Svan SVCA420LA Bruksanvisning

Svan Värmare SVCA420LA

Läs nedan 📖 manual på svenska för Svan SVCA420LA (10 sidor) i kategorin Värmare. Denna guide var användbar för 7 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Sida 1/10
Energy eciency classes: A (A++ <> G)
GAS HEATER - SVCA420LA
Instruction Manual
Important note:
Instructions for placing the reducer in the gas bottle can be found inside.
2
You have just acquired a mobile heater, whose technical characteristics are indicated on
the Characteristics Plate axed to the appliance and
shown in the table below.
Technical Data Heater
SVCA420LA
Destiny Country
Europe
Type of Gas and
Pressure
Butane, 30mbar
Gas Category
I3B
Potency
4,2 kW (Hs)
Consumption in Max
position
0,305 kg/h
Your device is designed to work with "commercial butane" - one of the best-known gases in
Liqueed Petroleum Gases - stored in bottles.
To place the gas bottle, proceed as follows:
Its connection or cylinder exchange must always be carried out far from any ame or
source of ignition.
Before placing the gas bottle in the mobile heater compartment, t the reducer to the
cylinder valve following the installation and safety instructions below:
To place the reducer in the bottle (Fig. 1 and Fig. 2):
1. Check that your heater control knob is in the START (0)
position
2. Conrm that the handle is facing up (fig. 1)
3. Whenever you buy a new bottle, remove the security seal,
opening it by the perforation.
4. Grasp the reducer with both hands. Pull the plastic ring down
with your ngers and insert it into the bottle valve (g. 1)
5. Push the plastic ring down with your thumbs until you hear a
click, a sign that the reducer is properly connected (g. 2)
READ THE INSTRUCTIONS CAREFULLY BEFORE PUTTING THE APPLIANCE INTO OPERATION
This appliance complies with
the provisions of regulation
2016/426/EU on the
approximation of the
legislation of member states
on gas appliances. The
devices were thoroughly
tested before being packaged.
3
Opening and closing the gas (Fig. 3 and Fig. 4):
1. To open the gas, turn the gear reducer lever counterclockwise
to the OPEN position.
2. To turn o the gas, turn the gear reducer lever clockwise to
the CLOSED position - you will hear a click.
To remove the reducer from the bottle:
1. Close the valve on the device.
2. Place the gear reducer tab in the CLOSED position (g. 4)
3. Check that the burner and/or pilot are extinguished.
4. Grasp the reducer with both hands. With your ngertips, pull the plastic ring upwards.
Remove reducer from valve.
Whenever you change the bottle, follow the procedure of removing and putting the reducer from
the bottle.
Whenever changing bottles, be aware of possible leaks. They are detected by the characteristic
smell. If possible, check the connections with soap suds.
To place the bottle inside the heater:
Once the reducer has been properly tted, place the bottle in the compartment provided for this
purpose in your mobile heater. Avoid bending the hose.
Regulatory conditions for installation
The current European Regulation recommends that the minimum dimension of the room where
the appliance is placed should not be less than 60m3 for living rooms and 30m3 for other types
of rooms, and should not be used in high-rise apartments, attics, bathrooms, bedrooms and
basements.
Only use this heater in places where there is sucient air circulation. To ensure optimal air
circulation, there must be two ventilation openings of at least 25 cm2 per kX/h of heat (minimum
105 cm2 opening - 1/2 at the top and 1/2 at the bottom of the room).
Do not use in vehicles such as caravans or motorhomes.
Objects that may cause re should not be placed on the device (special care with curtains,
fabrics, papers, inammable materials, etc...)

Produktspecifikationer

Varumärke: Svan
Kategori: Värmare
Modell: SVCA420LA

Behöver du hjälp?

Om du behöver hjälp med Svan SVCA420LA ställ en fråga nedan och andra användare kommer att svara dig




Värmare Svan Manualer

Värmare Manualer

Nyaste Värmare Manualer