Panamorph DCR-S2 Bruksanvisning
Läs nedan 📖 manual på svenska för Panamorph DCR-S2 (2 sidor) i kategorin Beamer. Denna guide var användbar för 8 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare
Sida 1/2
®
We bring cinema home
DCR-S2
INSTALLATION GUIDE
(Phillips #2 screwdriver required)
Anamorphic Lens System
CEILING OR SHELF MOUNTING. Regardless of the projector
orientation the DCR retainer should be installed with the prongs closer
to the ceiling so the Panamorph logo is upright after installation.
ABOUT GEOMETRIC DISTORTION. Anamorphic vertical
compression lenses such as the DCR naturally create a slight “barrel”
shaped curvature especially at the edges of the image. The amount of
this curvature is greatest at the minimum recommended projector
throw ratio of 1.4:1 and decreases as the projector is located
farther back from a given screen size. However, most content was
actually created with more internal geometric distortion than that from
an anamorphic lens. Once residual edge distortion is masked by the
edge of the screen the effect becomes quite unnoticeable. Note that at
least some residual geometric distortion can be reduced using Sony’s
Calibration Pro software available from both Sony or Panamorph.
LIMITED WARRANTY. Panamorph, Inc. warrants this product against
any change in performance or functionality for a period of twenty-four
months from our ship date. During this period, a unit may be repaired
or replaced, at the discretion of Panamorph, Inc., by returning it in its
original packaging with a copy of your receipt. This warranty does not
cover damage resultant from lack of prudent care, accident or misuse
(including use with other products in ways not intended); any cosmetic
damage not reported within 15 days of purchase; or any performance
change caused by the environment in which it is used. All damages are
limited to the cost of the product.
CLEANING. Small amounts of dust and wipe marks are very
noticeable on lens surfaces with a high brightness projection beam but
typically will not impact the image as much as damage from excessive
cleaning in pursuit of a "perfect" optical surface. Occasionally blowing
off the lens surfaces with clean air is the best way to keep long term
performance. If there is any excessive residue or build-up then it is
recommended that you clean the optics with professional lens cleaning
supplies such as from a camera store while the lens is in front of the lit
beam of the projector. This will allow you to quickly see if the cleaning
process is causing any damage.
VPL-VW ES (International: VPL-VW ES)915 790
VPL-VW ES (International: VPL-VW ES)885 760
For use only with the following projector models:Sony
IMPORTANT THEATER GUIDANCE
1. Projection screen should be , in the aspect ratio and with a flat 2.4:1
minimum 1.5″ border.
2. Projector should be horizontally centered on the screen +/- 3 inches
with minimal horizontal lens shift.
3. (throw distance divided by screen viewable width) Throw ratio
should be .at least 1.4:1
4. Projector should ideally be close to the top of the vertical position
screen with limits of up to 10% of screen height below to 30% of
screen height above for best performance. Beyond these limits may
prevent the beam from passing through the lens at low throw ratios.
DCR-S2 Instruction Guide Version 1.0
1
2
3
4
5
INSTALL THE DCR LENS RETAINER. Remove the two front
Phillips assembly screws from the lens/mount assembly and
remove the rear retainer (it comes loosely assembled).
Squeeze the retainer to fit into the projector lens opening and
then relax it so that it nests into the inner rim of the opening with the
prongs level and the gap downward.
Show a 2.4:1 movie. Set the Sony anamorphic lens menu setting to
1.24X and the Aspect mode to V-Stretch. Make sure the projector
lens is clean and as dust free as possible.
PREPARE THE PROJECTOR. Make sure the projector lens is
horizontally centered in its opening (ie little or no horizontal lens
shift). Adjust the projector roll, tilt and/or yaw so the projector
test pattern lines are square to the screen edges and the test
pattern is centered on the screen. Then ...
INSTALL THE DCR LENS. Remove the rear DCR lens cover.
Tilt the DCR lens/mount assembly to insert the bottom mount
tabs through the bottom retainer gap and behind the projector
housing rim. Then tilt the assembly back and over the retainer
prongs. Remove the front protective film; rotate the assembly so that
any visible edges of the movie appear the same on the left and right;
then insert and tighten the two assembly screws (do not over tighten).
ADJUST THE LENS TILT AND PROJECTOR SHIFT. Adjust
the projector lens zoom to fill the width of the screen with the
movie. Tilt the DCR lens in its mount and adjust the projector
vertical lens shift to make sure the beam is getting through the
DCR lens to fill the screen. There is only a slight variation in vertical
image height with this adjustment but experimentation may lead to the
best fit. Lock the DCR lens tilt by tightening the single Philips tilt lock
screw. As desired you may want to adjust any panel alignment in the
projector (see Sony projector instruction manual).
DECIDE HOW TO WATCH 16:9 CONTENT. The “classic”
mode to watch 16:9 content is to set the projector anamorphic
mode to However, Squeeze. V-Stretch Normal or 2.35:1 ,
Zoom will better fill the full cinema format screen with 16:9 with
various tradeoffs worth exploring. Note that menus are always created
in 16:9 so some type of switch from V-Stretch will be necessary to
show complete menu content.
DCR-S2 Installation Steps
Retainer nested into
projector lens opening
Assembly
screws
Tilt lock
screw
Produktspecifikationer
| Varumärke: | Panamorph |
| Kategori: | Beamer |
| Modell: | DCR-S2 |
Behöver du hjälp?
Om du behöver hjälp med Panamorph DCR-S2 ställ en fråga nedan och andra användare kommer att svara dig
Beamer Panamorph Manualer
26 September 2024
26 September 2024
Beamer Manualer
- Beamer Sony
- Beamer Samsung
- Beamer Casio
- Beamer LG
- Beamer HP
- Beamer Philips
- Beamer Panasonic
- Beamer Epson
- Beamer JVC
- Beamer Toshiba
- Beamer Canon
- Beamer Acer
- Beamer Aiptek
- Beamer Anker
- Beamer BenQ
- Beamer Sharp
- Beamer Klarstein
- Beamer Hitachi
- Beamer Pyle
- Beamer Livoo
- Beamer Asus
- Beamer Hisense
- Beamer Kodak
- Beamer RCA
- Beamer 3M
- Beamer Overmax
- Beamer GPX
- Beamer Blaupunkt
- Beamer Polaroid
- Beamer Yaber
- Beamer Salora
- Beamer Optoma
- Beamer ZTE
- Beamer Sanyo
- Beamer Mitsubishi
- Beamer Nec
- Beamer Easymaxx
- Beamer Oki
- Beamer Eiki
- Beamer Marantz
- Beamer Adj
- Beamer Barco
- Beamer Derksen
- Beamer Ricoh
- Beamer Dell
- Beamer InFocus
- Beamer Bauer
- Beamer Planar
- Beamer Nebula
- Beamer Viewsonic
- Beamer Technaxx
- Beamer D-Link
- Beamer Vivitek
- Beamer Eurolite
- Beamer Promethean
- Beamer Odys
- Beamer Stairville
- Beamer Laserworld
- Beamer Maxell
- Beamer Elmo
- Beamer Kogan
- Beamer EKO
- Beamer Celexon
- Beamer Prixton
- Beamer Christie
- Beamer PLUS
- Beamer Ultimea
- Beamer Touchjet
- Beamer Boxlight
- Beamer Miroir
- Beamer Vankyo
- Beamer Beghelli
- Beamer Mimio
- Beamer AWOL Vision
- Beamer Smart Tech
- Beamer Atlantis Land
- Beamer KickAss
- Beamer Microtek
- Beamer VAVA
Nyaste Beamer Manualer
26 Oktober 2024
24 Oktober 2024
24 Oktober 2024
22 Oktober 2024
22 Oktober 2024
22 Oktober 2024
21 Oktober 2024
21 Oktober 2024
21 Oktober 2024
21 Oktober 2024