Frigidaire FGF382HS Bruksanvisning

Frigidaire Ugn FGF382HS

Läs nedan 📖 manual på svenska för Frigidaire FGF382HS (16 sidor) i kategorin Ugn. Denna guide var användbar för 9 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/16

INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.

IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.

READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

Clearances and Dimensions

1. Location—Check location where the range will be

installed. Check for proper electrical and gas supply,

and the stability of the floor.

2. Dimensions that are shown must be used. Given

dimensions provide minimum clearance. Contact

surface must be solid and level.

Provide Proper Fuel Type

Before Proceeding: Your range is preset to operate on

natural gas.

DO NOT attempt to convert this range to LP/

Propane settings without the proper LP/Propane conversion

kit provided with the range or obtained from your dealer. Follow

all instructions provided with the LP Conversion Kit.

Español - Páginas 9-16

30" GAS RANGE INSTALLATION INSTRUCTIONS

(For Models with Sealed Top Burners)

If the information in this manual is not followed

exactly, a fire or explosion may result causing property

damage, personal injury or death.

FOR YOUR SAFETY:

— Do not store or use gasoline or other flammable vapors

and liquids in the vicinity of this or any other appliance.

— WHAT TO DO IF YOU SMELL GAS:

• Do not try to light any appliance.

•Do not touch any electrical switch; do not use any phone

in your building.

• Immediately call your gas supplier from a neighbor's

phone. Follow the gas supplier's instructions.

• If you cannot reach your gas supplier, call the fire

department.

— Installation and service must be performed by a qualified

installer, service agency or the gas supplier. Note: For appliances installed in the

State of Massachusetts see page 2.

Refer to your serial plate for

applicable agency certification

p/n 316259343 Rev A EN/SP (0809)

door open

incl. door handle

3/8"

36 1/8"

30"

13"

18"

SIDE

VIEW

Minimum to

Cabinets on

Either Side

of Range.

0" Clearance Below Cooking Top and at Rear of Range.

Maximum Depth

for Cabinets

Above Range Top.

36"

25"

FRONT

VIEW

25 3/4"

30"

29 7/8"

48"

Maximum

30"

Minimum

*Minimum to

Side Wall

on Either

Side of

Range 5"

OVERALL

DIMENSIONS

*5"

1/4"

30"

Important Notes to the Installer

1. Read all instructions contained in these installation

instructions before installing range.

2. Remove all packing material from the oven compartments

before connecting the gas and electrical supply to the

range.

3. Observe all governing codes and ordinances.

4. Be sure to leave these instructions with the consumer.

Important Note to the Consumer

1. Keep these instructions with your Use & Care Guide for

future reference.

IMPORTANT SAFETY INSTRUCTIONS

Installation of this range must conform with local codes or, in

the absence of local codes, with the National Fuel Gas Code

ANSI Z223.1—latest edition when installed in the United

States.

When installed in a manufactured (mobile) home, installation

must conform with the Manufactured Home Construction and

Safety Standard, Title 24 CFR, Part 3280 [formerly the Federal

Standard for Mobile Home Construction and Safety, Title 24,

HUD (Part 280)] or, when such standard is not applicable, the

Standard for Manufactured Home Installations, ANSI/NCSBCS

A225.1, or with local codes.

This range has been design certified by CSA International. As

with any appliance using gas and generating heat, there are

certain safety precautions you should follow. You will find them

in the Use & Care Guide, read it carefully.

•Be sure your range is installed and grounded properly

by a qualified installer or service technician.

•This range must be electrically grounded in

accordance with local codes or, in their absence,

with the National Electrical Code ANSI/NFPA No .70—

latest edition when installed in the United States.

See Grounding Instructions on page 5.

•Before installing the range in an area covered with

linoleum or any other synthetic floor covering, make

sure the floor covering can withstand heat at least

90°F above room temperature without shrinking,

warping or discoloring. Do not install the range over

carpeting unless you place an insulating pad or sheet of

1/4-inch thick plywood between the range and carpeting.

•Make sure the wall coverings around the range can

withstand the heat generated by the range.

•Do not obstruct the flow of combustion air at the oven

vent nor around the base or beneath the lower front

panel of the range. Avoid touching the vent openings or

nearby surfaces as they may become hot while the oven

is in operation. This range requires fresh air for proper

burner combustion.

Never leave children alone or unattended

in the area where an appliance is in use. As children grow,

teach them the proper, safe use of all appliances. Never leave

the oven door open when the range is unattended.

Stepping, leaning or sitting on the doors

or drawers of this range can result in serious injuries and

can also cause damage to the range.

•Do not store items of interest to children in the

cabinets above the range. Children could be seriously

burned climbing on the range to reach items.

•To eliminate the need to reach over the surface

burners, cabinet storage space above the burners

should be avoided.

•Adjust surface burner flame size so it does not

extend beyond the edge of the cooking utensil.

Excessive flame is hazardous.

•Do not use the oven as a storage space. This creates

a potentially hazardous situation.

•Never use your range for warming or heating the

room. Prolonged use of the range without adequate

ventilation can be dangerous.

•Do not store or use gasoline or other flammable

vapors and liquids near this or any other appliance.

Explosions or fires could result.

•Reset all controls to the "off" position after using a

programmable timing operation.

FOR MODELS WITH SELF-CLEAN FEATURE:

• Remove broiler pan, food and other utensils before

self-cleaning the oven. Wipe up excess spillage. Follow

the cleaning instructions in the Use & Care Guide.

• Unlike the standard gas range, THIS COOKTOP IS

NOT REMOVABLE. Do not attempt to remove the cooktop.

DO NOT MAKE ANY ATTEMPT TO

OPERATE THE ELECTRIC IGNITION OVEN DURING AN

ELECTRICAL POWER FAILURE. RESET ALL OVEN

CONTROLS TO "OFF" IN THE EVENT OF A POWER

FAILURE.

The electric ignitor will automatically re-ignite the oven burner

when power resumes if the oven thermostat control was left

in the "ON" position.

When an electrical power failure occurs during use, the

surface burners will continue to operate.

During a power outage, the surface burners can be lit with a

match. Hold a lighted match to the burner, then slowly turn

the knob to the LITE position. Use extreme caution when

lighting burners this way.

30" GAS RANGE INSTALLATION INSTRUCTIONS

(For Models with Sealed Top Burners)

Special instructions for appliances installed in the State of

Massachusetts: This appliance can only be installed in the

State of Massachusetts by a Massachusetts licensed

plumber or gas fitter. When using a flexible gas connector, it

must not exceed 3 feet (36 inches) in length. A "T" handle

type manual gas valve must be installed in the gas supply

line to this appliance.

• Air curtain or other overhead range hoods, which operate

by blowing a downward air flow on to a range, shall not be

used in conjunction with gas ranges other than when the

hood and range have been designed, tested and listed by

an independent test laboratory for use in combination with

each other.

Before Starting

Tools You Will Need

For leveling legs and Anti-Tip Bracket:

• Adjustable wrench or channel lock pliers

• 5/16" Nutdriver or Flat Head Screw Driver

• Electric Drill & 1/8" Diameter Drill Bit (5/32" Masonry Drill

Bit if installing in concrete)

For gas supply connection:

• Pipe wrench

For burner flame adjustment:

• Phillips head and

blade-type screwdrivers

For gas conversion (LP/Propane or Natural):

• Open end wrench - 1/2"

Additional Materials You Will Need

• Gas line shut-off valve

• Pipe joint sealant that resists action of LP/Propane gas

• A new flexible metal appliance conduit (1/2" NPT x 3/4"

or 1/2" I.D.) must be design certified by CSA International.

Because solid pipe restricts moving the range we

recommend using a new flexible conduit (4 to 5 foot

length) for each new installation and additional

reinstallations.

• Always use the (2) new flare union adapters (1/2" NPT x

3/4" or 1/2" I.D.) supplied with the new flexible appliance

conduit for connection of the range.

Normal Installation Steps

1. Anti-Tip Bracket Installation Instructions

Important Safety Warning

To reduce the risk of tipping of the range, the range must be

secured to the floor by properly installed anti-tip bracket and

screws packed with the range. Failure to install the anti-tip

bracket will allow the range to tip over if excessive weight is

placed on an open door or if a child climbs upon it. Serious

injury might result from spilled hot liquids or from the range

itself.

If range is ever moved to a different location, the anti-tip

brackets must also be moved and installed with the range.

Instructions are provided for installation in wood or cement

fastened to either the floor or wall. When installed to the wall,

make sure that screws completely penetrate dry wall and are

secured in wood or metal. When fastening to the floor or wall,

be sure that screws do not penetrate electrical wiring or

plumbing.

A. Locate the Bracket Using the Template - (Bracket may

be located on either the left or right side of the range. Use

the information below to locate the bracket if template is

not available). Mark the floor or wall where left or right side

of the range will be located. If rear of range is against the

wall or no further than 1-1/4" from wall when installed, you

may use the wall or floor mount method. If molding is

installed and does not allow the bracket to fit flush against

the wall, remove molding or mount bracket to the floor. For

wall mount, locate the bracket by placing the back edge

of the template against the rear wall and the side edge of

template on the mark made referencing the side of the

range. Place bracket on top of template and mark location

of the screw holes in wall. If rear of range is further than

1-1/4" from the wall when installed, attach bracket to the

floor. For floor mount, locate the bracket by placing back

edge of the template where the rear of the range will be

located. Mark the location of the screw holes, shown in

template.

B. Drill Pilot Holes and Fasten Bracket - Drill a 1/8" pilot

hole where screws are to be located. If bracket is to be

mounted to the wall, drill pilot hole at an approximate 20°

downward angle. If bracket is to be mounted to masonry

or ceramic floors, drill a 3/16" pilot hole 1-3/4" deep. The

screws provided may be used in wood or concrete material.

Use a 5/16" nut-driver or flat head screwdriver to secure the

bracket in place.

30" GAS RANGE INSTALLATION INSTRUCTIONS

(For Models with Sealed Top Burners)

Produktspecifikationer

Varumärke:	Frigidaire
Kategori:	Ugn
Modell:	FGF382HS
Färg på produkten:	Zwart
Förpackningens bredd:	260 mm
Djuppackning:	75 mm
Förpackningshöjd:	185 mm
Snäll:	AV-zender & ontvanger
Användarmanual:	Ja
Nuvarande:	1.2 A
Ljudformat som stöds:	PCM
Anslutningsteknik:	Draadloos
Videolägen som stöds:	1080i, 1080p, 480p, 576p, 720p
Maximal upplösning:	1920 x 1080 Pixels
Medföljande kablar:	HDMI, Mini-USB
Inkluderar AC-adapter:	Ja
HDCP:	Ja
Maximal uppdateringshastighet:	60 Hz
Anslutning för nätadapter:	Ja
Extern anpassning:	Ja
Frekvensomfång:	5.1 - 5.6 GHz
HDMI in:	1
HDCP-version:	1.3
Antal HDMI-utgångar:	1
Mottagare mått (B x D x H):	95 x 95 x 32 mm
Driftspänning:	5 V
Maximal-räckvidd:	10 m
AC-ingångsspänning:	100 - 240 V
AC-ingångsfrekvens:	50 - 60 Hz
Mottagarens vikt:	126 g
Sändarens mått (BxDxH):	30 x 83 x 18 mm
Sändarens vikt:	22 g
Utökad visningsidentifikationsdata (EDID):	Ja