Mini-Box picoPSU-150-XT Bruksanvisning

Mini-Box Dator strömförsörjning picoPSU-150-XT

Läs nedan 📖 manual på svenska för Mini-Box picoPSU-150-XT (4 sidor) i kategorin Dator strömförsörjning. Denna guide var användbar för 8 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/4

Mini-Box.com ATX DC-DC Converter Series

pixoPSU 150- -XT Quick Installation Guide Page 1

picoPSU 150- -XT

12V, 150Watt, 24pin ATX Power Supply

Quick Installation Guide

Version 1.0a

P/N picoPSU- -150 XT

Introduction

The picoPSU- -XT is a small yet powerful and fully compliant ATX power 150

supply designed to power a wide variety of motherboard from a single 12V

regulated power source.

The PICOPSU- -XT is the only snap power supply solution for general150

purpose motherboards. Compatible with an entire range of mini-ITX, UATX or full

size ATX motherboards the picoPSU- -XT provides cool, silent power for 150

system. The PICOPSU- -XT has many advantages over a regular power 150

supply:

- Smallest 24 pin ATX PSU to date

- silent operation100%

- Low heat dissipation with efficiency over 95%

- Plugs directly into the motherboard’s power connector, no cable mess

- Solid Capacitor design, very long life design.

- 12V Aux power connector designed to support processors with TDP of 35 or

65Watts.

- 2nd HDD power harness connector.

Mini-Box.com ATX DC-DC Converter Series

pixoPSU 150- -XT Quick Installation Guide Page 2

Quick installation Instructions

The PICOPSU- -XT has been specifically designed for the Mini-ITX form 150

factor, thus eliminating the need for ATX power cables. It is also 1U compliant –

height will not exceed 1U form factor.

1) After the picoPSU module was ‘snapped in’, hook the hard drive power or

floppy power to your floppy/hard drives. If more hard drives or floppy connectors

are needed, use a HDD/floppy “Y” splitter cable.

Fig 1.1 picoPSU-120 plugged into ATX connector.

2) Connect a 12 VDC power adapter (or any 12V source) to the DC- -to DC

connector, center pin / white wire is positive (+).

3) Turn on the PC using the motherboard ON/OFF switch

Typical configuration

The picoPSU- -XT has been tested with all mini- board under virtually any 150 ITX

disk/floppy/CDROM/PCI configuration. Additionally, the PICOPSU- -XT can 150

power boards that require 4 pin 12V aux power connector to be used with

processors with TDP ranging from 35 to 65watts.

Removing the picoPSU- -XT150

In order to remove the picoPSU you must release the power connector latch and

then remove the unit. Gently lift the picoPSU out from the ATX connector, by

grabbing from the picoPSU PCB, not from components or the wire harness.

Mini-Box.com ATX DC-DC Converter Series

pixoPSU 150- -XT Quick Installation Guide Page 3

Specifications, picoPSU- -XT, 150Watts DC-DC ATX Power Supply150

Power Ratings (max load = 150watts)

Volts (V)

Max Load (A)

Peak Load (A)

Regulation %

+/- 1.5%

5VSB

1.5A

+/- 1.5%

3.3V

+/- 1.5%

-12V

0.05A

0.1A

+/- 5%

12V

10A

Switched input

Precautions for operating this DC-DC converter:

- For fan less operation de-rate the output of the 3.3 and 5V rails by ~35% or

ensure PSU surface temperature should not exceed 65C, whichever comes first.

- Combined and sustained output should not exceed 65% of total power or or

ensure PSU surface temperature should not exceed 65C, whichever comes first.

- Input current should not exceed 8A. For current higher loads, we suggest using

a 2x2 mini-FIT JR as an input connector.

- Peak load for individual rails should not exceed 60 seconds.

- For long life operation, PSU surface temperature should not exceed 65C.

Efficiency Ratings, 3.3 and 5V rail

CH1=5V

Efficiency (%)

CH2=3.3V

Efficiency (%)

86%

85%

94%

93%

96%

94%

93%

91%

Input Requirements: 12V regulated, min=2A, max = load dependent. Over-

voltage shutdown will occur at ~13-13.5V. Do not operate this PSU from a car

battery, as unit requires 12VDC regulated input voltage.

Size: 53mm(L) * 20mm(W) * 30mm (H) (1U compliant)

Weight: 60gramms, including cable harness, 30 grams without cable harness.

DC Jack: - Female, panel mount, 2.5*5.5*10 mm.

Produktspecifikationer

Varumärke:	Mini-Box
Kategori:	Dator strömförsörjning
Modell:	picoPSU-150-XT
Färg på produkten:	Zwart
Vikt:	10900 g
Bredd:	100 mm
Djup:	370 mm
Höjd:	265 mm
Sladdlängd:	1.83 m
Förpackningens vikt:	13000 g
Förpackningens bredd:	195 mm
Djuppackning:	466 mm
Förpackningshöjd:	370 mm
Husmaterial:	Kunststof
LED-indikatorer:	Batterijvervanging
Vormfaktor:	Tower
USB uttag:	Ja
Medföljande kablar:	Input power cable, Phone (RJ-11), USB cable
Antal USB 2.0-portar:	2
Typ av seriell anslutning:	RS-232
Antal batterier/batterier som stöds:	1
Certifiering:	CE, EAC, RCM
RS-232 port:	1
Ljudlarm:	Ja
Respons tid:	4 ms
Hållbarhetscertifikat:	RoHS
Uteffekt:	900 W
Batteri/Batteri laddningstid:	8 uur
Förvaringstemperatur:	-15 - 45 °C
Frekvens:	50/60 Hz
Kompatibla operativsystem:	Windows 7/Vista/XP/2000/ME/98, Windows Server\n2003/2008, Mac OS, Linux
Förvaringsfuktighet:	0 - 95 procent
Mac-kompatibilitet:	Ja
Höjd, drift:	0 - 3000 m
Höjd vid förvaring:	0 - 1500 m
Seriell port(ar):	1
Modem (RJ-11) port:	1
Plugg:	C14 stekker
Drifttemperatur (TT):	0 - 40 °C
Relativ luftfuktighet i drift (VV):	0 - 95 procent
Batteriteknik:	Sealed Lead Acid (VRLA)
Type beeldscherm:	LCD
Harmoniserad systemkod (HS):	85078000
Överspänningsenergiklassificering:	405 J
Antal AC-utgångar:	6 AC-uitgang(en)
Uttagstyper:	Type F
Vågskyddsfunktioner:	Network, Telephone
Uteffektkapacitet:	1.5 kVA
Ingångsdriftspänning (min):	170 V
Ingångsdriftspänning (max):	270 V
Utgångsdriftspänning (min):	230 V
Utgångsdriftspänning (max):	230 V
UPS-topologi:	Line-interactive
Antal ingångsfaser:	1
Typisk backuptid vid halv belastning:	11 min
Typisk backuptid vid full laddning:	3 min
Seriellt gränssnitt:	Ja
Utgångsfrekvens:	50/60 Hz
Ljudlarmlägen:	Batterijvervanging
Reglering av utspänning:	10 procent
Antal utgångsfaser:	1
EMI/RFI brusfiltrering:	Ja
Spänningsskydd:	Ja
Vågform:	Zuivere sinus
Ersättningsbatteripatron:	RBP0016
USB-porttyp:	USB Type-A
Antal typ F-utgångar:	6