Nemco 6422 Bruksanvisning

Nemco Inte kategoriserad 6422

Läs nedan 📖 manual på svenska för Nemco 6422 (2 sidor) i kategorin Inte kategoriserad. Denna guide var användbar för 8 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/2

HEATED DISPLAY CASE

Model Series: 6421, 6422, 6423, & 6425

OPERATING INSTRUCTIONS

INTRODUCTION

1. Please read instructions before using this appliance.

2. When using electrical appliances, always follow basic precautions to reduce the risk of fire, electric shock and injury to persons.

3. Clean machine thoroughly before and after all uses using cleaning instructions below.

SAFETY INSTRUCTIONS

1. Plug electrical cord into a certified electrical outlet with a corresponding voltage rating as listed on the machine model labels.

2. Always unplug the electric cord when appliance is not in use and before cleaning, adjusting or maintaining this machine. Do not

operate with a damaged cord or plug or after the machine malfunctions, has been dropped or damaged. Use authorized service for

examination, electrical or mechanical adjustment or repair.

3. This machine will be HOT during use and for a short time after it is turned off BE CAREFUL. To avoid burns, do not let bare skin –

touch hot surfaces. Keep combustible materials away from appliance.

4. Use extreme caution when any appliance is used by or near children and whenever the appliance is left operating and unattende d.

5. This appliance is not intended for use near or around water. Never locate appliance where it may fall into a water container.

6. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause an electrical shock, fire or

damage to the appliance. Do not block air intakes or exhaust in any manner. Do not use on soft surfaces where openings may

become blocked.

PREPARATION

1. Remove all packing pieces and lift unit out of the box.

2. Remove any outside packaging.

3. Remove any plastic coating that may be affixed to stainless steel surfaces.

4. Be sure the round tier rack systems (equipped on models that rotate) are secure at the top and bottom.

5. CAUTION To reduce the risk of fire, the appliance is to be installed in non-combustible surroundings only, with no –

combustible material within 18 inches of the sides, front, or rear of the appliance or within 40 inches above the appliance.

The appliance is to be mounted on floors of noncombustible construction with non-combustible flooring and surface finish

and with no combustible material against the underside, or on noncombustible slabs or arches that have no combustible

material against the underside. Such construction shall in all cases extend not less than 12 inches beyond the equipment

on all sides.

6. Unit can only be operated with the 4 provided. Failure to do so will cause damage to the unit. ” legs

7. Set unit on a flat surface.

8. Position unit near the power outlet. Avoid the use of extension cords. Do not run cord under carpeting or cover with runners or the

like. Arrange cord where it will not be tripped over.

9. This appliance has hot and live electrical parts. Do not use in areas where gasoline, paint or flammable liquids are used or stored.

10. If unit fails to work properly when first operated call NEMCO customer service at 1-800- -6761. 782

ELECTRICAL REQUIREMENTS

Refer to the product tag (serial plate) on the back of the unit for voltage and wattage requirements. Be sure to plug unit into grounded

outlet with sufficient power.

WARNING: DURING NORMAL OPERATIONS THE EXTERIOR OF THE UNIT IS HOT.

OPERATION

1. Fill the water reservoir to provide humidity as required. Do not overfill.

2. Plug the unit into the appropriate power supply.

3. Turn heat switch to on position.

4. Turn temperature switch to high and preheat approximately 15 minutes.

5. Turn the temperature control to desired setting. (High, Medium or Low)

6. Load food products when pre-heat is complete.

7. Pull pin and lift the top coupling to remove rack.

8. To disconnect appliance, turn controls to off and remove plug from outlet.

NEMCO FOOD EQUIPMENT 301 Meuse Argonne, Hicksville, OH 43526

1-800- -6761 T782 oll Free 419 542- -6690 Fax

www.nemcofoodequip.com - -11 14 13

CLEANING

NOTE: Proper maintenance plays an important part in the life span and functioning of the unit.

1. Turn the temperature control to the off position.

2. Turn the light switch and heat switch off.

3. Unplug the unit from the power supply.

4. Do not attempt to clean unit while it is turned on; it will be hot during operation.

5. The rotary rack is removed by lifting on the drive coupling located at the top of the shelf system and carefully removing the rack

from the interior of the case. Stationary racks just lift out. Wash with warm water and a mild detergent. Rinse and dry. Rack can

be installed by reversing process.

6. Clean daily. Clean excess food debris from the interior of the unit.

7. Clean the water reservoir daily with a scouring pad and mild detergent. Use of distilled water in the reservoir will reduce mineral

deposit build-up.

8. Clean interior and exterior of unit with a mild detergent and warm water. Be sure to dry unit.

9. Do not immerse in water or other liquid. Avoid splashing water into the motor unit.

SERVICE INSTRUCTIONS

1. For warranty or service information, please refer to the attached “Nemco Food Equipment Warranty Service Procedures.”

2. The light can be replaced easily in the event it burns out. Be sure to replace it with a shatterproof light.

ITEM

NUMBER

PART NUMBER

DESCRIPTION

69164

48626- PM

48626-PT

48626-PR

CONTROL COVER, ALL

CONTROL COVER LABEL, 6421 / 6422

CONTROL COVER LABEL, 6425

CONTROL COVER LABEL, 6423

47472

46356

SOCKET

LAMP

47716

KNOB

47420

ROCKER SWITCH

48620

DOOR GLASS

45768-3

MOTOR

48621- PM

48621-HT

48621-PR

48623

FRONT BACKLIT GRAPHICS, 6421 / 6422

FRONT BACKLIT GRAPHICS, 6425

FRONT BACKLIT GPAPHICS, 6423

FRONT GRAPHICS SUPPORT

48268

48269

BACKLIT SOCKET

BACKLIT LAMP

48622- PM

48622-HT

48622-PR

48624

SIDE BACKLIT GRAPHICS, 6421 / 6422

SIDE BACKLIT GRAPHICS, 6425

SIDE BACKLIT GRAPHICS, 6423

SIDE GRAPHICS SUPPORT

66790-1

66791-1

66793

66794

RACK, 6421

RACK, 6422

RACK, 6425

RACK, 6423

69036

PAN COVER

48605

ADJUSTABLE LEG

NOTE THAT THERE MUST

BE AN 18” NON-COMBUSTIBLE

ZONE ON ALL (4) SIDES & A 40”

NON-COMBUSTIBLE ZONE

FROM THE TOP

Produktspecifikationer

Varumärke:	Nemco
Kategori:	Inte kategoriserad
Modell:	6422
Färg på produkten:	Zwart
Skärm diagonal:	17 "
Upplösning:	1280 x 1024 Pixels
Pekskärm:	Ja
Betraktningsvinkel, horisontell:	160 °
Betraktningsvinkel, vertikal:	160 °
Skärmform:	Flat
Typiskt kontrastförhållande:	1000:1
Ljusstyrka:	250 cd/m²
Pekskärmstyp:	Tafelblad
VGA (D-Sub) port(ar):	1
DVI-port:	Ja
Inbyggda högtalare:	Ja
Genomsnittlig effekt:	2 W
Antal högtalare:	2
Display, antal färger:	16.78 miljoen kleuren
Luidsprekers:	2
Displayteknik:	LCD
Respons tid:	5 ms
Panelmonteringsgränssnitt:	100 x 100 mm
DVI-D-portar:	1
Bildförhållande:	5:4
Digital horisontell frekvens:	31.47 - 60.02 kHz
Digital vertikal frekvens:	56 - 75 Hz
Apparte H/V sync:	Ja
Sammansatt synkronisering:	Ja
Sync-on-green (SOG):	Ja
Effektiv bilddiameter:	338 x 270 mm
Plug and play:	Ja
Enhetsbredd (med stativ):	386.8 mm
Djupenhet (med stativ):	202 mm
Enhetshöjd (med stativ):	341.9 mm
Vikt (med stativ):	5600 g
AMD FreeSync:	Nee
NVIDIA G-SYNC:	Nee
On Screen Display (OSD):	Ja
Stöder Windows:	Ja
Förvaringstemperatur:	-20 - 60 °C
Förvaringsfuktighet:	10 - 90 procent
Medeltid mellan fel (MTBF):	50000 uur
Upphängningssystem för väggen:	Ja
Pekskärmsteknik:	Capacitief
Mått (B x D x H) med bas:	386.8 x 202 x 341.9 mm
Drifttemperatur (TT):	0 - 40 °C
Relativ luftfuktighet i drift (VV):	20 - 80 procent
Antal samtidiga beröringspunkter (Windows 7):	2