Poly-Planar MS-55 Bruksanvisning

Läs nedan 📖 manual på svenska för Poly-Planar MS-55 (4 sidor) i kategorin Subwoofer. Denna guide var användbar för 4 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Sida 1/4
1
POLY-PLANAR • PO Box 409 • Hanover, MD 21076
Tel: (410)761-4000 • Fax: (410) 761-6274 • www.polyplanar.com
MS-55 Compact Box Subwoofer
The MS-55 is a compact, waterproof subwoofer designed to work in
concert with poly-planar’s other marine speakers and amplifiers. It
provides the low-frequency audio that smaller speakers cannot produce.
The MS-55s small size allows it to be mounted in a variety of hidden
locations while providing rich, accurate bass.
Introduction
• Computer optimized acoustic design
• High efficiency, long-throw, dual voice coil driver
• Compact dimensions allow out of sight installation
• Rubber isolation feet for vibration free mounting
• Waterproof design for marine use
Features
2
POLY-PLANAR • PO Box 409 • Hanover, MD 21076
Tel: (410)761-4000 • Fax: (410) 761-6274 • www.polyplanar.com
1) Mount so that water will not collect in the enclosure.
2) To optimize output, point the grill end of the enclosure into a
corner.
3) The grill end should have at least 4 inches of clearance between the
grill and the corner it is pointing into.
4) Drill 1/8” (3mm) pilot holes in the mounting surface corresponding
to the 4 mounting flanges of the enclosure. Be sure not to drill into
any critical areas of your boat or vehicle.
5) Install the 4 rubber isolation grommets into the slots on the enclosure’s
mounting flanges. Fasten the subwoofer to the surface securely using
the 4 included tapping screws.
MS-55 Installation Instructions
The MS-55 can be mounted horizontally or vertically on any flat surface.
Since bass radiates uniformly in all directions, the MS-55 can be placed
in out of sight locations such as underneath seats or storage areas.
3
POLY-PLANAR • PO Box 409 • Hanover, MD 21076
Tel: (410)761-4000 • Fax: (410) 761-6274 • www.polyplanar.com
6) There are 4 wires coming out of the MS55. Each color pair of wires
goes to a 4 ohm voice coil of the speaker. Make sure the black striped
wires go to the negative speaker (-) outputs of the source amplifier.
Connection to the POLY-PLANAR ME-51 subwoofer amplifier:
Connection to the POLY-PLANAR MZ-100 amplifier:
Connection to the POLY-PLANAR ME-400 amplifier:
MS-55 Installation Instructions
To prevent damage to the
MS-55 when hooked up
to the high-power ME-
400 amplifier, connect the
speaker wires in a series
connection as shown.

Produktspecifikationer

Varumärke: Poly-Planar
Kategori: Subwoofer
Modell: MS-55

Behöver du hjälp?

Om du behöver hjälp med Poly-Planar MS-55 ställ en fråga nedan och andra användare kommer att svara dig




Subwoofer Poly-Planar Manualer

Subwoofer Manualer

Nyaste Subwoofer Manualer