PAC AP4-TY11 Bruksanvisning

PAC mottagare AP4-TY11

Läs nedan 📖 manual på svenska för PAC AP4-TY11 (4 sidor) i kategorin mottagare. Denna guide var användbar för 2 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF
Sida 1/4
© 2018 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-audio.com
C
Page 1
Rev: V2
Date:032718
Advanced Amplier Interface
for Toyota / Lexus
AP4-TY11
The AP4-TY11 provides a 6-channel pre-amp output for use with aftermarket audio equipment. Using the full range,
xed level head unit output, in conjunction with data bus messages, the AP4-TY11 delivers a variable 5v RMS pre-
amp output with fading, balance, equalization, and level control capabilities. The module also retains audio from
other vehicle features such as factory navigation prompts, Bluetooth and Voice Activation. An accessory controlled
remote amplier turn on wire is also provided by the AP4-TY11. When used in conjunction with the APA-TOS1 (sold
separately), the module can provide a variable 2-channel ber optic digital audio output (TOSLINK).
Introduction and Features
Important Notes
Wiring Connection Chart
To Aftermarket
Amplifier
Non-FadingRearFront
1(L) 2(R) 4(R) 5(L) 6(R)3(L)
Remote Turn On Output (2A Max)
Mute Input From Navigation
Mute Input From Telematics
To Amp PRO*
B*
A*
C*
*Connections “To Amp PRO”, “A”, “B” and “C”
are discussed in detail starting on page 5 under
“Voice / Nav Audio Connections”.
To Vehicle
Harness
To Radio
Non-Fading
Level Control
Knob
AP4-TY11-HAR
To Radio
1. Only compatible in vehicles equipped with a data bus controlled premium sound system. To verify compatibility in Toyota,
look for a JBL logo on the radio. In Lexus applications, most compatible radios will have a factory subwoofer or center
channel. RX Series Lexus are always amplied regardless if they do or do not have a center channel or subwoofer. Always
check PAC-audio.com for radio specic compatibility notes based on the year, make and model of the vehicle.
2. Voice activation / navigation prompt audio requires the AP4-TY11 harness to be connected for the proper conguration for
the vehicle. See the Vehicle Connections Chart starting on page 2 for details.
3. The factory radio's speed controlled volume, DSP, and surround sound mode are not supported by the AP4 outputs.
4. The factory amplier must remain connected, and in the vehicle after the AmpPRO has been installed.
5. Prior to testing, cycle the ignition off and back on again to properly initilize the AP4-TY11.
6. The AP4-TY11 beep volume and minimum volume levels are set to 0 dB by default. If you are happy with this level in your
particular application, additional adjustment is not required. Please refer to the Setup and Conguration section on page 9
for more details.
7. The remote output is rated at 2A of current. If more current is needed, an external relay must be used.
8. Channels 5 and 6 are non-fading outputs. The output level of channels 5 and 6 can be controlled using the supplied level
control knob.
9. The level control knob must be connected in order to manually adjust the beep volume and minimum volume settings.
10. Due to variations in output levels between various OEM radios and even between radio modes, the AP4-TY11 output
voltage may vary from the selected 5 volt (or 4 volt when DIP switch 2 is down) output.
11. Toyota Safety Connect and Lexus Enform (SOS) can easily be retained. See the Tech Brief "AP4-TY SOS Retention" at
PAC-audio.com for detailed instructions.
© 2018 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-audio.com
C
Page 2
Rev: V2
Date:032718
Advanced Amplier Interface
for Toyota / Lexus
AP4-TY11
Vehicle Connections Chart
The connections chart provides the information necessary to retain the voice prompts and navigation audio along with details
of where to nd the factory amplier, and in some cases, location of the factory navigation module. In vehicles with navigation
and / or a voice button on the steering wheel, locate your vehicle on this chart to determine which cong you will use. If the
vehicle does not have the voice button on the steering wheel and it does not have navigation, this information will not pertain to
the installation.
Use the chart to determine which Conguration to use, and the location of the amplier and navigation module (when
applicable). Under the "Cong Type" column, if it is listed as "A" it is cong type A, "B" is cong type "B" and Cong type C is
listed as the 3 possible versions. "C v1" is cong type C version 1, "C v2" is cong. type C version 2, and "C v3" is cong C
version 3. See the appropriate section covered on pages 5 thru 8 regarding the connections covered in the chart. If there is
an N / A listed for the vehicle, the information in that column does not pertain to your vehicle. The "Nav Input Audio" and "Nav
Output Audio" information describes the wiring and connector found at the navigation module.
Toyota
Model Years Cong Type OEM Amp Location Nav Module Location Nav Input Audio Nav Output Audio
4Runner 2003 - 2005 C v3 Behind Right Rear Side *
Panel in Rear Cargo Area
Over Right Rear Tire Well
In Rear Cargo Area
18 Pin Connector
Pin 1 (+) Light Green
Pin 10 (-) Blue
18 Pin Connector
Pin 2 (+) Light Green
Pin 11 (-) Blue
4Runner 2006 - 2013 A Behind Right Rear Side
Panel in Rear Cargo Area
N / A N / A N / A
Avalon 2005 - 2007 C v3 Under Front Right Seat Left Side of Luggage
Compartment
18 Pin Connector
Pin 1 (+) Gray
Pin 10 (-) Yellow
18 Pin Connector
Pin 2 (+) Pink
Pin 11 (-) Violet
Avalon 2008 - 2010 Non Nav: A
Nav: C v3
Under Front Right Seat Left Side of Luggage
Compartment
18 Pin Connector
Pin 1 (+) Gray
Pin 10 (-) Yellow
18 Pin Connector
Pin 2 (+) Pink
Pin 11 (-) Violet
Avalon 2011 - 2012 A Under Front Right Seat N / A N / A N / A
Avalon 2013 - 2014 B Under Front Left Seat N / A N / A N / A
Camry 2007 - 2011 A Under Front Right Seat N / A N / A N / A
Camry 2012 - 2014 B Under Front Left Seat N / A N / A N / A
Corolla 2005 - 2008 Under Front Right SeatN / A N / A N / A N / A
Corolla 2009 - 2011 A Under Front Right Seat N / A N / A N / A
FJ Cruiser 2011 - 2014 A Behind Right Rear Side
Panel in Rear Cargo Area
N / A N / A N / A
Highlander 2008 - 2010 A Under Front Right Seat N / A N / A N / A
Highlander 2011 - 2013 ** Radio and
Display: B
All Others: A
Under Front Right Seat N / A N / A N / A
Prius 2004 - 2005 C v1 Under Front Right Seat Pin 22 (+) White N / A N / A
Pin 21 (-) Black
Prius 2006- 2009 C v2 Under Front Right Seat Pin 25 (+) Green N / A N / A
Pin 26 (-) Red
Prius 2010 - 2011 A Under Front Right Seat N / A N / A N / A
Prius 2012 - 2015 B Under Front Right Seat N / A N / A N / A
Rav4 2004 - 2006 Behind Right Rear Side N / A
Panel in Rear Cargo Area
N / A N / A N / A
© 2018 AAMP Global. All rights reserved. PAC is a Power Brand of AAMP Global.
PAC-audio.com
C
Page 3
Rev: V2
Date:032718
Advanced Amplier Interface
for Toyota / Lexus
AP4-TY11
Vehicle Connections Chart (cont.)
Model Years Cong Type OEM Amp Location Nav Module Location Nav Input Audio Nav Output Audio
Rav4 2007 - 2012 A Behind Right Rear Side
Panel in Rear Cargo Area
N / A N / A N / A
Rav4 2013 B Behind Right Rear Side
Panel in Rear Cargo Area
N / A N / A N / A
Sequioa 2005 - 2013 A Under Front Right Seat N / A N / A N / A
Sienna 2004 C v3 Right Side of Dash
Behind Glovebox
Under Front Right Seat 18 Pin Connector
Pin 1 (+) Green / White
Pin 10 (-) Brown
18 Pin Connector
Pin 2 (+) Pink
Pin 11 (-) Violet
Sienna 2005 - 2010 A Right Side of Dash
Behind Glovebox
N / A N / A N / A
Sienna 2011 - 2014 A Under Front Right Seat N / A N / A N / A
Tacoma 2005 - 2008 Back Wall Right SideN / A N / A N / A N / A
Tacoma 2009 - 2011 A Back Wall Right Side N / A N / A N / A
Tacoma 2012 - 2013 B Back Wall Right Side N / A N / A N / A
Tundra 2009 - 2012 A Built Into Rear Seat Back N / A N / A N / A
Tundra 2007 - 2013 A Under Front Right Seat N / A N / A N / A
Venza 2009 - 2012 A Under Front Left Seat N / A N / A N / A
Venza 2013 B Under Front Left Seat N / A N / A N / A
* VR / Nav Trigger wire is in the 18-Pin Navigation connector in Pin 15 and is Violet / White.
** If the radio only has provisions for one of the 20-Pin connectors from the AP4-TY11 harness, it is "Cong A", if it has provisions
for both 20-Pin connectors, it is "Cong B".
Toyota (cont.)
Lexus
Model Years Cong Type OEM Amp Location Nav Module Location Nav Input Audio Nav Output Audio
CT200h 2011 - 2013 A Under Front Right Seat N / A N / A N / A
ES300
2002 - 2003* C v3 Behind Right Side Panel
of Luggage Compartment
Left Side of Luggage
Compartment
18 Pin Connector
Pin 1 (+) Pink
Pin 10 (-) Violet
18 Pin Connector
Pin 2 (+) Pink
Pin 11 (-) Violet
ES300h 2013 - 2014** Multi-Media
Radio: B
Other: A
Under Front Left Seat N / A N / A N / A
ES330 2004 - 2006 A Behind Right Side Panel
of Luggage Compartment
N / A N / A N / A
ES350 2007 - 2009** Non Nav: A
Nav: C v1
Behind Right Side Panel
of Luggage Compartment
N / A N / A Pin 22 (+) Yellow
Pin 21 (-) Brown
ES350 2010 - 2012 A Behind Right Side Panel
of Luggage Compartment
N / A N / A N / A
ES350 2013 - 2014** Multi-Media
Radio: B
Other: A
Behind Right Side Panel
of Luggage Compartment
N / A N / A N / A

Produktspecifikationer

Varumärke: PAC
Kategori: mottagare
Modell: AP4-TY11

Behöver du hjälp?

Om du behöver hjälp med PAC AP4-TY11 ställ en fråga nedan och andra användare kommer att svara dig


mottagare PAC Manualer

PAC

PAC AP4-TY14 Bruksanvisning

12 Februari 2025
PAC

PAC AP4-TY11 Bruksanvisning

12 Februari 2025
PAC

PAC OEM-1 Bruksanvisning

31 Augusti 2024

mottagare Manualer

Nyaste mottagare Manualer

DJI

DJI D-RTK 3 Bruksanvisning

4 April 2025
Alpine

Alpine MRX-F65 Bruksanvisning

2 April 2025
QSC

QSC SPA-Qf 60x2 Bruksanvisning

2 April 2025
Harper

Harper HDT2-5010 Bruksanvisning

2 April 2025
Harper

Harper HDT2-2010 Bruksanvisning

2 April 2025
Pro-Ject

Pro-Ject Stereo Box DS Bruksanvisning

30 Mars 2025
Streacom

Streacom TL1 Bruksanvisning

30 Mars 2025
Graupner

Graupner GR-8 Bruksanvisning

30 Mars 2025
MB Quart

MB Quart FA2-2000.1 Bruksanvisning

29 Mars 2025
MB Quart

MB Quart FA2-1500.1 Bruksanvisning

29 Mars 2025