Scholtes SDLE 129 (EU) Bruksanvisning

Scholtes tvättmaskin SDLE 129 (EU)

Läs nedan 📖 manual på svenska för Scholtes SDLE 129 (EU) (56 sidor) i kategorin tvättmaskin. Denna guide var användbar för 6 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/56

English,1 Contents

Installation, 2-3-4-5

Unpacking and levelling

Connecting the electricity and water supplies

The first wash cycle

Technical data

Instructions for the fitter

Care and maintenance, 6

Cutting off the water or electricity supply

Cleaning the washer dryer

Cleaning the detergent dispenser drawer

Caring for the door and drum of your appliance

Cleaning the pump

Checking the water inlet hose

Precautions and tips, 7

General safety

Disposal

Opening the porthole door manually

Description of the washer dryer, 8-9

Control panel

Display

How to run a wash cycle or a drying cycle, 10

Wash cycles and functions, 11

Table of wash cycles

Wash functions

Detergents and laundry, 12

Detergent dispenser drawer

Preparing the laundry

Special wash cycles

Load balancing system

Troubleshooting, 13

Service, 14

SDLE 129

Instructions for use

WASHER DRYER

Español,29Français,15

Italiano,43

! This symbol reminds you to read this instruction manual.

Installation

! This instruction manual should be kept in a safe

place for future reference. If the washer dryer is

sold, transferred or moved, make sure that the

instruction manual remains with the machine so

that the new owner is able to familiarise himself/

herself with its operation and features.

! Read these instructions carefully: they contain

vital information relating to the safe installation

and operation of the appliance.

Unpacking and levelling

Unpacking

1. Remove the washer dryer from its packaging.

2. Make sure that the washer dryer has not been

damaged during the transportation process. If it

has been damaged, contact the retailer and do not

proceed any further with the installation process.

3. Remove the pro-4

tective screws (used

during transportation)

and the rubber washer

with the corresponding

spacer, located on the

rear part of the applian-

ce ( ).see figure

4. Close off the holes using the plastic plugs

provided.

5. Keep all the parts in a safe place: you will

need them again if the washer dryer needs to

be moved to another location.

! Packaging materials should not be used as

toys for children.

Levelling

1. Install the washer dryer on a flat sturdy floor,

without resting it up against walls, furniture ca-

binets or anything else.

2. If the floor is not per-

fectly level, compensa-

te for any unevenness

by tightening or loo-

sening the adjustable

front feet ( ); see figure

the angle of inclination,

measured in relation to

the worktop, must not

exceed 2°.

Levelling the machine correctly will provide it with

stability, help to avoid vibrations and excessive

noise and prevent it from shifting while it is ope-

rating. If it is placed on carpet or a rug, adjust

the feet in such a way as to allow a sufficient

ventilation space underneath the washer dryer.

Connecting the electricity and wa-

ter supplies

Connecting the water inlet hose

1. Connect the supply

pipe by screwing it to

a cold water tab using

a ¾ gas threaded con-

nection (see figure).

Before performing the

connection, allow the

water to run freely until

it is perfectly clear.

2. Connect the inlet

hose to the washer dr-

yer by screwing it onto

the corresponding wa-

ter inlet of the applian-

ce, which is situated on

the top right-hand side

of the rear part of the

appliance . (see figure)

3. Make sure that the hose is not folded over

or bent.

! The water pressure at the tap must fall within

the values indicated in the Technical details table

(see next page).

! If the inlet hose is not long enough, contact a

specialised shop or an authorised technician.

! Never use second-hand hoses.

! Use the ones supplied with the machine.

65 - 100 cm

Connecting the drain hose

Connect the drain

hose, without bending

it, to a drainage duct or

a wall drain located at a

height between 65 and

100 cm from the floor;

alternatively, rest it on

the side of a washba-

sin or bathtub, faste-

ning the duct supplied

to the tap (see figure).

The free end of the

hose should not be

underwater.

! We advise against the use of hose extensions;

if it is absolutely necessary, the extension must

have the same diameter as the original hose and

must not exceed 150 cm in length.

Electrical connections

Before plugging the appliance into the electricity

socket, make sure that:

• the socket is earthed and complies with all

applicable laws;

• the socket is able to withstand the maximum

power load of the appliance as indicated in the

Technical data table (see opposite);

• the power supply voltage falls within the values

indicated in the Technical data table (see opposite);

• the socket is compatible with the plug of the

washer dryer. If this is not the case, replace the

socket or the plug.

! The washer dryer must not be installed ou-

tdoors, even in covered areas. It is extremely

dangerous to leave the appliance exposed to

rain, storms and other weather conditions.

! When the washer dryer has been installed, the

electricity socket must be within easy reach.

! Do not use extension cords or multiple sockets.

! The cable should not be bent or compressed.

! The power supply cable must only be replaced

by authorised technicians.

Warning! The company shall not be held responsible

in the event that these regulations are not respected.

The first wash cycle

Once the appliance has been installed, and before

you use it for the first time, run a wash cycle with

detergent and no laundry, using the wash cycle .

Technical data

Model SDLE 129

Dimensions width 59,5 cm

height 81,5 cm

depth 54,5 cm

Capacity

from 1 to 7 kg for the wash

programme

from 1 to 5 kg for the drying

programme

Electrical

connections

please refer to the technical

data plate fixed to the ma-

chine

Water con-

nections

maximum pressure 1 MPa

(10 bar)

minimum pressure 0.05

MPa (0.5 bar)

drum capacity 52 litres

Spin speed up to 1200 rotations per

minute

Energy ra-

ted

programmes

according to

regulation

EN 50229

Wash: programme ;

temperature 60°C (1st press

of the button); using a load of

7 kg.

Drying: the smaller load

must be dried by selecting

the “IRON DRY” dryness le-

vel. The load must consist of

2 sheets, 1 pillowcase and 1

hand towel;

the remainder of the load

must be dried by selecting

the “CUPBOARD DRY” dry-

ness level.

This appliance conforms to

the following EC Directives:

- 2004/108/EC (Electromagne-

tic Compatibility)

- 2006/95/EC (Low Voltage)

- 2002/96/EC

Produktspecifikationer

Varumärke:	Scholtes
Kategori:	tvättmaskin
Modell:	SDLE 129 (EU)

Behöver du hjälp?

Om du behöver hjälp med Scholtes SDLE 129 (EU) ställ en fråga nedan och andra användare kommer att svara dig

Ditt namn*

Din e-post*

Skriv din fråga här

tvättmaskin Scholtes Manualer

Scholtes SDLE 129 (EU) Bruksanvisning

5 September 2024

Scholtes SDLE 129 Bruksanvisning

22 Augusti 2024

Scholtes SMLE 129 Bruksanvisning

17 Augusti 2024

tvättmaskin Manualer

Nyaste tvättmaskin Manualer

Whirlpool FFWDD 107448 BSV EE Bruksanvisning

25 Mars 2025

Whirlpool WPM 911W ADS SPT Bruksanvisning

25 Mars 2025

Bauknecht B6R 08 SILENCE DE Bruksanvisning

22 Mars 2025

Vedette LFV404QW Bruksanvisning

18 Mars 2025

Toshiba AW-T08DUH1800MMMG Bruksanvisning

18 Mars 2025

Toshiba DW-15F5SS-NZ Bruksanvisning

18 Mars 2025

BEKO B3WF T 5124111 W Bruksanvisning

14 Mars 2025

Privileg 42N Slimline (026.882) Bruksanvisning

13 Mars 2025

Bosch WGH244M40 Bruksanvisning

13 Mars 2025

Insignia NS-WMT41WA5 Bruksanvisning

12 Mars 2025