Kicker SF150SC15 Bruksanvisning

Läs nedan 📖 manual på svenska för Kicker SF150SC15 (11 sidor) i kategorin Inte kategoriserad. Denna guide var användbar för 2 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Sida 1/11
1
S 150SC15 F
Designed for 2015 Ford F150 Super-Cab and Super-Crew vehicles
(Compatible in vehicles with or without Sony® System
©2015 Stillwater Designs
S 150SC15-A2-201F 60502
SubwooferHarness
SubwooferPower Harness
M8Bolt  X 2
M6Bolt  X 2
M6Nut  X 2
Fuse
WireTie  X 6
AdapterHarness
WireTaps
SubwooferAssembly
AmplifierRelocationBracket
(notusedonnonSony®trucks)
2
Fig. 4
Power Harness Routing
1. Disconnect negative battery cable.
2. Make sure supplied fuse is not installed in fuse holder and connect the subwoofer power wire to
the stud pictured in figure 1.
3. Route the power harness toward and along the firewall and secure with supplied wire ties.
4. Make a small incision in the grommet on the driver side of the firewall and pass the power
harness into the cabin. Fig. 2
5. Install the black two pin power connector on the subwoofer power harness. Note: Make sure
the blue retainer in the center of the connector body is not depressed. If the retainer is
depressed, the terminal will not fully seat in the connector body. Make sure the terminal
is installed into position 1 on the connector body. There should be a block-out plug
installed to prevent the terminal from being installed into the wrong position on the
connector body.
Subwoofer Harness Routing
6. Pull loose the dash end trim panel on the drivers side of dash. Fig. 3
7. Connect the black ground wire of the subwoofer harness to the bolt above the drivers kick
panel. Fig. 4
Fig. 1 Fig. 2
Fig. 3
3
8. Remove the driver side front and rear threshold panel along the bottom of the door opening by
prying up.
9. Snap loose the drivers side kick panel.
10. Connect the subwoofer harness black two-pin power connector to the power harness black two-
pin connector.
11. Connect the subwoofer harness white two pin signal input connector to the corresponding white
connector of the adaptor harness.
Input Connection Non Sony® Equipped Truck
(For trucks equipped with Sony, skip to step 25)
12. Locate the black connector and find the twisted pair of wires that are white and white/brown
stripe.
13. Install one of the supplied wire taps on each of the two wires using a pair of pliers.
14. Connect the green wire of the adaptor harness to the white wire. Connect the brown wire
of the adaptor harness to the white/brown stripe wire. Fig. 5
Fig. 5

Produktspecifikationer

Varumärke: Kicker
Kategori: Inte kategoriserad
Modell: SF150SC15

Behöver du hjälp?

Om du behöver hjälp med Kicker SF150SC15 ställ en fråga nedan och andra användare kommer att svara dig




Inte kategoriserad Kicker Manualer

Inte kategoriserad Manualer

Nyaste Inte kategoriserad Manualer