ProFlo PF1184WH Bruksanvisning
ProFlo
Tvättställ
PF1184WH
Läs nedan 📖 manual på svenska för ProFlo PF1184WH (6 sidor) i kategorin Tvättställ. Denna guide var användbar för 9 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare
Sida 1/6
© 2019 Wolseley Distributed Exclusively by Ferguson, Stock Building Supply and Wolseley Canada 0713 16540
Installation Instructions
PF1081WH
PF1181WH/PF1184WH
Pedestal Lavatory
Risk of personal injury or product damage.
Handle with care. Vitreous china can break or
chip if the product is handled carelessly.
CAUTION
Prior to installation, unpack the new lavatory and
inspect for damage. Return the lavatory to its
protective carton until you are ready to install it.
These instructions are for installing the lavatory to
wood frame construction. For other installations,
supply suitable bracing and fastening devices of
sufficient size and strength.
The walls and floor must be square, plumb, and
level.
Rough-in
Mark the centerline on the floor.
Position the pedestal on the floor centerline.
Carefully set the lavatory on the pedestal.
Move the pedestal as required to ensure proper fit
in the desired location.
Level the lavatory.
NOTE: The lavatory must be supported by the
pedestal.
Drill two 1/4" (6.4mm) hanger bolt holes at the
marks on the wall.
Mount hanger bolts to the wall so approximately
1-1/4" (3.2cm) of each bolt remains exposed.
NOTE: Other fastening devices of sufficient size
and strength may also be used.
Install the faucet and drain to the lavatory
according to the manufacturer’s instructions.
NOTE: Do not fully tighten slip-joint drain
connections at this time.
Check the lavatory placement.
Mark the center of each anchoring hole on the
wall.
Carefully remove the lavatory from the pedestal.
Then remove the pedestal from the area.
Installation
5-7/8"
(150mm)
Finished Floor
Note: Dimensions shown for location of
supplies and waste are suggested.
1-1/4" OD (32mm OD)
2-1/8" (54mm)
11-1/2"
(292mm)
13-1/2" (343mm)
31-1/4" (794mm)
8" (203mm)
Anchor Holes
in Lavatory
Finished Wall
8-1/2"
(216mm)
Tools and Materials
A. Level
B. Drill with assorted bits
C. 9/16˝ wrench
D. Tape measure
E. Framing Square
F. Channel lock pliers
BCE
D
F
A
Centerline
Pedestal
Lavatory
Finished Wall
Anchor Holes
in Lavatory
Hanger Bolts
Finished Wall
Hanger Bolts
Lavatory
Finished Wall
© 2019 Wolseley Distributed Exclusively by Ferguson, Stock Building Supply and Wolseley Canada 0713 16540
Installation Instructions
Pedestal Lavatory
1. WARRANTY:
Subject to the limitations expressed herein, Seller
warrants to the original Buyer that parts of
products manufactured by Seller (“Products)” shall
be free from defects in material and workmanship
during the original installation from the date of sale
for the duration set forth in the below table
(“Warranty Period”). This warranty is void for (a)
improper storage, use or installation, (b) accident,
damage, abuse or misuse, or (c) acts of God. This
warranty does not apply to damage caused by (a)
exposure to chemicals or minerals, (e) use of
abrasive cleaners, or (f) use of in-tank cleaners.
PRODUCT
PARTS
WARRANTY
PERIOD
Vitreous China Lifetime
2. REMEDIES:
If during the Warranty Period, Seller’s inspection of
Products confirms that any part is defective in
materials or workmanship, Seller shall, at its
option, repair, replace or refund the defective part.
Seller makes NO ADDITIONAL ALLOWANCE FOR
THE LABOR OR EXPENSE OF DE-INSTALLATION,
RE-INSTALLATION OR TRANSPORTATION COST
INCIDENTAL TO REPAIRING OR REPLACING THE
DEFECTIVE PART OR DAMAGE RESULTING FROM
SAME. SELLER HEREBY DISCLAIMS ALL OTHER
EXPRESSED OR IMPLIED WARRANTIES,
INCLUDING, WITHOUT LIMITATION, ALL IMPLIED
WARRANTIES OF MERCHANTABILITY AND FITNESS
OR FITNESS FOR A PARTICULAR PURPOSE AND
COMPLIANCE WITH LOCAL BUILDING CODES.
Seller may assist Buyer in selection decisions by
providing information regarding Products.
However, Buyer acknowledges that Buyer
ultimately chooses the product’s suitability for
Buyer’s use. Any recommendation made by Seller
concerning the use, design, application or
operation of the Products shall not be construed as
representations or warranties, expressed or
implied. Failure by Seller to make
recommendations or give advice to Buyer shall not
impose any liability upon Seller.
3. BUYER RESPONSIBILITIES:
Buyer must provide proof of purchase - save sales
receipt. Buyer must make claim within the
Warranty Period outlined above.
4. LIMITATION OF LIABILITY:
The warranty provided above is strictly limited to
its terms and is in lieu of all other warranties
expressed, implied and statutory. Buyer expressly
agrees that the sole and exclusive remedy for
breach of warranty shall be the remedies set forth
above. BUYER FURTHER SPECIFICALLY
UNDERSTANDS AND AGREES THAT, SELLER
DISCLAIMS AND WILL HAVE NO LIABILITY FOR
INCIDENTAL, PUNITIVE, SPECIAL OR
CONSEQUENTIAL DAMAGES ATTRIBUTED TO THE
PRODUCT DEFECT OR THE REPAIR OR EXCHANGE
OF DEFECTIVE PRODUCT. UNDER NO
CIRCUMSTANCES WILL SELLER BE LIABLE FOR
LOSS OF ANTICIPATED PROFITS.
Note: This warranty gives you specific rights.
Some states provide additional rights that vary
from state to state or province to province. This
warranty does not affect such statutory rights.
© 2019 Ferguson 10/19
Risk of product damage.
Do not overtighten the nuts. Overtightening may
cause damage to the product.
CAUTION
Risk of product damage.
Do not use strong abrasive cleaners, as they will
scratch and dull the surface.
CAUTION
Set the lavatory on the pedestal so the hanger
bolts extend through the lavatory holes.
Level the lavatory.
Install the nuts and washers, and tighten until snug.
Connect and tighten the trap. Connect the hot and
cold water supplies to the faucet.
To keep your lavatory looking new, make sure you
rinse it out thoroughly after each use.
Stubborn stains, paint, or tar can be removed with
turpentine or paint thinner.
Installation (continued)
Care and Cleaning
Level
Nut
Washer
CONTACT PROFLO CUSTOMER SERVICE AT 800-221-3379 OR EMAIL CUSTOMER SUPPORT:
SUPPORT@PROFLO.COM | WWW.PROFLO.COM
© 2019 Wolseley Distribué en exclusivité par Wolseley North American Division: Ferguson, Stock Building Supply et Wolseley Canada. 16540 0713
Instructions d’installation
Lavabo sur colonne
PF1081WH
PF1181WH/PF1184WH
Outils et matériels
A. Niveau
B. Perceuse avec mèches assorties
C. Clé de 9/16 po
D. Ruban à mesurer
E. Équerre de charpente
F. Pinces multiprises ordinaires
BCE
D
F
A
Risques de blessures ou de dommages matériels.
Manipulez avec soin. La porcelaine vitrifiée peut se
briser ou s’écailler si le produit n’est pas manipulé
avec précaution.
ATTENTION
Avant de procéder à l'installation, déballez votre
nouveau lavabo et examinez-le afin de vérifier s’il a
été endommagé. Replacez le lavabo dans la boîte de
carton protectrice jusqu’au moment de l’installation.
Ces instructions servent à installer le lavabo à une
charpente en bois. Pour les autres types d’installation,
vous devez vous procurer des dispositifs de
renforcement et de fixation adéquats, de taille et de
force suffisantes.
Les murs et le plancher doivent être droits, d'aplomb
et de niveau.
La plomberie brute
5-7/8"
(150mm)
Plancher ni
Note: Les dimensions présentées pour la localisation
des pièces et des déchets sont suggérées.
Diam. ext.
1-1/4" (32mm)
2-1/8" (54mm)
11-1/2"
(292mm)
13-1/2" (343mm)
31-1/4" (794mm)
8" (203mm)
Trous dans
le lavabo
Mur ni
8-1/2"
(216mm)
Percez deux trous de 6,4 mm (1/4 po) pour les
vis-boulons dans le mur, à l’endroit où vous avez
tracé les marques.
Installez les vis-boulons dans le mur de manière à
ce que chacun dépasse d’environ 3,2 cm (1-1/4 po).
REMARQUE : Il est également possible d’utilicer
d’autres disponsitifs de fixation de taille et de force
suffisantes.
Installez le robinet et l’orifice d’évacuation sur le
lavabo conformément aux instructions du fabricant.
REMARQUE : Ne serrez pas complètement les
raccords coulissants de l’orifice d’évacuation pour
le moment.
Installation
Vis-boulons
Mur ni
Vis-boulons
Lavabo
Mur ni
Tracez une ligne centrale sur le plancher.
Positionnez la colonne en l’alignant avec la ligne
centrale du plancher.
Installez soigneusement le lavabo sur la colonne.
Déplacez la colonne au besoin afin de vous assurer
que l’installation est appropriée à l’emplacement
désiré.
Mettez le lavabo de niveau.
REMARQUE : Le lavabo doit être soutenu par la
colonne.
Vérifiez l’emplacement d’installation du lavabo.
Marquez le centre de chaque trou d’ancrage sur le
mur.
Retirez soigneusement le lavabo de la colonne.
Retirez la colonne de l’emplacement où le lavabo
sera installé.
Ligne centrale
Colonne
Lavabo
Mur ni
Trous dans
le lavabo
Produktspecifikationer
Varumärke: | ProFlo |
Kategori: | Tvättställ |
Modell: | PF1184WH |
Behöver du hjälp?
Om du behöver hjälp med ProFlo PF1184WH ställ en fråga nedan och andra användare kommer att svara dig
Tvättställ ProFlo Manualer
28 December 2024
28 December 2024
28 December 2024
Tvättställ Manualer
- Tvättställ IKEA
- Tvättställ Bartscher
- Tvättställ Smeg
- Tvättställ Cata
- Tvättställ Kernau
- Tvättställ Miomare
- Tvättställ CDA
- Tvättställ Blanco
- Tvättställ Gustavsberg
- Tvättställ Franke
- Tvättställ Elkay
- Tvättställ ZLine
- Tvättställ Enza
- Tvättställ Lynx
- Tvättställ Alfi
- Tvättställ ARC
- Tvättställ Dxv
- Tvättställ Vigo
- Tvättställ Signature Hardware
- Tvättställ Rohl
- Tvättställ Thompson Traders
- Tvättställ Whitehaus
Nyaste Tvättställ Manualer
4 Januari 2025
4 Januari 2025
4 Januari 2025
3 Januari 2025
3 Januari 2025
3 Januari 2025
3 Januari 2025
3 Januari 2025
3 Januari 2025
3 Januari 2025