Microchip HV9861ADB1 Bruksanvisning

Microchip Inte kategoriserad HV9861ADB1

Läs nedan 📖 manual på svenska för Microchip HV9861ADB1 (6 sidor) i kategorin Inte kategoriserad. Denna guide var användbar för 5 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/6

Supertex inc.

www.supertex.com

HV9861ADB2

Doc.# DSDB-HV9861ADB2

A032713

General Description

Certain target markets for LED lighting require a power factor

of at least 90%. A power factor over 90% can be attained

using valley ll power factor correction with the addition of a

small boost converter.

The boost converter lowers line current distortion by adding

line current draw in the valley and lowering the peak

amplitude of the valley ll capacitor recharging current.

HV9861A LED Driver Demoboard

Boost Assisted, Valley Fill,

120VAC Input, 7W Output, 350mA, 20V, Power Factor ~ 93%

Basic valley ll circuit operation

A valley ll power factor correction circuit operates in two

distinctly different modes.

During a rst period, here referred to as the valley and

coinciding with line voltage being lower than half the peak

line voltage, the load is exclusively powered from two energy

storage capacitors. Consequently, in the valley the line

current is equal to zero. The valley, being characterized by a

line voltage less than half the peak line voltage, extends 30°

on either side of the line voltage zero crossing.

During a second period, coinciding with the line voltage being

higher than half the peak voltage, the load is exclusively

powered from the line and not from the valley ll capacitors.

Consequently, the line current is not zero. Furthermore, an

additional line current is drawn near the peak of the line

voltage for recharge of the valley ll capacitors. The two

line current components can clearly be identied in the

oscillogram of the line current.

Boost converter operation

The boost converter adds current draw in the valley, thereby

lowering distortion and raising power factor.

The boost converter switch, a bipolar transistor in common

base conguration, is driven indirectly by the current ow in

the valley capacitors. In the valley, current is extracted from

the valley capacitors during ON time of the main switch, each

capacitor contributing half of the load current. The capacitor

current in one of the capacitors develops a voltage of about

1.2V across two diodes in series. This voltage provides a

forward bias for the base emitter circuit of the boost transistor.

Current develops in the boost inductor, which subsequently

ows in to the valley capacitors during OFF time.

The boost converter develops a line current with an

amplitude which is line voltage dependent. When line

voltage is particularly small the boost converter operates

in discontinuous mode (DCM) and when the line voltage

approaches half the peak voltage the converter operates

in continuous conduction mode (CCM). The line current

amplitude increases nonlinearly with line voltage in either

conduction mode. The boost converter action results in

delivery of power to the valley capacitors thereby lowering

the amplitude of the capacitor recharging current during the

second period.

Circuit add-ons

PF 93. PF 90.6 % 8 %

without boost seconwith boost secon

Supertex inc.

www.supertex.com

HV9861ADB2

Doc.# DSDB-HV9861ADB2

A032713

Specications

Parameter Value

Input voltage 100 … 135VAC

Output voltage 20VDC, ±10%

Output current 350 mADC, ±5%

Output power 7W

Power factor ~93.6%

Total harmonic distortion ~35%

EMI limits CISPR 15

Parameter Value

Efciency ~80%

Output current ripple (at FSW) 80%PP (See note)

Output open circuit protection Yes

Output short circuit protection Yes

Switching frequency 50kHz … 60kHz

Dimensions 54mm x 24mm x 20mm

Connection Diagram

Note:

Output current ripple can be reduced in straightforward manner by increasing inductor L3. Alternatively, capacitor

C4 can be increased.

Connections

Connect the mains voltage at the input terminals and connect the LED load at the output terminals as shown.

Warning: The mains voltage circuit does not contain galvanic isolation. Do not ground any part of the circuit

directly to protective ground by means of test equipment connections.

120VAC

20VDC

Circuit Schematic

VIN

VDD RT GND

GATE

PWMD

100

1.3

332k

100n

10µ

220n

100n

10µ

33n

FMT108

RM4007

FMT108

DN1

BAV99

D914

RM4007

FMT108

AN0 RED TP31

CAT BLU TP32

BR1

MS380

1.5m

1ATP11 AC11 AC1

TP22 AC22 AC2

MOV1

S07K140

33n

6 8 3

HV9861A

STX616

1.5m

M1N60

Supertex inc.

www.supertex.com

HV9861ADB2

Doc.# DSDB-HV9861ADB2

A032713

THD vs. Line Voltage

80 100 120 140 160

100

PF vs. Line Voltage

80 100 120 140 160

100

Efficiency vs. Line Voltage

80 100 120 140 160

100

Output Current vs. Line Voltage

80 10 12 14 160 0 0 0

100

200

300

400

500

EMI Signature

100

10k 100k 1M 10M

dBμV

If BW 9.0kHz

Notes:

PCB suspended approximately 3 inches above reference plane.

Peak detector in peak hold mode for 10 min.

Produktspecifikationer

Varumärke:	Microchip
Kategori:	Inte kategoriserad
Modell:	HV9861ADB1
Inbyggd display:	Nee
Vikt:	1800 g
LED-indikatorer:	Ja
På / Av knapp:	Ja
Processorfrekvens:	800 MHz
Antal processorkärnor:	2
Anslutningsteknik:	Bedraad
Antal USB 2.0-portar:	1
Strömförbrukning (max):	14 W
Certifiering:	EN55022 class A, FCC class A, VCCI class A
Internminne:	512 MB
Typ processor:	Ja
Ethernet LAN, dataöverföringshastigheter:	10,100,1000 Mbit/s
Säkerhetsalgoritmer som stöds:	3DES, 128-bit AES, 192-bit AES, 256-bit AES, IPSec, SHA-1, SHA-256, SSL/TLS
Antal användare:	100 gebruiker(s)
Förvaringstemperatur:	-25 - 70 °C
Webbaserad hantering:	Ja
Förvaringsfuktighet:	5 - 95 procent
Återställningsknapp:	Ja
Flashminne:	4096 MB
DHCP-server:	Ja
Höjd, drift:	0 - 2000 m
Quality of Service (QoS):	Ja
DHCP-klient:	Ja
Stöd för multicast:	Ja
Antal Gigabit Ethernet (koppar) portar:	5
Konsolport:	RJ-45
Mått (B x D x H):	210 x 220 x 42.5 mm
WAN-port:	Ethernet (RJ-45)
URL-filtrering:	Ja
Brandväggsgenomströmning:	750 Mbit/s
VPN-genomströmning:	400 Mbit/s
IPS/IDS genomströmning:	200 Mbit/s
VPN-tunnlar kvantitet:	50
Samtidiga anslutningar:	100000
DDoS-skydd:	Ja
Wifi:	Nee
AC-ingångsspänning:	90-260 V
AC-ingångsfrekvens:	47/63 Hz
Drifttemperatur (TT):	0 - 45 °C
Relativ luftfuktighet i drift (VV):	5 - 80 procent
Point-to-Point Protocol over Ethernet (PPPoE):	Ja
Syslog:	Ja
Routingprotokoll:	BGP, OSPF, RIP
Port forwarding:	Ja
Maximalt antal brandväggsanslutningar per sekund:	3600