Smartwares Byron DIC-23112 Bruksanvisning

Smartwares Dörrklocka Byron DIC-23112

Läs nedan 📖 manual på svenska för Smartwares Byron DIC-23112 (23 sidor) i kategorin Dörrklocka. Denna guide var användbar för 10 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Sida 1/23
DIC-23112
MANUAL
Installation
We recommend for the Wi Fi doorbell to be set up indoors and tested before final fitting.- -
Please follow the steps included in this guide to get the product up and running.
Doorbell setup
To use the recording feature, it is recommended to install the SD card before installation. This can be
done later but will involve removing and -re fitting some cables.
1. Remove the 3x securing screws located on the back of the doorbell and also remove the
rubber seal.
2. Slide the doorbell up and out of the aluminium case.
3. On the side of the doorbell is the SD card slot. Remove the rubber seal and insert the SD
card, then push the rubber seal back into place.
4. Slide the doorbell back into its aluminium case and replace the 3x securing screws.
5. Push the power cable through the hole of the rubber seal.
6. Connect the power cable to the V+ and connections at the back of the doorbell. V-
7. terminal. Connect the red wire to the V+ terminal. Connect the black wire to the V-
Don’t replace rubber seal yet. Plug in the power supply and connect it to the power cable, then
switch the socket on.
8. After around 30 seconds, the red and green LED’s will begin to light up on the back
9. of the doorbell. If this does not happen, please ensure the power cable and the power supply
are all connected correctly and the plug socket is turned on. Push the rubber seal back into
place

Produktspecifikationer

Varumärke: Smartwares
Kategori: Dörrklocka
Modell: Byron DIC-23112

Behöver du hjälp?

Om du behöver hjälp med Smartwares Byron DIC-23112 ställ en fråga nedan och andra användare kommer att svara dig




Dörrklocka Smartwares Manualer

Dörrklocka Manualer

Nyaste Dörrklocka Manualer