Rotel RSX-1056 Bruksanvisning

Rotel mottagare RSX-1056

Läs nedan 📖 manual på svenska för Rotel RSX-1056 (46 sidor) i kategorin mottagare. Denna guide var användbar för 13 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF
Sida 1/46
Owner’s manual
RSX-1056
Surround Sound Receiver
2CH
DOLBY
PLII/3ST
DTS
Neo 6 DSP
MULTI
INPUT MUTE RECZONE
CD TUNER TAPE1
SURROUND SOUND RECEIVER RSX-1056
STANDBY
VIDEO1 VIDEO2 VIDEO3 VIDEO5VIDEO4
6 7 8 9 0 DIRECT MEMORYMONO
12345 TUNING
VOLUME
BAND
> 10 cm
> 4 in
> 10 cm
> 4 in
> 10 cm
> 4 in
> 10 cm > 4 in
2CH
DOLBY
PLII/3ST
DTS
Neo 6 DSP
MULTI
INPUT MUTE RECZONE
CD TUNER TAPE1
SURROUND SOUND RECEIVER RSX-1056
STANDBY
VIDEO1 VIDEO2 VIDEO3 VIDEO5VIDEO4
6 7 8 9 0 DIRECT MEMORYMONO
12345 TUNING
VOLUME
BAND
Notice
The COMPUTER I/O connection should be handled by authorized person
only.
FCC Information
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses and can radi-
ate radio frequency energy and, if not installed and used in accordance
with the instruction, may cause harmful interference to radio communica-
tions.
However, there is no guarantee that interference will not occur in a particu-
lar installation. If this equipment does cause harmful interference to radio
or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.(TV, radio, etc.)
• Increase the separation between the equipment and receiver
• Connect the equipment to an outlet on circuit different from that to which
the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for additional
help.
Caution
This device complies with part 15 of the FCC Rules operation is subject to
the following to conditions: (1) This device may not cause harmful interfer-
ence, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
NOTE TO CATV SYSTEM INSTALLER: Call the CATV system or antenna
installer’s attention to Article 820-40 of the NEC. This provides guidelines
for proper grounding and, in particular, specifies that the cable ground
shall be connected to the grounding system of the building, as close to the
point of cable entry as practical. See installation diagram.
NOTE: This equipment has been tested and found to comply with the lim-
its for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against interference
in a residential installation. This equipment generates and can radiate ra-
dio frequency energy and, if not installed and used in accordance with the
instructions, may cause interference to radio or TV communications. There
is no guarantee that interference will not occur in a particular installation.
If this equipment does cause interference to radio or television reception,
which can be determined by turning the equipment off and on, try to cor-
rect the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the unit and the television tuner.
• Connect the unit to an AC power outlet on a different electrical circuit.
• Consult your authorized Rotel retailer for assistance.
Important Safety Instructions
WARNING: There are no user serviceable parts inside. Refer all servic-
ing to qualified service personnel.
WARNING: To reduce the risk of fire or electric shock, do not expose the
unit to moisture or water. Do not allow foreign objects to get into the enclo-
sure. If the unit is exposed to moisture, or a foreign object gets into the
enclosure, immediately disconnect the power cord from the wall. Take the
unit to a qualified service person for inspection and necessary repairs.
Read all the instructions before connecting or operating the component.
Keep this manual so you can refer to these safety instructions.
Heed all warnings and safety information in these instructions and on the
product itself. Follow all operating instructions.
Clean the enclosure only with a dry cloth or a vacuum cleaner.
Do not use this unit near water.
You must allow a minimum 10 cm or 4 inches of unobstructed
clearance around the unit. Do not place the unit on a bed, sofa, rug,
or similar surface that could block the ventilation openings. If the unit is
placed in a bookcase or cabinet, there must be ventilation of the cabinet to
allow proper cooling.
Keep the component away from radiators, heat registers, stoves, or any
other appliance that produces heat.
The unit must be connected to a power supply only of the type and voltage
specified on the rear panel. (USA: 115 V/60Hz, EC: 230V/50Hz)
Connect the component to the power outlet only with the supplied power
supply cable or an exact equivalent. Do not modify the supplied cable. Do
not A polarized plug has two blades, with one wider than the other. A
grounding plug has two blades plus a third grounding prong. These are
provided for your safety. Do not defeat grounding and/or polarization safety
provisions. If the supplied plug does not fit your outlet, please consult an
electrician for replacement of the obsolete outlet. Do not use extension cords.
The main plug of the power cordset is a disconnect device of the appara-
tus. In order to completely disconnect the apparatus from the supply mains,
the main plug of the power cordset should be unplugged from the mains
(AC) outlet. The stand-by LED indicator will not be lit up to show the power
cord is unplugged.
Do not route the power cord where it will be crushed, pinched, bent, ex-
posed to heat, or damaged in any way. Pay particular attention to the power
cord at the plug and where the cord exits the back of the unit.
The power cord should be unplugged from the wall outlet during a light-
ning storm or if the unit is to be left unused for a long period of time.
Use only accessories specified by the manufacturer.
Use only with a cart, stand, rack, bracket or shelf system recommended by
Rotel. Use caution when moving the unit in a stand or rack to avoid injury
from a tip-over.
Immediately stop using the component and have it inspected and/or ser-
viced by a qualified service agency if:
• The power supply cord or plug has been damaged.
• Objects have fallen or liquid has been spilled into the unit.
• The unit has been exposed to rain.
• The unit shows signs of improper operation
• The unit has been dropped or damaged in any way

Produktspecifikationer

Varumärke: Rotel
Kategori: mottagare
Modell: RSX-1056

Behöver du hjälp?

Om du behöver hjälp med Rotel RSX-1056 ställ en fråga nedan och andra användare kommer att svara dig


mottagare Rotel Manualer

Rotel

Rotel RA‑1592MKII Bruksanvisning

16 Oktober 2024
Rotel

Rotel A8 Bruksanvisning

27 September 2024
Rotel

Rotel RC-1590MKII Bruksanvisning

24 September 2024
Rotel

Rotel RA-1572MKII Bruksanvisning

24 September 2024
Rotel

Rotel A10 Bruksanvisning

19 September 2024
Rotel

Rotel RAS-5000 Bruksanvisning

16 September 2024
Rotel

Rotel A11MKII Bruksanvisning

11 September 2024
Rotel

Rotel A10MKII Bruksanvisning

11 September 2024
Rotel

Rotel RA-921 Bruksanvisning

5 September 2024
Rotel

Rotel RC-995 Bruksanvisning

4 September 2024

mottagare Manualer

Nyaste mottagare Manualer

Alto

Alto D1 Bruksanvisning

16 Januari 2025
Alto

Alto MC700.4 Bruksanvisning

16 Januari 2025
Alto

Alto MC250.4 Bruksanvisning

16 Januari 2025
Alto

Alto MC250.8 Bruksanvisning

16 Januari 2025
Alto

Alto D4 Bruksanvisning

16 Januari 2025
Alto

Alto D3 Bruksanvisning

16 Januari 2025
Alto

Alto MC500.4 Bruksanvisning

16 Januari 2025
S.M.S.L

S.M.S.L PA200 Bruksanvisning

15 Januari 2025
Peavey

Peavey CKd 608 Bruksanvisning

15 Januari 2025
Wavtech

Wavtech link700.4plus Bruksanvisning

14 Januari 2025