Ozito ZLHDK-150U Bruksanvisning

Ozito Borrmaskin ZLHDK-150U

Läs nedan 📖 manual på svenska för Ozito ZLHDK-150U (2 sidor) i kategorin Borrmaskin. Denna guide var användbar för 8 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/2

BATTERY SAFETY WARNINGS

ELECTRICAL SAFETY

DESCRIPTION OF SYMBOLS

Warning

Do not use or store battery in

temperatures exceeding 50ºC

Volts Hertz

Alternating Current

Direct Current

Milliamperes

Watts

Amp Hour

HzV

ac/~

Lithium Ion Battery

Do not put in the rubbish

Do not get battery wet

Recycle Battery

Do not incinerate

ZLBP-015U

1.5Ah BATTERY

12V Lithium Ion

INSTRUCTION MANUAL

SPECIFICATIONS

Input: 12V

Battery Capacity: 1.5Ah Li-Ion

Charge Times: 1hr (Fast Charger)

3-5hrs (Eco Charger)

ozito-diy.co.uk

1 2

1 Battery Release Button

2 Battery

THIS MANUAL CONTAINS IMPORTANT SAFETY AND OPERATING INSTRUCTIONS FOR

YOUR BATTERY CHARGER.

1. Before using the charger read all instructions and cautionary markings on the charger,

battery pack and the product using the battery pack.

2. This charger is not intended for any uses other than charging rechargeable batteries. Any

other use may result in risk of ﬁ re, electric shock or electrocution.

3. Do not place any object on top of the charger or place the charger on a soft surface that

may result in excessive internal heat. Place the charger in a position away from any heat

source.

4. To reduce risk of damage to the electric plug and cord, pull by the plug rather than the

cord when disconnecting the charger.

5. Make sure the cord is located so that it will not be stepped on, tripped over, or otherwise

subjected to damage or stress.

6. An extension cord should not be used unless absolutely necessary. Use of an improper

extension cord could result in the risk of ﬁ re, electric shock or electrocution.

7. Do not operate the charger if it has received a sharp blow, been dropped or otherwise

damaged in any way. Have it checked by an electrician or power tool repairer.

8. Do not disassemble charger. Take it to an electrician or power tool repairer when

service or repair is required. Incorrect reassembly may result in a risk of electric shock,

electrocution or ﬁ re.

9. To reduce risk of electric shock, unplug the charger from the outlet before attempting any

cleaning. Removing the battery pack will not reduce this risk.

10. Never attempt to connect 2 chargers together.

11. DO NOT store or use the tool and battery pack in locations where the temperature may reach

or exceed 40ºC (such as inside sheds or metal buildings in summer).

12. The charger is designed to operate on standard household electrical power (240 volts).

Do not attempt to use it on any other voltage!

13. The battery pack is not fully charged out of the carton. First read the safety instructions

and then follow the charging notes and procedures.

14. The longest life and best performance can be obtained if the battery pack is charged

when the air temperature is between 18 - 24ºC. Do not charge the battery pack in an air

temperature below 10ºC or above 40ºC. This is important and will prevent damage to the

battery pack.

15. Do not incinerate the battery pack even if it is seriously damaged or is completely worn out.

The battery can explode in a ﬁ re.

16. Never attempt to open the battery pack for any reason. If the plastic housing of the battery

pack breaks or cracks, immediately discontinue use and do not recharge.

17. During charging, the battery must be placed in a well ventilated area.

WARNING! When using mains-powered tools, basic safety precautions,

including the following, should always be followed to reduce risk of ﬁ re, electric

shock, personal injury and material damage.

Read the whole manual carefully and make sure you know how to switch the tool o󰀨 in an

emergency, before operating the tool. Save these instructions and other documents supplied

with this tool for future reference.

The charger has been designed for 230V and 240V only. Always check that the power supply

corresponds to the voltage on the rating plate.

Note: The supply of 230V and 240V on Ozito tools are interchangeable for the UK.

This tools charger is double insulated; therefore no earth wire is required.

If the supply cord is damaged, it must be replaced by an electrician or a power tool repairer in

order to avoid a hazard.

Note: Double insulation does not take the place of normal safety precautions when operating

this tool. The insulation system is for added protection against injury resulting from a possible

electrical insulation failure within the tool.

The power supply for this products charger should be protected by a residual current device

(rated at 30mA or less). A residual current device reduces the risk of electric shock.

Manual_ZLBP-015U.indd 1 06.08.2019 10:33:40

BATTERY PROTECTION SYSTEM

The tool is equipped with a battery protection system, which helps to

ensure longevity of the battery.

The output power automatically cuts o󰀨 during operation when the tool

and/or battery are placed under the following situations:

• When the tool is overloaded:

If this occurs, release the trigger switch and remove causes of

overload, then pull the switch trigger again to restart.

• When the remaining battery capacity becomes low:

Recharge the battery pack.

Note: The battery protection system does not in any way damage the

tool.

Note: The indicated capacity may be lower than the actual level during

use or immediately after using the tool.

ZLBP-015U

CHARGING YOUR LITHIUM ION BATTERY

This battery has been shipped in a low charge condition, and requires

charging prior to use. Allow several cycles of charging and discharging

(through use with a compatible tool) for the battery to reach its optimum

performance / runtime.

This battery has two compatible Ozito chargers available through your

local Bunnings Warehouse:

• ZLCG-112U Fast Charger

• ZLCG-312U Eco Charger

Only use the battery pack with Ozito Home 12Volt cordless

products.

1. Insert the power plug of the charger into the mains socket outlet.

The red LED on the plug will begin to illuminate when properly

connected to power supply.

2. Insert the battery pack into the battery charger .

3. Remove battery from the charger once fully charged. Disconnect

the charger from the power supply.

Note: The battery pack can become a little warm during the charging.

This is normal

If the battery pack fails to charge, check:

• if there is voltage at the socket outlet

• that the battery and charger are properly connected.

If the battery pack still fails to charge, please contact our customer

service center.

1. OPERATION WARRANTY

All of our products undergo strict quality checks to ensure that they

reach you in perfect condition. In the unlikely event that your device

develops a fault, please contact our service department at the address

shown on this guarantee card. You can also contact us by telephone

using the customer service number shown. Please note the following

terms under which guarantee claims can be made:

1. These warranty terms regulate additional warranty services, which

the manufacturer mentioned below promises to buyers of its new

products in addition to their statutory guarantee claims are not

affected by this guarantee. Our guarantee is free of charge to you.

2. The warranty services only covers defects due to material or

manufacturing faults on

a product which you have bought from the manufacturer mentioned

below are limited to either the rectiﬁcation of said defects on the

product or the replacement of the product, whichever we prefer.

Please note that our devices are not designed for use in

commercial, trade or professional applications. A guarantee contract

will not be created if the device has been used by commercial, trade

or industrial business or has been exposed to similar stresses during

the guarantee period.

3. The following are not covered by our guarantee:

- Damage to the device caused by a failure to follow the assembly

instructions or due to incorrect installation, a failure to follow the

operating instructions (for example connecting it to an incorrect

mains voltage or current type) or a failure to follow the maintenance

and safety instructions or by exposing the device to abnormal

environmental conditions or by lack of care and maintenance.

- Damage to the device caused by abuse or incorrect use (for

example overloading the device or the use or unapproved tools or

accessories), ingress of foreign bodies into the device (such as sand,

stones or dust, transport damage), the use of force or damage

caused by external forces (for example by dropping it).

- Damage to the device or parts of the device caused by normal or

natural wear or tear or by normal use of the device.

4. Your Product is guaranteed for a period of 60 months from the

original date of purchase and is intended for DIY (Do It Yourself) use

only. Lithium Ion batteries and chargers are covered by a 12 month

warranty. Warranty excludes consumable parts, for example:

grinding discs. Guarantee claims should be submitted before the

end of the guarantee period within two weeks of the defect being

noticed. No guarantee claims will be accepted after the end of the

guarantee period. The original guarantee period remains applicable

to the device even if repairs are carried out or parts are replaced. In

such cases, the work performed or parts ﬁtted will not result in an

extension of the guarantee period, and no new guarantee will

become active for the work performed or parts ﬁtted. This also

applies if an on-site service is used.

IN ORDER TO MAKE A CLAIM UNDER THIS WARRANTY YOU MUST

RETURN THE PRODUCT TO THE PLACE OF PURCHASE WITH YOUR

Please refer to the restrictions of this warranty concerning wearing

parts, consumables and missing parts as set out in the service

information in these operating instructions.

CUSTOMER SERVICE HELPLINE

GB: 0151 294 4488

IRL: 1850 882711

Ozito-diy.co.uk

iSC GmbH · Eschenstraße 6 · 94405 Landau /Isar · Germany

Manual_ZLBP-015U.indd 2 06.08.2019 10:33:40

Produktspecifikationer

Varumärke:	Ozito
Kategori:	Borrmaskin
Modell:	ZLHDK-150U

Behöver du hjälp?

Om du behöver hjälp med Ozito ZLHDK-150U ställ en fråga nedan och andra användare kommer att svara dig

Ditt namn*

Din e-post*

Skriv din fråga här

Borrmaskin Ozito Manualer

Ozito BDP-500 Bruksanvisning

15 Oktober 2024

Ozito PXDDS-200 Bruksanvisning

30 September 2024

Ozito PXRHK-200 Bruksanvisning

26 Augusti 2024

Ozito PXDDK-070U Bruksanvisning

26 Augusti 2024

Ozito ZLHDK-150U Bruksanvisning

25 Augusti 2024

Ozito PXDDK-070 Bruksanvisning

24 Augusti 2024

Ozito PXBIS-320 Bruksanvisning

16 Augusti 2024

Ozito HDR-3000 Bruksanvisning

15 Augusti 2024

Ozito PXDDK-200 Bruksanvisning

12 Augusti 2024

Ozito SHD-3100 Bruksanvisning

7 Augusti 2024

Borrmaskin Manualer

Nyaste Borrmaskin Manualer

Black And Decker PF126 Bruksanvisning

27 Oktober 2024

Bosch GSR 120-LI Professional Bruksanvisning

24 Oktober 2024

Bosch gsr 18 2 li Bruksanvisning

23 Oktober 2024

Vonroc CD510DC Bruksanvisning

21 Oktober 2024

Einhell TC-CD 18/35 Li Bruksanvisning

20 Oktober 2024

Einhell Herocco Solo Bruksanvisning

19 Oktober 2024

DeWalt dc987ka Bruksanvisning

19 Oktober 2024

AEG KH 28 Super XE Bruksanvisning

18 Oktober 2024

MSW -DDM255 Bruksanvisning

16 Oktober 2024

MSW -DDM152 Bruksanvisning

16 Oktober 2024