Maytag WHP0400VW Bruksanvisning

Läs nedan 📖 manual på svenska för Maytag WHP0400VW (16 sidor) i kategorin Inte kategoriserad. Denna guide var användbar för 6 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Sida 1/16
PEDESTAL INSTALLATION INSTRUCTIONS
For use only with commercial washers and dryers
W10103370A
23.62"
(60.0 cm)
Table of Contents ................................................................................2
Índice....................................................................................................7
Table des matres ............................................................................12
27"
(68.6 cm)
2.85"
(7.2 cm)
INSTRUCTIONS D’INSTALLATION DU PIÉDESTAL
Destiné uniquement aux laveuses et sécheuses commerciales
INSTRUCCIONES DE INSTALACIÓN DEL PEDESTAL
Para uso sólo con lavadoras y secadoras comerciales
2
NOTE: If the dryer and pedestal assembly is located in a garage,
15.5" (39.4 cm) must be added under the pedestal so that the
dryer is 18" (46 cm) above the garage floor.
PEDESTAL SAFETY
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools
listed here.
Tools needed
utility knife
1/4" hex head ratchet or open-end wrench
5/16" hex head ratchet or open-end wrench
14 mm open-end wrench
level
9/16" open-end wrench
pliers or slip-joint pliers
bucket
Parts supplied
four #12 x 5/8" hex head sheet metal screws (in parts bag)
two adjustable feet (in parts bag)
Installation Instructions
NOTE: If the pedestal is to be installed under a washer, use the
feet that were factory installed on the washer for the pedestal
installation, and save the two adjustable feet supplied in the parts
bag for use with dryer pedestal installation.
TABLE OF CONTENTS
PEDESTAL SAFETY . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
INSTALLATION REQUIREMENTS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Tools and Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Location Requirements . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
Before Installing the Pedestal . . . . . . . . . . . . . . . . . . . . . . . .3
INSTALLATION INSTRUCTIONS . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
Installing the Pedestal . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
Complete the Installation . . . . . . . . . . . . . . . . . . . . . . . . . . .5
COMMERCIAL PEDESTAL WARRANTY . . . . . . . . . . . . . . . . . . . . . . .6
INSTALLATION REQUIREMENTS
Location Requirements
Uninstalling your electric dryer
1. Unplug the power supply cord.
2. Disconnect wiring if dryer is direct wired.
3. Pull the dryer away from the wall enough to loosen the vent
clamp. Loosen the clamp and gently remove the exhaust vent
from the dryer exhaust outlet.
4. Pull the dryer away from the wall so that it can be tipped on
its back.
5. Protect the floor with a large piece of cardboard cut from the
pedestal carton. Lay the dryer on its back (make sure that the
power supply cord is not under the dryer) so that the
cardboard is under the entire lower back edge of the dryer.
6. Go to “Installing the Pedestal” section.
Before Installing the Pedestal
IMPORTANT: If your washer and dryer are already installed, they
must be uninstalled.
If you need to uninstall your washer or dryer, see the installation
instructions that came with your model for tools required.
Uninstalling your washer
NOTE: To prevent suspension and structural damage, your
washer must be properly set up for relocation by a certified
technician.
1. Turn off the hot and cold water faucets.
2. Unplug the power supply cord or disconnect power.
3. Slowly loosen the fill hoses at the faucets to relieve the water
pressure. Use a sponge or towel to absorb the released water.
4. Remove the “HOT” and “COLD” fill hoses from the back of
the washer. Drain the water from the hoses into a bucket.
5. Squeeze the ears of the drain hose clamp with pliers to open
and slide the clamp down the hose. Disconnect the drain
hose from the washer and drain any water in the hose into
a bucket.
6. Pull the washer away from wall so it can be tipped on its
back.
7. Protect the floor with a large piece of cardboard cut from the
pedestal carton. Lay the washer on its back (make sure that
the power supply cord is not under the washer) so that the
cardboard is under the entire lower back edge of the washer.
An additional small amount of water will drain out of the
washer when it is tipped back.
8. Go to “Installing the Pedestal” section.
3
A. Cardboard
12"
(30.5 cm)
15"
(38.1 cm)
12"
(30.5 cm)
15"
(38.1 cm)
A
A. Cardboard
A

Produktspecifikationer

Varumärke: Maytag
Kategori: Inte kategoriserad
Modell: WHP0400VW

Behöver du hjälp?

Om du behöver hjälp med Maytag WHP0400VW ställ en fråga nedan och andra användare kommer att svara dig




Inte kategoriserad Maytag Manualer

Inte kategoriserad Manualer

Nyaste Inte kategoriserad Manualer