Metz 45 ct-1 Bruksanvisning

Metz Flash 45 ct-1

Läs nedan 📖 manual på svenska för Metz 45 ct-1 (7 sidor) i kategorin Flash. Denna guide var användbar för 8 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Sida 1/7
Modify a Metz 45ct1 flash to make it full manual.
Whe need:
a Stepped switch 12 positions (stappenschakelaar)
Black knob with a marking (knop met markering)
plastic box
Some diodecable and some wire ( diodekabel en montagedraad)
Resistors:
2,2M ohm
56K ohm
22K ohm
15K ohm
10K ohm
5K6 ohm (5,6K ohm)
3K9 ohm (3,9K ohm)
tulip connectors 1 male and 1 female
some pieces of shrinktube (krimpkous)
First remove the battery's.
If the flash was charged, discharge it by pressing the testbutton several times.
Remove the cover
Detach the small printboard.
Cut a piece of diode cable approx 5 inches and connect a female connector at one end.
Put the other end trough the hole (remove the small piece of transparent plastic).
Connect the two wires of the diodecable with the green and yellow wire.
eg. the center wire with the yellow wire and the outer wire with the green one or vice versa.
Make sure you shield the wires to avoid shortcuts. First i used thin shrinktubes to put over the
connected wires and a wider (red) piece of shrinktube to protect it all. This gives me a double
protection.

Produktspecifikationer

Varumärke: Metz
Kategori: Flash
Modell: 45 ct-1

Behöver du hjälp?

Om du behöver hjälp med Metz 45 ct-1 ställ en fråga nedan och andra användare kommer att svara dig




Flash Metz Manualer

Flash Manualer

Nyaste Flash Manualer