La Crosse Technology WS-9006U Bruksanvisning
La Crosse Technology
Termometer
WS-9006U
Läs nedan 📖 manual på svenska för La Crosse Technology WS-9006U (6 sidor) i kategorin Termometer. Denna guide var användbar för 10 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare
Sida 1/6
WS- 9006U
Wireless Temperature Station
Instruction Manual
FEATURES:
Four digit time display
12-hour or 24-hour selectable time
Indoor temperature (°F or °C)
Outdoor temperature (°F or °C)
Minimum and Maximum temperature
Four level RF strength indicator
Wall hanging or free standing
Low battery indicator for receiver and transmitter
100 foot wireless transmission range (open air)
RF reception
indicator
Indoor
Temperature
Outdoor
Temperature
Time
MIN/MAX/+ Button
CF / SET Button
Outdoor
Temperature
Sensor TX43U
INITIAL SET UP:
IMPORTANT Do Not Mix Old and New Batteries : -
- Do Not Mix Alkaline, Standard, or Rechargeable Batteries
NOTE: This temperature station can receive one transmitter only.
First, insert fresh 2 AA, IEC LR6, 1.5 alkaline batteries into the TX43U transmitter, observing the x V
correct polarity (see marking inside battery compartment). Keep transmitter 5-10 feet from the
temperature station.
Within 30 seconds of powering up the transmitter, insert 2 A, IEC LR3, 1.5V batteries into the x AA
Temperature Station, observing the correct polarity (see marking inside battery compartment Once ).
the batteries are in place, all segments of the LCD will light up briey. Following, the indoor
temperature will display. If the indoor temperature does not show in the LCD after 60 seconds,
remove the batteries and wait for at least 60 seconds before reinserting them. Once the indoor data is
displayed, proceed to the next step.
After the batteries are inserted, the Temperature Station will start receiving outdoor temp data from
the transmitter. The outdoor temperature should be displayed on the Temperature station. If this does
not happen after 2 minutes, remove the batteries from both units and start again from the beginning.
In order to ensure sufcient 433 MHz transmission, place the outdoor transmitter a distance of no
more than 100 feet (30 meters) from the Temperature Station and the transmitter.
INSTALL AND REPLACE BATTERIES IN THE TEMPERATURE TRANSMITTER
The Temperature transmitter uses AA, IEC LR6, 1.5V batteries. When batteries will 2 x
need to be replaced, the low battery icon will appear on the LCD in front of the outdoor
temperature. To install and replace the batteries, please follow the steps below:
1. Remove the battery compartment cover. (Slide to the bottom and then lift straight o).
2. Insert the batteries, observing the correct polarity (see marking).
3. Replace the battery cover the unit. to
NOTE: When changing batteries in any of the units, all units need to be reset by
following the set up procedures. The transmitter at start- , assigns a random security up
code and this code must be received and stored by the Temperature Station in the rst
few minutes of power supplied.
INSTALL AND REPLACE BATTERIES IN THE TEMPERATURE STATION
The Temperature Station uses 2 x AAA, IEC LR3 1.5V batteries. When batteries
need to be replaced, the low battery icon will appear in front of the indoor
temperature.
To install and replace the batteries, please follow the steps below:
1. Remove the battery compartment cover.
2. Insert batteries observing the correct polarity (see marking).
3. Replace battery compartment cover.
LOW BATTERY:
Replace the batteries in all units every 12 months to ensure optimum accuracy of these units. A low
battery icon will display next to the outdoor temperature when the transmitter batteries are low and next to
the indoor temperature then the batteries in the temperature station are low.
SET TIME:
12/24-HOUR TIME: Hold the CF/SET button until 12hr or 24hr ashes in the lower
right hand corner. Press and release the MIX/MAX/+ button to switch between -hour 12
and 24-hour time. Press the CF/SET button once to continue.
HOUR: The Hour will ash. Press and release the MIX/MAX/+ button to change the
hour. Press the CF/SET button once to continue.
MINUTES: The minutes will flash. Press and release the MIX/MAX/+ button to change
the minutes.
NOTE: Hold the MIX/MAX/+ button to move quickly through the numbers. Press
CF/SET once to confirm and exit.
TEMPERATURE SELECTION:
FAHRENHEIT/CELSIUS: Press and release the CF/SET button once to switch from Fahrenheit to
Celsius.
FOUR LEVEL RF INDICATORS: The temperature station will indicate strength of signal
reception from the outdoor transmitter by the number of bars on the RF indicator icon.
: Shows after initial set up and stays when reception is at full strength. 4-bars
: Indicates one reception failure from the outdoor transmitter. 3-bars
: Indicates two reception failures from the outdoor transmitter. 2-bars
: Indicates three reception failures from the outdoor transmitter.1-bar
: Indicates four reception failures from the outdoor transmitter. 0-bars
The antenna symbol will ash on initial set while searching for the signal. If it fails to receive a signal after
63 minutes the temperature station will display dashes (“ “). The temperature stati--.- on will search again
for a signal for 3 minutes every next hour.
MIN/MAX RECORDING:
VIEW MIN/MAX: Press the MIN/MAX/+ button view indoor and outdoor MAX, MIN and Current
temperature.
RESET MIN/MAX: Hold the MIN/MAX/+ button for 3 seconds to reset all MIN/MAX readings to current
temperatures.
OUTDOOR TRANSMITTER RESET BUTTON:
The Temperature Transmitter has a RESET button. Use a small pointed object to gently press and
release to send a signal. Follow the instructions for in SET UP regarding the display.
NOTE: Removing power from the transmitter and display negates the need for the RESET button.
POSITIONING THE TEMPERATURE STATION:
Stand the Temperature Station on a tabletop, counter or desk, or mount on a wall. Ensure that the
Temperature Station continuously receives the 433MHz signal from the Sensor before mounting it in the
desired location.
WALL MOUNT
Install a mounting screw (not included) into a wall leaving approximately 3/16 of an —
inch (5mm) extended from the wall.
Place the Temperature Station onto the screw, using the hanging hole on the
backside. Gently pull the Temperature Station down to lock into place.
NOTE: Always ensure that the Temperature Station locks onto the screw before
releasing the station.
TABLE STAND: The Temperature Station has a wide base to stand on a desk or table.
Produktspecifikationer
| Varumärke: | La Crosse Technology |
| Kategori: | Termometer |
| Modell: | WS-9006U |
Behöver du hjälp?
Om du behöver hjälp med La Crosse Technology WS-9006U ställ en fråga nedan och andra användare kommer att svara dig
Termometer La Crosse Technology Manualer
4 Oktober 2024
27 September 2024
26 September 2024
26 September 2024
26 September 2024
24 September 2024
24 September 2024
17 September 2024
17 September 2024
17 September 2024
Termometer Manualer
- Termometer Braun
- Termometer Philips
- Termometer Inventum
- Termometer Motorola
- Termometer Quigg
- Termometer Topcom
- Termometer Ade
- Termometer AnD
- Termometer Amprobe
- Termometer Arendo
- Termometer ATN
- Termometer Aponorm
- Termometer Bartscher
- Termometer Kruidvat
- Termometer Telefunken
- Termometer Silvercrest
- Termometer Nedis
- Termometer Innoliving
- Termometer Pyle
- Termometer Taylor
- Termometer Beurer
- Termometer Melissa
- Termometer Emerio
- Termometer Clatronic
- Termometer Sencor
- Termometer Medisana
- Termometer Milwaukee
- Termometer Elro
- Termometer EMOS
- Termometer Extech
- Termometer Omron
- Termometer Citizen
- Termometer Hama
- Termometer Cresta
- Termometer Voltcraft
- Termometer Terraillon
- Termometer Velleman
- Termometer GlobalTronics
- Termometer Weber
- Termometer Kyoritsu
- Termometer Flir
- Termometer Homedics
- Termometer Sanitas
- Termometer AcuRite
- Termometer Auriol
- Termometer Technoline
- Termometer Olympia
- Termometer Cotech
- Termometer Rossmax
- Termometer Vicks
- Termometer Microlife
- Termometer Welch Allyn
- Termometer Testboy
- Termometer Salter
- Termometer Trotec
- Termometer BabyOno
- Termometer Laica
- Termometer TFA
- Termometer Boso
- Termometer Clas Ohlson
- Termometer Powerfix
- Termometer Owon
- Termometer Irox
- Termometer Reer
- Termometer Miniland
- Termometer Fluke
- Termometer Leifheit
- Termometer Etekcity
- Termometer Ecomed
- Termometer Comark
- Termometer Fora
- Termometer Testo
- Termometer Elta
- Termometer Beaba
- Termometer Eurochron
- Termometer Medel
- Termometer Geratherm
- Termometer Truelife
- Termometer Bioland
- Termometer Global Tronics
- Termometer Oregon Scientific
- Termometer Levita
- Termometer Kerbl
- Termometer Scala
- Termometer Duronic
- Termometer Dittmann
- Termometer TFA Dostmann
- Termometer Greisinger
- Termometer CDN
- Termometer Emga
- Termometer Hartmann
- Termometer VDH
- Termometer Uni-T
- Termometer Ebro
- Termometer Arya
- Termometer PeakTech
- Termometer Thermoval
- Termometer Pasha
- Termometer Innovo
- Termometer Delta Ohm
- Termometer InfiRay
- Termometer Chauvin Arnoux
- Termometer PCE Instruments
- Termometer Joy-it
- Termometer Techno Line
- Termometer Klein Tools
- Termometer TensCare
- Termometer Yummly
- Termometer Eks
- Termometer Gima
- Termometer Aspen
- Termometer Salva Tec
- Termometer Radiant
- Termometer Kuchenprofi
- Termometer WBTT
- Termometer Welby
- Termometer Prologue
- Termometer A&D
- Termometer ClimeMET
- Termometer Bearware
Nyaste Termometer Manualer
27 Oktober 2024
23 Oktober 2024
23 Oktober 2024
22 Oktober 2024
22 Oktober 2024
22 Oktober 2024
20 Oktober 2024
17 Oktober 2024
16 Oktober 2024
16 Oktober 2024