Pyle PLCM4LED Bruksanvisning

Pyle Backkamera PLCM4LED

Läs nedan 📖 manual på svenska för Pyle PLCM4LED (4 sidor) i kategorin Backkamera. Denna guide var användbar för 4 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/4



WARNING:Failureto thesereadandfollow  warnings andinstructionsmayresultinseriousinjury,includingdamaged

property,sopleasepay close and attention exhibittheutmostcare.



• is in potentiallyTheDigitalBackupCamera  designedasanaidtothedriver  detecting  hazardousdrivingconditions,

obstructions, properly.and drive andlargestationary objects.  You, thedriver,mustalsorememberto safely   Use ofthe

DigitalBackupCamera is not a substituteforsafe, practices.properandlegaldriving 



• screen.Neverbackupwhilelookingonlyatyourconnectedmonitordisplay Youshouldalwayscheckbehindand around 

the thevehiclewhenbackingupjustasyouwould vehicle if the didnothave DigitalBackupCamera.Alwaysmakesure

yourdrivingarea is clear.Alwaysbackupslowlyandwith caution.



• imageNeverdependontheBackupCameraentirelywhenbackingup.The onthemonitordisplayscreenmaybeslightly

differentfromactualandreal‐timeconditions.Objectsviewedintherearviewmonitordifferfromactual distances

because a is wide‐anglelens used.Sousethecameraasanaidandalwaysfollowintendeddrivingpracticestoproperly

judgedistancesfrom objects.



• is aTheBackupCamera'sassistedlowluxlightingperformancefeature alsoanaidto driver.Alwaysuseyourowneyes

to theconfirm  vehicle’s surroundings, displayed entirely visible.asthe  image maybenot notwell lit or   Alwaysproceed

with caution andperform beforedouble‐checks proceeding.



• isTheareadisplayedbytheBackupCamera  limited.Itdoesnotdisplayobjectsthatareclosetoorjustbelowthe

bumper, canunderneaththevehicle, objectsor outofthecamera’s view. The camera's view changeaccordingtoyour

vehicle'sorientationon ortheroad changing  road conditions.



• is isBesuretocheckthecamera  properlyfunctioning,  properlypositionedandsecurelymounted,everytimeyou

operate your vehicle.



• intended,Makesureyourtrunkorhatchoperatescorrectly,as beforeandafterinstallation.



•Proceedwithcautionwhencleaningyourvehiclearoundthe        camera. Avoid excess water exposure around the camera

especiallywithsprayingor a powerwasher.



•Pleasemakesuretokeepthecameracleanandunobstructedfromanydebris



•Followalltrafficlawsandmotorvehicleregulations.



•Consultlocallawsandregulationsforanyrestrictionsoninstallationoruse.



• a is a vehicle’sUsing BackupCameraSystem notadequateenoughtocompletelyeliminate  blindspot.Alwaysremember

todrivewithcaution,followingalltrafficlaws.

Pleaseread voidallofthe theinstallationinstructionscarefully installingbefore  product.Improperinstallationwill 

manufacturer’swarranty.Theinstallation vehicles, instructions donot allapplyto  typesof  andarewrittenas

guidelinestoassist an in installingthesystem.  Pleaseconsult  experienced comfortabletechnician if youarenot 

installing               the product.Prior to using and installing the Backup Camera System, please read the safety information

provided in this use product userusermanual.Besureto the asoutlined in this manual.Altercationormodifications

carriedoutwithoutappropriateauthorization invalidatemay the theuser'srighttooperate equipment.

SystemInstallationandWiring

Note: SystemCamera installation slightly install.ondieselvehicles may require a different wiring 



Quick Installation: 

Thisrearview system andbackupcamera comeswith camera  installationwiring.When installing, thecamera is preferably

to thebemounted in rearofyourvehicle(justabovethelicense plate).



Thiskit necessaryincludes wiringandcable connector accessoriessufficientfortypicalconnections.

However,additionalaccessorycablesand installation be for  materialsmay  necessary  completely

secureandoperationalbackup performance.camera



CameraConnection:

Connectthe the thecamerausing included powerDC12V cable.Connect DC12Vpowercableto the positive12Vreverse

taillightintherearofyourvehicle.Then, connect theblackwire,oftheDC12Vpower groundcable,and properly.This

connected connectspowerandgroundcablethen            to the camera, and will supply power to the camera directly.

Next,usethe theincludedyellowRCA video  connector cable, cableandrunthat from yellowRCA video  connector jackof

the thecamera,to yellowvideoconnectorofyourcompatibledisplay monitor 

TheyellowRCA iscablewhenconnected, yourautomatically activatedretrievesthevideosignalwhen (when vehicle switchedintothereversegear).



Installation Transcript: 



1. yourLocatethereversetaillightwiringbehind vehicle's light. panel,reverse Youmayneedtoremove an interior orothercover,in

orderto Connectlocatethewiring. theincludedpower power12VDC cabletothereverselight.

    a. Connect the power cable's     Red wire to your vehicle's reverselightpositivewire.

             b. Connect the power cable's Black wire to your vehicle's reverse light negative wire.



2.Connectthecamerato connection mountthis'reverselight' installation,then thecamerainthedesired location.



3.RuntheRCAvideocablefromthecamera compatibletoyour videodisplaymonitor.



*Please cablesremembertorun  intheleastobtrusiveroutepossible.  Vehiclevibrationsandbumpydrivingconditionscan

                    result, so extra care should be taken to securely mount the camera and fasten all cables and wiring to secure locations.



*Ensurethewiresaresafelyandsecurelyconnected,withproperisolation    applied to all connections.



AdditionalNotes:

‐Determine             the best location for the camera (The camera is preferably mounted just above thelicenseplate).

‐Be sure when             running the connection cables to leave a small amount of slack so you can    still move the camera around

 the licenseplate, if youdecidetoslightly        adjust the camera's positioning at a later time.

‐After installation, Test                the camera before use. Placing your vehicle in reverse should provide a picture in the monitor

    within the rearview mirror assembly.

Caution: youConnectingtoothertypesofelectricalsystemswillcausedamagetoyourvehicle.Pleasecontactthemanufacturerif  are

unawareof installation.the thesystemtypeinyourvehicle.Referto model'spower requirements priortoconnectionand 

Produktspecifikationer

Varumärke:	Pyle
Kategori:	Backkamera
Modell:	PLCM4LED
Vikt:	318 g
Förpackningens vikt:	704 g
Förpackningens bredd:	161 mm
Djuppackning:	170 mm
Förpackningshöjd:	94 mm
Användarmanual:	Ja
LED-indikatorer:	Activity, Power
På / Av knapp:	Ja
Medföljande kablar:	USB
Inkluderar AC-adapter:	Ja
Inbyggd fläkt:	Nee
Förpackningsmått (BxDxH):	92 x 160 x 170 mm
Anslutning för nätadapter:	Ja
Typ av lagringsmedia:	HDD, SSD
Hållbarhetscertifikat:	CE, RoHS
Plug and play:	Ja
Förvaringstemperatur:	-20 - 50 °C
Överensstämmelse med hållbarhet:	Ja
Spännande:	12 V
Värdgränssnitt:	USB 3.2 Gen 1 (3.1 Gen 1) Type-B
Standardgränssnitt:	USB 3.2 Gen 1 (3.1 Gen 1)
Max. överföringshastighet:	6 Gbit/s
Gränssnitt för lagringsdisk:	Serial ATA, Serial ATA II, Serial ATA III
Chipset:	ASMedia - ASM1053 - 6G
(Ytter) huvudpaketets höjd:	387 mm
(Ytter) huvudförpackningens bredd:	187 mm
(Ytre) huvudpaketets längd:	476 mm
Kvantitet per (yttre) huvudkartong:	10 stuk(s)
Antal USB 3.2 Gen 1 (3.1 Gen 1)-portar:	1
Antal lagringsenheter som stöds:	1
Storlekar för lagringsenheter stöds:	2.5, 3.5 "
AC-ingångsspänning:	100-240 V
Drifttemperatur (TT):	5 - 35 °C
Relativ luftfuktighet i drift (VV):	20 - 80 procent
Harmoniserad systemkod (HS):	84733080
Inkluderade typer av nätkontakter:	EU, NA, UK
UASP-stöd:	Ja