplace.Pullupon

thecarseattoensureitissecure.See Figure 11.

• Toremovetheinfantcarseat,pullthereleaselever(sameleverusedtoreleasethecarseatfromitsbase)andliftup.

NOTE: strollerfoldswithcarseatadapterinstalled.

Removing the Infant Car Seat Adapter

• Toremovethecarseatadapter,rstpositionthecanopysothatitisopenedhalfway.

• RemoveallfourVelcro®strapsfromtheclamps.

• Openallfourclampsandremovetheadapterfromthestroller.

• ReattachthefourVelcro®strapstotheclampsontheadapterandstoretheadapterforfutureuse.

• WraptheseatfabricoverthestrollerframetubesandreattachthevesnapslocatedonBOTHsidesofthestroller.

Zoom

Peg Perego® Car Seat Adapter

00951

PEG PEREGO® CAR SEAT ADAPTER COMPATABILITY

Peg Perego® Primo Viaggio

Figure 1

Figure 7

Figure 2

Figure 8

Figure 5Figure 4

Figure 11Figure 10

Figure 6

Figure 3

Figure 9

©joovy 2013 • Document Version 091313

Joovy•2919CantonStreet•Dallas,TX75226•(877)456-5049•Fax:(214)761-1774Email:customerservice@joovy.com•Website:www.joovy.com

Produktspecifikationer

Varumärke:	Joovy
Kategori:	Babyprodukter
Modell:	Peg Perego Car Seat Adapter
Färg på produkten:	Zwart
Vikt:	1180 g
Bredd:	142.9 mm
Djup:	220.1 mm
Höjd:	88.5 mm
Instruktioner:	Ja
Medföljande kablar:	AC, Thunderbolt
Hållbarhetscertifikat:	RoHS
Stöder Windows:	Windows 10, Windows 10 Education, Windows 10 Education x64, Windows 10 Enterprise, Windows 10 Enterprise x64, Windows 10 Home, Windows 10 Home x64, Windows 10 IOT Core, Windows 10 Pro, Windows 10 Pro x64, Windows 10 x64
Internera:	Nee
Stöder Mac-operativsystem:	Mac OS X 10.12 Sierra, Mac OS X 10.13 High Sierra, Mac OS X 10.14 Mojave
Värdgränssnitt:	Thunderbolt 3
Drifttemperatur (TT):	0 - 35 °C
Utgångsgränssnitt:	PCIe