La Crosse Technology WS6812 Bruksanvisning

La Crosse Technology Väderstation WS6812

Läs nedan 📖 manual på svenska för La Crosse Technology WS6812 (2 sidor) i kategorin Väderstation. Denna guide var användbar för 3 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/2

Wireless Weather Station

WS6812 | Quick Setup Guide

The Wireless Weather Station features manual set time, date, time alarm,

Outdoor/Indoor temperature alerts, and moon phase. Monitor temperature

and humidity, track temperature trends and set customizable temperature

alerts all in one convenient device. Wireless transmission range of over --

300 feet (90 meters) in open air, from transmitter to weather station.

SETUP INSTRUCTIONS STEP BY STEP

STEP 1:

 Remove battery cover from the weather station. Slide tab down and pull

out to remove the battery cover.

 Insert 2 NEW AA batteries (not included) into the back

of the weather station. Observe the correct polarity

(see marking inside the battery compartment).

The weather station will light up and show,

indoor temperature, humidity and time.

 Do Not Mix Old and New Batteries

 Do Not Mix Alkaline, Standard, Lithium or Rechargeable Batteries

STEP 2:

 Ensure that the transmitter is within 10 feet of the Weather Station.

 To remove battery cover from transmitter, slide the battery

cover down and lift off the front of the transmitter.

 Insert 2 NEW AA batteries (not included) into the transmitter.

 Observe the correct polarity.

 Within 3 minutes the weather station will show readings in the

outdoor temperature area on the LCD.

 Allow the weather station and the transmitter to stay Note:

within 10 feet of each other for the first 15 minutes of set up.

TRANSMITTER SIGNAL STRENGTH

 After the batteries are inserted, the weather station will search for the

outdoor temperature/humidity transmitter for 3 minutes.

 The antenna symbol will flash during reception, and temperature

display will be dashes “---“.

 The antenna symbol will roll during signal synchronization. sc

 If synchronization fails once, the antenna will lose one bar.

 If synchronization fails twice, the antenna will lose two bars.

 If reception continuously fails to receive 5 times, the antenna symbol will

be shown as .

 The antenna will show full display with successful RF (radio

frequency) reception.

TROUBLESHOOTING

 If the outdoor data are not displayed after three minutes,

hold the SENSOR button on the weather station for three

seconds to search for outdoor transmitter .

 Next, press the TX button on the outdoor transmitter to send signal.

 If it still does not receive the outdoor data, remove batteries from both

the weather station and the transmitter for 15 minutes then repeat the

setup instructions from step 1.

 The maximum transmitting range in open air is over 300-feet (90

meters). Obstacles such as walls, windows, stucco, concrete, and large

metal objects can reduce the range.

TIME/DATE

The TIME/DATE button will move through the program

menu and confirm settings.

Use the UP ARROW button to increase a value.

Use the DOWN ARROW button to decrease a value.

SET TIME AND DATE

Hold the TIME/DATE button for three seconds to enter time set mode.

 YEAR: The will flash. Use the ARROW buttons to choose the year, Year

and press the TIME/DATE button to confirm and move to the month.

 MONTH: The will flash, use the ARROW buttons to choose the Month

month, and press the TIME/DATE button to confirm and move to the

date.

 DATE: The Date will flash. U the ARROW buttons to choose the date, se

and press the TIME/DATE button to confirm and move to 12/24 hour

time format.

 12/24-HOUR: The time format will flash. Use the ARROW buttons to

choose 12-hour or 24-hour time format and press the TIME/DATE button

to confirm and move to language.

 LANGUAGE : The language will flash. Use the ARROW buttons to select

the language for weekday display (French, Italian, Dutch, Spanish,

Danish, English or German - refer to the table hereunder) and press the

TIME/DATE button to confirm and move to hour.

 HOUR: The will flash. Use the ARROW buttons to choose the Hour

hour, and press the TIME/DATE button to confirm and move to minutes.

 MINUTES: The will flash. Use the ARROW buttons to choose Minutes

the minutes, and press the TIME/DATE button to confirm and move to

Fahrenheit/Celsius.

 FAHRENHEIT/CELSIUS: will flash. Use the ARROW buttons °F or °C

button to select Fahrenheit or Celsius. Press and release the

TIME/DATE button to confirm and exit the program menu.

Note: When no buttons are pressed for ten seconds, the weather station

will save the last change and default back to normal time and

temperature display mode.

TIME ALARM

The TIME ALARM button moves through the alarm setting

mode and confirms the final setting.

Use the UP ARROW button to increase a value.

Use the DOWN ARROW button to decrease a value.

SET TIME ALARM

From normal time and temperature display mode, press and release the

TIME ALARM button once to show alarm time. Hold the TIME ALARM

button for three seconds to enter alarm set mode.

 HOUR: The will flash. Use the ARROW buttons to set the hour, Hour

and press TIME ALARM button to confirm and switch to minutes .

 MINUTES: The will flash. U the ARROW buttons to set the Minutes se

minutes, and press TIME ALARM button to confirm.

 Press the TIME/DATE button to return to normal mode

LOW BATTERY

 When this low battery icon appears in the indoor reading section,

replace the batteries in the weather station.

 When this low battery icon appears in the outdoor readings section,

replace the batteries in the outdoor transmitter.

POSITION THE WEATHER STATION

Choose a location for the weather station that is within range 00 feet,9(3 0

meters) of the outdoor transmitter. The weather station has a build in base

stand to sit on a table or desk.

 Choose a location 6 feet or more from electronics such as

cordless phones, gaming systems, televisions, microwaves,

routers, baby monitors, etc., which can prevent signal

reception.

 Be aware of electrical wires and plumbing within a wall.

 Best reception is achieved when the front or the back of the

weather station is facing the outdoor transmitter. This allows

a larger portion of the antenna to receive a signal.

POSITION THE WIRELESS OUTDOOR TRANSMITTER

Once the weather station shows the outdoor temperature/humidity, place it

and the transmitter in the desired locations and wait approximately one hour

before permanently mounting the transmitter to ensure that there is proper

reception. The transmitter should be mounted vertically, in a shaded,

protected area, at least 6 feet from the ground to avoid damage and ensure

accurate readings. The transmitter is water resistant, not waterproof and

should not be placed anywhere it will become submerged in water or

subject to standing water or snow.

Choose a location for the transmitter that is within range of

the Weather station and under an overhang for accuracy.

The maximum transmitting range in open air is over 3 -feet 00

(90 meters).

Option 1:

 Install one mounting screw (not included) into a wall

leaving approximately ½ of an inch (12.7mm) extended.

 Place the transmitter onto the screw, using the hanging

hole on the backside.

 Gently pull the transmitter down to lock the screw into

place .

Option 2:

 Insert the mounting screw (not included) through the front of the

transmitter and into the wall.

 Tighten the screw to snug (do not over tighten).

To achieve a true temperature/humidity reading, mount where direct

sunlight cannot reach the outdoor transmitter. Mount the outdoor

transmitter on a North-facing wall or in any well shaded area. Under an

eave or deck rail work well. The maximum transmitting range in open air is

over 3 -feet (90 meters). Obstacles such as walls, windows, stucco, 00

concrete, and large metal objects can reduce the range. Place the

transmitter at least 6 feet in the air to improve signal transmission.

CARE AND MAINTENANCE

 Do Not Mix Old and New Batteries

 Do Not Mix Alkaline, Standard, Lithium or Rechargeable Batteries

 Do not expose the weather station to extreme temperatures, vibration or

shock.

 Keep weather station dry.

 Clean weather station with a soft damp cloth. Do not use solvents or

scouring agents.

 The weather station is not a toy. Keep it out of reach of children.

 The weather station is not to be used for medical purpose or for public

information; it is for home use only.

 The specifications of this weather station may change without prior notice.

 Improper use or unauthorized opening of housing will void the warranty.

 If the weather station does not work properly, change the batteries.

SPECIFICATION

Indoor:

Temperature Range: +32°F to +122°F (0°C to 50°C)

Interval: About every 30 seconds

Outdoor:

Temperature Range: -40°F to 140°F (-40°C to 60°C)

Distance: Over 300 ft. (90 meters)

RF 433MHz (open air)

Interval: About every 50 seconds

Power:

Weather Station 2-AA, IEC, LR6 batteries (not included) :

Transmitter: 2-AA, IEC, LR6 batteries (not included)

Battery Life:

Transmitter

Battery Life: Battery life is over 12 months when

using reputable Alkaline battery brands.

Weather Station

Battery Life: Battery life is over months when 12

using reputable Alkaline battery brands.

Dimensions:

Weather Station: 5.40” L x 1.68” W x 4.40” H

(137.2 mm L x 42.8 mm W x 111.8 mm H)

Transmitter 1.57" L x 0.79" W x 5.12" H :

(40 x 20 x 130 mm)

LIABILITY DISCLAIMER

 The electrical and electronic wastes contain hazardous substances.

Disposal of electronic waste in wild country and/or in unauthorized

grounds strongly damages the environment.

 Please contact your local or/and regional authorities to retrieve the

addresses of legal dumping grounds with selective collection.

 All electronic instruments must from now on be recycled. User shall take

an active part in the reuse, recycling and recovery of the electrical and

electronic waste.

 The unrestricted disposal of electronic waste may do harm on public

health and the quality of environment.

 As stated on the gift box and labeled on the product, reading the “User

manual” is highly recommended for the benefit of the user. This product

must however not be thrown in general rubbish collection points.

 The manufacturer and supplier cannot accept any responsibility for any

incorrect readings and any consequences that occur should an inaccurate

reading take place.

 This product is designed for use in the home only as indication of the

temperature.

 This product is not to be used for medical purposes or for public

information.

 The specifications of this product may change without prior notice.

 This product is not a toy. Keep out of the reach of children.

 No part of this manual may be reproduced without written authorization of

the manufacture r.

R&TTE Directive 1999/5/EC

Summary of the Declaration of Conformity : We hereby declare that this

wireless transmission device does comply with the essential

requirements of R&TTE Directive 1999/5/EC.

Produktspecifikationer

Varumärke:	La Crosse Technology
Kategori:	Väderstation
Modell:	WS6812
Färg på produkten:	Black, Grey
Inbyggd display:	Nee
Vikt:	450 g
Bredd:	79.3 mm
Djup:	25.4 mm
Höjd:	63.5 mm
Förpackningens vikt:	620 g
Förpackningens bredd:	165.1 mm
Djuppackning:	69.9 mm
Förpackningshöjd:	190.5 mm
Användarmanual:	Ja
Husmaterial:	Kunststof
LED-indikatorer:	Ja
Typ av förpackning:	Doos
USB-kontakttyp:	USB Type-A
Maximal upplösning:	1920 x 1200 Pixels
Antal USB 2.0-portar:	2
Antal HDMI-portar:	2
Hörlursutgångar:	2
HDCP:	Ja
Upplösning (maximal digital):	1920 x 1200 Pixels
Plug and play:	Ja
Förvaringstemperatur:	-20 - 60 °C
Rackmontering:	Nee
Stöder Linux:	Ja
Andra stödsystem:	Ja
Videoanslutning:	HDMI
Drifttemperatur (TT):	0 - 50 °C
Relativ luftfuktighet i drift (VV):	0 - 80 procent
Tangentbordsanslutning:	USB
Musanslutning:	USB
Antal datorer:	2
Konsolportar:	3.5mm headphone, 3.5mm mic, HDMI, USB A
Ljudanslutningar:	Ja
Skanningsintervall:	3, 5,10, 20 s
Displayanslutning:	Ja