Panduit WMPF1E-X Bruksanvisning

Läs nedan 📖 manual på svenska för Panduit WMPF1E-X (1 sidor) i kategorin Inte kategoriserad. Denna guide var användbar för 7 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Sida 1/1
© Panduit Corp. 2003
For Worldwide Subsidiaries
and Sales Offices visit
Web Site: www.panduit.com
INSTRUCTIONS CM282C
Technical Support Phone: 866-405-6654
Fax: 708-444-6993
E-mail: ncginfo@panduit.com
Page 1 of 1
Cable Capacity
Part Number UTP Cable
.187 dia.
SeTP Cable
.250 dia. Fiber
3mm dia.
Method 1
Method 1
Method 1
Method 2
Method 2
Method 2
WMP1E
WMPF1E
WMPFSE
WMPH2E
WMPHF2E
WMPLFSE
WMPLSE
WMPSE
96 72 312
72 48 192
48 32 144
24 16 72
32
16
24
12
96
48
Flange
The PatchLink cable manager is recommended for use with Panduit 24 or 48 port patch panels mounted above and below the manager.
When routing the cables for the patch panels, either of the following two methods are recommended to help maintain cable bend radius.
METHOD 1:For each row of 24 ports, place two cables in each slot on the manager.
Route half the cables through each of the wire retainers on the ends of the manager.
METHOD 2: If the cables are coming from one side of the rack, place 2 cables in each of the slots on the manager.
Wire
Retainer
Wire
Retainer
METHOD 1
METHOD 2
19” Rack
Screws
Finger
Finger
WMP1E (shown)
Cover
Part Numbers: WMP1E, WMPF1E,WMPFSE, WMPH2E, WMPHF2E, WMPLFSE,
WMPLSE, WMPSE
WMP1E
WMPF1E
WMPFSE
WMPH2E
WMPHF2E
WMPLFSE
WMPLSE
WMPSE
The hinged cover opens from the top or the
bottom. Pull flange to open and close cover.
P LATCH INK
Cable Management Horizontal Panels
Install the managers to the rack with the #12-24x.5 or M6 screws provided. Built-in
screw retention in mounting holes secures screws in manager during installation.
Install the covers to the manager by positioning cover flat against the front of the
manager fingers, then push to snap in place.
Note: The recommended assembly torque shall be 9+/-1 in-lb for #12-24 screws,
1+/-0.1 N-m for M6 screws.
NOTE: When using front and back WMPHs to manage cables on the rear of the rack, place 2 cables in each of the 12 slots in the rear of
the manager, for each row of 24 ports.

Produktspecifikationer

Varumärke: Panduit
Kategori: Inte kategoriserad
Modell: WMPF1E-X

Behöver du hjälp?

Om du behöver hjälp med Panduit WMPF1E-X ställ en fråga nedan och andra användare kommer att svara dig




Inte kategoriserad Panduit Manualer

Inte kategoriserad Manualer

Nyaste Inte kategoriserad Manualer