Presto MyJo 02835 Bruksanvisning

Presto kaffebryggare MyJo 02835

Läs nedan 📖 manual på svenska för Presto MyJo 02835 (5 sidor) i kategorin kaffebryggare. Denna guide var användbar för 10 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/5

MyJo



single cup coffee maker

• The convenience of a single serve coffee maker without the high

cost.

• Compact design allows you to take it anywhere—home, work,

school, travel, or camping.

• Uses convenient K-Cup* packs and other commercially produced

single serve cups.

INSTRUCTIONS

Visit us on the web at www.GoPresto.com

2013 National Presto Industries, Inc.

Estas instrucciones también están disponibles en español.

Para obtener una copia impresa:

• Descargar en formato PDF en www.GoPresto.com/espanol.

• Envíe un mensaje de correo electrónico a contact@GoPresto.com.

• Llame al 1-800-877-0441, oprima 2 y deje un mensaje.

*“K-Cup” is a registered trademark of Keurig, Inc. Presto is not afliated with Keurig, Inc.

The following important safeguards are recommended by most portable appliance manufacturers.

IMPORTANT SAFEGUARDS

To reduce the risk of personal injury or property damage, when using this appliance, basic safety precautions should always be followed,

including the following:

1. Read all instructions.

2. Extreme caution must be used when handling a coffee maker containing hot liquid. Do not touch hot surfaces. Grasp the red

reservoir grip when handling the reservoir containing hot water.

3. To prevent the risk of injury, avoid contacting the needle in the cup holder.

4. Close supervision is necessary when any appliance is used by or near children.

5. Do not use in the event the coffee maker malfunctions or has been damaged in any manner.

6. The use of accessory attachments not recommended by the appliance manufacturer may damage the unit or cause injuries.

7. Use only water in your MyJo coffee maker. Do not ll with any other liquid.

8. Do not ll above the 10-ounce ll line.

9. Do not place on or near a hot gas or electric burner or in a heated oven.

10. Do not use appliance for other than intended use.

SAVE THESE INSTRUCTIONS

Fig. B

Cup

holder

Pump cap

Pump

Water

ll lines

Water

reservoir

Base

Fig. A

Reservoir

grip

Cup holder

Ridged

portion

Base ribs

Pump edge

BEFORE FIRST USE

1. Become familiar with the MyJo coffee maker parts (Fig. A) and read the following

information.

2. Unscrew the base from the reservoir. Then pull out the pump from the reservoir

and remove all contents from inside the reservoir.

3. Wash the coffee maker parts in warm, soapy water. Rinse thoroughly to remove

any soap residue.

Caution: There is a sharp needle in the cup holder which is designed to puncture

the single serve cup. To prevent injury, do not place ngers in the cup holder.

Do not wash the MyJo coffee maker in the dishwasher.

HOW TO USE

To prepare coffee or tea, follow the instructions below.

(To prepare hot cocoa and other beverages, refer to the instructions To Prepare Hot “

Cocoa and Other Beverages on page 3 before beginning.)”

The amount of water used with your MyJo

 coffee maker will determine the strength

of your coffee or tea. For the rst use, ll the water reservoir to the ll lines suggested

below:

• For normal strength coffee or tea, ll to the 8-ounce line with water.

• For stronger coffee or tea, ll to the 6-ounce line with water.

• For weaker coffee or tea, ll to the 10-ounce line with water.

For subsequent uses, adjust the strength, if necessary, by simply increasing or decreasing the amount of

water as desired.

Note: The ll line markings provide the necessary water to produce 6, 8, and 10 ounces of brewed coffee or tea.

1. Place a K-Cup* pack or other commercially produced single serve cup into the cup holder

(Fig. B). Press down rmly on the single serve cup until the bottom of the cup is punctured. Caution:

There is a sharp needle in the cup holder. To prevent injury, do not place ngers in the cup holder.

2. Heat the water and assemble the unit using one of the following methods:

(Note: The optimal brewing temperature for coffee is 195°F to 205°F. The optimal brewing temperature for tea will vary depending

on the type of tea you are preparing. A product like the Presto

 Heat ’n Steep electric kettle, which has a built-in thermometer, is an

ideal way to heat water to the correct brewing or steeping temperature. For information on ordering a Presto

 Heat ’n Steep kettle,

call the Presto Consumer Service Department at 1-800-877-0441.)

A. Microwave:

• Fill the water reservoir with the desired amount of water.

• Place the lled reservoir in the microwave. Be sure the base is not attached to the reservoir, as the base is not microwave safe.

Heat the water to the desired temperature.

Caution: When handling the reservoir containing hot water, always grasp the red grip as the other portions of the reservoir will

be very hot.

• Push the pump cap onto the top of the pump.

• Attach the pump to the reservoir. Insert the ridged portion of the pump into the reservoir, pressing around the pump edge until

the pump is attached rmly to the reservoir. Press only the pump edge. Do press the pump cap or pump.Important: not

• Grasp the red grip on the lled reservoir and place the reservoir onto the base. Screw on clockwise until tight.

B. Tea Kettle:

• Use an electric or stovetop tea kettle and heat water to the desired temperature.

• Attach the base to the reservoir prior to lling it with water. Screw the reservoir on clockwise until tight. Then, place the unit

on a dry, level surface and carefully ll the reservoir with the desired amount of heated water. Do not hold onto the Caution:

reservoir when pouring hot water into it.

• Push the pump cap onto the top of the pump.

*“K-Cup” is a registered trademark of Keurig, Inc. Presto is not afliated with Keurig, Inc.

Fig. C

Fig. D

Fig. E

Valve

Bottom of

reservoir

• Attach the pump to the reservoir. Insert the ridged portion of the pump into the reservoir, pressing around the pump edge until

the pump is attached rmly to the reservoir. Press only the pump edge. Do press the pump cap or pump.Important: not

3. Brew

• The MyJo coffee maker is designed to t on most coffee mugs. Verify that your mug is the right size

before pumping your coffee. The ribs on the bottom of the base should t within the inside rim of your

mug. (The diameter of the inner rim of the mug should be at least 2¼˝ but not more than 3¾˝ wide.)

You should also make sure you select a mug which is the appropriate size for the amount of coffee or

tea you are brewing.

• Place the assembled coffee maker over the selected coffee mug.

• Position the coffee maker and mug directly in front of you. Grasp the coffee maker base with one hand

and place the palm of your other hand on the pump cap (Fig. C). If using a tall travel mug, grasp the

top portion of the mug instead of the coffee maker base.

Note: Another method for pumping the water is by placing one hand over the other (Fig. D). However,

do not use this method when using tall mugs, such as travel mugs.

• Using the palm of your hand, gradually press down on the pump cap, keeping your hand down until

the coffee or tea ceases to ow. Release and allow the pump to return to the original position and press

down again. Repeat this process until all the water is expelled through the single serve cup and into

your coffee mug. You will hear a swoosh when all of the water has been expelled.

• Lift the coffee maker off the coffee mug and place the coffee maker on a plate or in the sink to catch

any residual drops.

• Enjoy your fresh brewed coffee or tea!

To Prepare Hot Cocoa and Other Beverages

When using your MyJo coffee maker to prepare other beverages, such as hot cocoa, cappuccino, or hot cider, BEFORE inserting the

K-Cup* pack/single serve cup into the holder, place the base over your mug. This will allow any powder residue to be contained in your

mug once the cup is punctured since these types of single serve beverages do not have a lter. For the rst use, ll the water reservoir to

the 6-ounce line. For subsequent uses, adjust the amount of water as desired.

CARE AND CLEANING

1. Unscrew the base from the reservoir. Turn the base over and use your nger to push the bottom of the used

K-Cup* pack/single serve cup out of the holder. Discard the cup. There is a sharp needle in the Caution:

cup holder. To prevent injury, do not place ngers in the cup holder.

2. Pull the pump off of the reservoir and wash the pump, reservoir, and base in warm, soapy water. Rinse and

dry.

Do not wash the MyJo coffee maker in the dishwasher.

3. There is a silicone valve located in the inside bottom of the reservoir. If you notice the valve contains coffee

grounds or residue, you should remove it for cleaning. The easiest way to do this is by gently poking the

valve at an angle from underneath the reservoir with a blunt object, such as a Q-tip* cotton swab (Fig. E)

or the eraser end of a pencil. (Note: There is a slit in the center of the valve so push gently on the outer edge

of the valve.) Wash the valve in warm, soapy water. Rinse and reposition the valve in the inside bottom of

the reservoir. Use the tip of your index nger or ngernail to press the outer edge tightly in the groove on the oor of the reservoir.

QUESTIONS AND ANSWERS (Troubleshooting)

Water is seeping out between the base and reservoir. What is happening?

You probably do not have the base screwed on tightly to the water reservoir. Tighten and rell the reservoir with water.

I notice water is leaking out of the reservoir when it’s not attached to the base. Why?

There are a couple of things that may be causing this:

• There is a silicone valve located in the inside bottom of the reservoir. The valve may not be seated properly. Use the tip of your

index nger or your ngernail to press around the edge of the valve so it ts snugly into the groove on the oor of the reservoir.

• The valve may be dirty. Remove the valve from the reservoir and clean it as instructed in step 3 of the “Care and Cleaning” section.

*“K-Cup” is a registered trademark of Keurig, Inc. “Q-tip” is a registered trademark of Conopco, Inc. Presto is not afliated with Keurig, Inc. or Conopco, Inc.