PAC RPK5-GM4101 Bruksanvisning
Läs nedan 📖 manual på svenska för PAC RPK5-GM4101 (9 sidor) i kategorin Bilsats. Denna guide var användbar för 2 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare
Sida 1/9
Page 1
PAC® | 866-931-8021 | support@pac-audio.com
©2016 Pacic Accessory Corporation
www.pac-audio.com Rev. 113016
P ifi A C ti
PAC is an AAMP power brand
RPK5-GM4101
Complete Radio Replacement Kit with
Integrated Climate Control Retention for
2010-2015 Chevrolet Camaro
Removing the factory radio from the vehicle
1.1 - Apply the parking brake. Move the transmission shift
assembly to the most rearward position possible. Use a
at bladed plastic trim tool and release the retainer tabs
securing the front oor console front cover to the console
assembly. Lift the cover (1) up and rearward making sure that
the accessory power receptacle and the electronic traction
control switch clears the transmission shift assembly. It may be
necessary to pop them loose from the underside to achieve
clearance. Disconnect the electrical connections.
1.2 - Remove the 2 x 7mm bolts (1) securing the radio
control assembly (2) into the dash. Then use a at-
bladed plastic trim tool in order to release the retainer
clips securing the radio control assembly (2) to the
instrument panel. Disconnect the electrical connections.
Parts List
The RPK5-GM4101 includes everything you need for a professional installation of an aftermarket radio in your Camaro.
This kit contains:
1. Dash Kit
• (x1) PAC HVAC Control Panel (Transfer of the factory HVAC knobs is required. See instructions below)
• (x2) Radio Mounting Brackets (One left and one right)
• (x1) Pocket (For single din applications)
• (x8) Radio Mounting Screws
2. RP5-GM4101 (Camaro specic radio replacement module)
3. Camaro specic antenna adapter (BAA-DIN22).
4. Rear camera retention cable for vehicles equipped with the MyLink system.
5. USB retention cable. This cable is compatible with vehicles equipped with the MyLink radios and vehicles equipped with the
standard non-touchscreen radios. It will require that the cable be ran to the back of the center console.
6. AUX retention cable for 2010-2012 vehicles equipped with the standard non-touchscreen radios also equipped with a USB port.
Overview
The RPK5-GM4101 is a complete radio replacement kit with integrated climate control retention for the 2010-2015 Chevrolet
Camaro. This kit utilizes the factory HVAC control knobs for a more factory look and experience. To add to the factory look
and experience the exterior temperature display is retained by a small OLED display at the top of the kit retaining this valuable
vehicle feature. This kit also includes all of the modules and cables needed to retain all of the important features of the factory
system such as OnStar, factory warning chimes, factory Bluetooth, steering wheel mounted radio controls, factory reverse
camera, factory amplier (if equipped), AM/FM reception, factory AUX jack (if equipped) and the factory USB port (if equipped).
Table of Contents: Page:
1. Factory Radio Removal ------------------------------------------------------ 1-2
2. Disassembly of the factory HVAC control module --------------------- 2-3
3. Assembly of the PAC HVAC control module ---------------------------- 3-4
4. RP5-GM4101 Instructions --------------------------------------------------- 4-6
5. AUX & USB Cable Installation ------------------------------------------------ 7
6. Temperature Display Settings ------------------------------------------------- 7
7. Sub-Dash Preparation ----------------------------------------------------------- 7
8. Kit Assembly Instructions ------------------------------------------------------- 8
9. Installation of the PAC HVAC control module --------------------------- 8-9
Page 2
RPK5-GM4101
Complete Radio Replacement Kit with
Integrated Climate Control Retention for
2010-2015 Chevrolet Camaro
PAC® | 866-931-8021 | support@pac-audio.com
©2016 Pacic Accessory Corporation
www.pac-audio.com Rev. 113016
P ifi A C ti
PAC is an AAMP power brand
Disassembly of the factory HVAC control panel
The following steps will aide you in the disassembly of the HVAC control panel so that the factory
HVAC control knobs and supports can be reused in the PAC RPK5-GM4101 Integrated Kit.
2.6 - Be sure to keep the screws
separated as there are different lengths
and diameters.
2.5 - Using a at bladed pry tool remove two
of the white fasteners off of the black plastic
backing.
2.4 - Remove the 10 Phillips head screws
shown below and remove the black plastic
backing.
2.2 - Pry outwards on the clips on either side
of the plastic trim that surrounds the white
connector.
2.3 - Once the plastic trim is removed, locate
the 16 pin connector shown below. Using a
at bladed tool, press in the grooves on both
sides, pry upward and away from the circuit
board, to release the connector.
2.1 - Remove the 2 Phillips head screws
shown below.
1.3 - Remove the 4 x 7mm bolts (1) securing the radio
(2) into the dash. Slide the radio (2) to the rear and
disconnect all electrical connections.
You can set the radio aside as it will not be used fur-
ther. For the next section, you will be working with
the factory HVAC control panel to utilize the HVAC
knobs allowing for more of a factory experience
when using the PAC RPK5-GM4101.
Proceed to the next section to begin disassembly of
the factory radio control assembly.
Removing the factory radio from the vehicle (cont.)
Page 3
PAC® | 866-931-8021 | support@pac-audio.com
©2016 Pacic Accessory Corporation
www.pac-audio.com Rev. 113016
P ifi A C ti
PAC is an AAMP power brand
RPK5-GM4101
Complete Radio Replacement Kit with
Integrated Climate Control Retention for
2010-2015 Chevrolet Camaro
Disassembly of the factory radio control assembly (cont.)
2.7 - Remove the 12 Phillips head screws
shown below.
2.8 - Be sure to keep the screws separated
as they will be used during the assembly
stage later.
2.9 - After the screws have been removed,
remove the HVAC knobs by pulling them
from the front of the faceplate being careful
not to bend the contacts on either end of the
contact swiper on the backside of each of
the knobs.
2.10 - Look inside the opening where the
knobs were removed. Remove the 2 Phillips
screws shown below. Do this for both
openings.
2.11 - Remove the 2 support brackets and
keep handy as they will be used in the next
step.
Assembly of the PAC HVAC control assembly
3.2 - Secure the 2 support brackets to
the circuit board using the same screws
removed from Disassembly step # 9. The
screws will pass through the board and
thread into the brackets via the holes dened
below. Be sure that the alignment tabs are
seated properly.
3.1 - Secure the 2 support brackets to the
PAC HVAC control assembly using 4 of the
same screws shown in disassembly step #
7. Do this to the back of each side. Be sure
that the alignment tabs are seated properly
in the circuit board to the front.
3.3 - Position the knobs in the proper opening
so that the buttons are straight and insert
them into the opening. With VERY LITTLE
force rotate them slightly left and right while
pushing them towards the PCB. Once the
alignment tabs are lined up they should click
and lock into place. Use extra caution as the
contacts could bend while rotating.
Produktspecifikationer
| Varumärke: | PAC |
| Kategori: | Bilsats |
| Modell: | RPK5-GM4101 |
Behöver du hjälp?
Om du behöver hjälp med PAC RPK5-GM4101 ställ en fråga nedan och andra användare kommer att svara dig
Bilsats PAC Manualer
4 September 2024
31 Augusti 2024
Bilsats Manualer
- Bilsats Motorola
- Bilsats Nokia
- Bilsats Pioneer
- Bilsats Siemens
- Bilsats Alpine
- Bilsats Silvercrest
- Bilsats Nedis
- Bilsats Gembird
- Bilsats Pyle
- Bilsats Livoo
- Bilsats Manta
- Bilsats BeeWi
- Bilsats Caliber
- Bilsats Sony Ericsson
- Bilsats Manhattan
- Bilsats Exibel
- Bilsats Trust
- Bilsats Thule
- Bilsats Hama
- Bilsats Kensington
- Bilsats Parrot
- Bilsats Brigmton
- Bilsats Maginon
- Bilsats Plantronics
- Bilsats Magellan
- Bilsats Clarion
- Bilsats HTC
- Bilsats Envivo
- Bilsats Uniden
- Bilsats Renegade
- Bilsats Boss
- Bilsats Jabra
- Bilsats TomTom
- Bilsats Technaxx
- Bilsats Bury
- Bilsats T'nB
- Bilsats SuperTooth
- Bilsats Veho
- Bilsats Mr Handsfree
- Bilsats HQ
- Bilsats Metra
- Bilsats Scosche
- Bilsats Urban Revolt
- Bilsats Iluv
- Bilsats KRAM
- Bilsats NAV-TV
- Bilsats Ergotron
- Bilsats Havis
- Bilsats Alpin
- Bilsats Novero
- Bilsats Kogan
- Bilsats Foliatec
- Bilsats B-Speech
- Bilsats THB
- Bilsats Interphone-Cellularline
- Bilsats Perfect Choice
- Bilsats Arkon
- Bilsats SiriusXM
- Bilsats I-Tec
- Bilsats Hamron
- Bilsats Brodit
Nyaste Bilsats Manualer
31 December 2025
29 December 2024
29 December 2024
29 December 2024
29 December 2024
29 December 2024
29 December 2024
29 December 2024
16 December 2024
19 Oktober 2024