Boss Angry Driver JB-2 Bruksanvisning
Läs nedan 📖 manual på svenska för Boss Angry Driver JB-2 (1 sidor) i kategorin Gitarr. Denna guide var användbar för 3 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare
Sida 1/1
AC Adaptor
(PSA series; sold separately)
Electric Guitar
English
LEVEL knobs
These adjust the volume of the eect sound. Clockwise rotation raises the volume
and counterclockwise rotation decreases.
The JB-2 is a distortion pedal cooperatively developed by JHS PEDALS and BOSS.
7It is equipped with two completely independent distortion eects designed respectively by JHS PEDALS and BOSS.
7By switching modes, you can use the JHS PEDALS and BOSS sounds individually, or use them together in series (with your choice of connection order) or parallel to create a wide variety of rock sounds.
7If you connect a footswitch to the REMOTE jack, you can use it in conjunction with the pedal switch for additional options, such as switching between distortions or turning the eect on/o.
OUTPUT jack
Connect an amplier to this jack.
DC IN jack
Accepts connection of an AC Adaptor (PSA series; sold separately). By using an AC Adaptor, you can play
without being concerned about how much battery power you have left.
* We recommend that you keep batteries installed in the unit even though you’ll be powering it with
the AC adaptor. That way, you’ll be able to continue a performance even if the cord of the AC adaptor
gets accidentally disconnected from the unit.
* Use only the specied AC adaptor (PSA-series).
* If the AC adaptor is connected while power is on, the power supply is drawn
from the AC adaptor.
CHECK indicator
This indicator shows whether an eect is ON/OFF, and doubles as the Battery Check indicator.
The indicator lights when an eect is ON. The indicator also shows which eect is active: JHS
PEDALS and/or BOSS.
Indicator color Eect type
Red JHS PEDALS
Blue BOSS
Purple Both JHS PEDALS and BOSS
* If this indicator goes dim or no longer lights while an eect is ON, the battery is near
exhaustion and should be replaced immediately.
TONE knobs
These adjust the tone of the eect sound. As you rotate the knob clockwise,
higher frequencies are emphasized, and counterclockwise cuts them.
Pedal switch
This switch turns the eect on/o or switches between the two types of
distortion.
* The operation that occurs when you press the pedal depends on the mode.
For details, refer to “Operation at a Glance.”
Thumbscrew
When this screw is loosened, the pedal will open, allowing you to change the
battery.
* For instructions on changing the battery, refer to “Changing the Battery.”
Panel Descriptions
Main Features
MODE knob
This switch switches between modes (JHS, BOSS, JHS/BOSS, J J, PARALLEL).AB, BA
For details, refer to “Mode List.”
DRIVE knobs
These adjust the depth of the distortion eect. Rotating the knob clockwise
deepens the distortion creating powerful distortion eect.
Rotating the knob counterclockwise makes lighter distortion.
IMPORTANT NOTES
5 Some settings might cause the JB-2 to oscillate or might result in
increased noise, but this is not a malfunction.
5
To prevent malfunction and equipment failure, always turn down the
volume, and turn o all the units before making any connections.
5 Once everything is properly connected, be sure to follow the
procedure below to turn on their power. If you turn on equipment in
the wrong order, you risk causing malfunction or equipment failure.
When powering up: Turn on the power to your guitar amp last.
When powering down: Turn o the power to your guitar amp rst.
5 Before turning the unit on/o, always be sure to turn the volume
down. Even with the volume turned down, you might hear some
sound when switching the unit on/o. However, this is normal and
does not indicate a malfunction.
5 If operating this unit on batteries, please use alkaline or carbon
battery.
5 When operating on battery power only, the unit’s indicator will
become dim when battery power gets too low. Replace the
battery as soon as possible.
5 If you handle batteries improperly, you risk explosion and uid
leakage. Make sure that you carefully observe all of the items
related to batteries that are listed in “USING THE UNIT SAFELY” and
“IMPORTANT NOTES” (supplied on a separate sheet).
Changing the Battery
1. Hold down
the pedal and
loosen the
thumbscrew,
then open the
pedal upward.
* The pedal can be
opened without
detaching the
thumbscrew
completely.
2. Remove the
old battery from the battery housing, and remove the
snap cord connected to it.
3. Connect the snap cord to the new battery, and place
the battery inside the battery housing.
* Be sure to carefully observe the battery’s polarity (+ versus -).
4. Slip the coil spring onto the spring base on the back of
the pedal, and then close the pedal.
* Carefully avoid getting the snap cord caught in the pedal, coil
spring, and battery housing.
5. Finally, insert the thumbscrew into the guide bush
hole and fasten it securely.
MODE List
Use the MODE knob to select the eect you want.
MODE Explanation
JHS A high-gain distortion with a design based on the “Angry
Charlie” made by JHS PEDALS.
It’s a classic sound with a distinctively rich low-frequency
range and thick mids.
BOSS An overdrive with a design based on the BOSS “BD-2”
Blues Driver.
It’s noted for a broad range of expression that responds
to your guitar volume and picking dynamics. With a
broad range of gain variation, you can create a wide
variety of sounds from crunch to hard rock.
JHS/BOSS Switch between the “JHS” and “BOSS” eects.
JAB (*1) Series connection in the order of “JHS”
0 “BOSS.”
BAJ (*1) Series connection in the order of “BOSS”
0 “JHS.”
PARALLEL (*1) “JHS” and “BOSS” circuits connected in parallel.
(*1) Both JHS PEDALS and BOSS are on.
Operation at a Glance
This table shows the operations of the pedal switch and of a
footswitch connected to the REMOTE jack.
MODE Pedal switch Footswitch
JHS Eect ON/OFF Switch between JHS/BOSS
BOSS
JHS/BOSS Switch between JHS/BOSS Eect ON/OFF
JAB
Eect ON/OFF
JHS ON/OFF
BAJBOSS ON/OFF
PARALLEL
Main Specications
Nominal Input Level -20 dBu
Input Impedance 1 MΩ
Nominal Output Level -20 dBu
Output Impedance 1 kΩ
Recommended Load
Impedance
10 kΩ or greater
Power Supply Alkaline battery (9 V, 6LR61) or
Carbon-zinc battery (9 V, 6F22)
AC adaptor (sold separately)
Current Draw 55 mA
* Expected battery life under continuous use:
Alkaline: Approx. 7 hours
Carbon: Approx. 2.5 hours
These gures will vary depending on the
actual conditions of use.
Dimensions 73 (W) x 129 (D) x 59 (H) mm
2-7/8 (W) x 5-1/8 (D) x 2-3/8 (H) inches
Weight 445 g / 1 lb (including battery)
Accessories Leaet (“USING THE UNIT SAFELY,”
“IMPORTANT NOTES,” and “Information”)
Alkaline battery (9V, 6LR61)
Options
(sold separately)
AC adaptor (PSA-series)
Footswitch: FS-5L, FS-6, FS-7
* The FS-6 and FS-7 can be used only in latch
mode.
* 0 dBu = 0.775 Vrms
* This document explains the specications of the product at the time
that the document was issued. For the latest information, refer to the
Roland website.
Thumbscrew
Battery Housing
Pedal
Spring Base
Coil Spring
Guide Bush
Hole
Battery Snap
Cord
Battery
Snap
9 V Battery
REMOTE jack
Here you can connect a latch-type footswitch (sold separately: FS-5L, FS-6, FS-7).
* In the case of the FS-6 or FS-7, only latch mode can be used.
By operating the footswitch you can switch between the two
types of distortion or turn them on/o individually.
For details, refer to “Operation at a Glance.”
Guitar Amplier
Owner’s Manual
Intellectual Property Right
• Roland, BOSS, BLUES DRIVER are either registered trademarks or
trademarks of Roland Corporation in the United States and/or other
countries.
CMSIS-RTOS RTX Version 4.70.1
Copyright (c) 1999-2009 KEIL, 2009-2015 ARM Germany GmbH
All rights reserved.
Redistribution and use in source and binary forms, with or without
modication, are permitted provided that the following conditions are
met:
• Redistributions of source code must retain the above copyright notice,
this list of conditions and the following disclaimer.
• Redistributions in binary form must reproduce the above copyright
notice, this list of conditions and the following disclaimer in the
documentation and/or other materials provided with the distribution.
• Neither the name of ARM nor the names of its contributors may be
used to endorse or promote products derived from this software
without specic prior written permission.
THIS SOFTWARE IS PROVIDED BY THE COPYRIGHT HOLDERS AND
CONTRIBUTORS “AS IS” AND ANY EXPRESS OR IMPLIED WARRANTIES,
INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF
MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE
DISCLAIMED. IN NO EVENT SHALL COPYRIGHT HOLDERS AND CONTRIBU-
TORS BE LIABLE FOR ANY DIRECT, INDIRECT, INCIDENTAL, SPECIAL,
EXEMPLARY, OR CONSEQUENTIAL DAMAGES (INCLUDING, BUT NOT
LIMITED TO, PROCUREMENT OF SUBSTITUTE GOODS OR SERVICES; LOSS OF
USE, DATA, OR PROFITS; OR BUSINESS INTERRUPTION) HOWEVER CAUSED
AND ON ANY THEORY OF LIABILITY, WHETHER IN CONTRACT, STRICT
LIABILITY, OR TORT (INCLUDING NEGLIGENCE OR OTHERWISE) ARISING IN
ANY WAY OUT OF THE USE OF THIS SOFTWARE, EVEN IF ADVISED OF THE
POSSIBILITY OF SUCH DAMAGE.
INPUT jack
This jack accepts input signals (coming from a guitar, some other electric or
electronic musical instrument, or another eects unit).
* The INPUT jack doubles as the power switch.
Power to the unit is turned on when you plug
into the INPUT jack; the power is turned o
when the cable is unplugged.
To prevent unnecessary battery consumption,
be sure to disconnect the plug from the INPUT
jack when not using the eects unit.
Before using this unit, carefully read the sections entitled: “USING THE UNIT SAFELY” and “IMPORTANT NOTES” (supplied on a separate sheet).
After reading, keep the document(s) where it will be available for immediate reference.
© 2017 Roland Corporation 02
Produktspecifikationer
| Varumärke: | Boss |
| Kategori: | Gitarr |
| Modell: | Angry Driver JB-2 |
Behöver du hjälp?
Om du behöver hjälp med Boss Angry Driver JB-2 ställ en fråga nedan och andra användare kommer att svara dig
Gitarr Boss Manualer
17 December 2024
17 December 2024
17 December 2024
17 December 2024
Gitarr Manualer
- Gitarr Yamaha
- Gitarr Pyle
- Gitarr Peavey
- Gitarr Behringer
- Gitarr Line 6
- Gitarr Fender
- Gitarr Ibanez
- Gitarr Epiphone
- Gitarr Gretsch
- Gitarr Gretsch Guitars
- Gitarr Orange
- Gitarr AER
- Gitarr Warwick
- Gitarr Cordoba
- Gitarr Gallien-Krueger
- Gitarr Bugera
- Gitarr Aria
- Gitarr Traveler Guitar
- Gitarr Carlsbro
Nyaste Gitarr Manualer
15 December 2024
15 December 2024
15 December 2024
15 December 2024
14 December 2024
14 December 2024
6 December 2024
27 Oktober 2024
19 Oktober 2024
5 Oktober 2024