RCBS Partner Press Bruksanvisning

RCBS Inte kategoriserad Partner Press

Läs nedan 📖 manual på svenska för RCBS Partner Press (16 sidor) i kategorin Inte kategoriserad. Denna guide var användbar för 2 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/16

PARTNER

PRESS

P R O D U C T I N S T R U C T I O N S

IMPORTANT

Before using the RCBS , read this instruction manual carefully to fully learn how to Partner Press

safely operate the scale. Failure to properly operate the scale can result in severe personal injury

and/or equipment damage. If you have read these instructions and still do not understand some

operation, call us at 1-800-533-5000 and a technician will assist you.

This instruction manual contains specific safety and operating information. It should be considered a

permanent part of your reloading equipment and remain with the equipment at all times for easy

reference.

SAFETY

Reloading is an enjoyable and rewarding hobby that can be conducted safely. But, as with any

hobby, carelessness or negligence can make reloading hazardous. This product has been designed

from the beginning with the user’s safety in mind. When reloading, safety rules must be followed. By

observing these rules, the chance of a hazardous occurrence causing personal injury or property

damage is minimized.

GENERAL

• Use all equipment as the manufacturer recommends. Study the instructions carefully and become

thoroughly familiar with the operation of the product. If you do not have written instructions, request

a copy from the equipment manufacturer.

• Don’t take short cuts. Attempting to bypass established procedures is an invitation to an accident.

• Observe “good housekeeping” in the reloading area. Keep tools and components neat, clean and

orderly. Promptly and completely clean up primer and powder spills.

• Reload only when you can give your undivided attention. Do not reload when fatigued or ill, or

under the influence of medications or alcohol. Develop a reloading routine to avoid mistakes which

may prove hazardous. Don’t rush - load at a leisurely pace.

• Always wear adequate eye protection to protect your eyes from flying particles. You assume

unnecessary risk when reloading without wearing safety glasses.

LOADING DATA

• Use only laboratory tested reloading data. We highly recommend the SPEER Reloading Manual.

• OBSERVE ALL WARNINGS ABOUT THE USE OF MAXIMUM LISTED LOADS.

PRIMERS AND POWDER

• Store primers and powder beyond the reach of children and away from heat, dampness, open

flames and electrical equipment. Avoid areas where static electricity is evident.

• Do not use primers of unknown identity. Scrap unknown primers in accordance with applicable

regulations.

• Keep primers in the original factory container until ready to use. Return unused primer to the same

factory packaging for safety and to preserve their identity. Primer packaging is designed to provide

safe storage.

• DO NOT store primers in bulk. The blast of just a few hundred primers is sufficient to cause

serious injury to anyone nearby.

• DO NOT force primers. Use care in handling primers.

• DO NOT have more than one can of powder on the bench at one time. Powder cans should be

stored away from the bench to avoid picking up the wrong one.

• DO NOT use any powder unless its identity is positively known. The only positive

 identification is the manufacturer’s label on the original canister. Discard all mixed powders            

and those of uncertain identity.

• If you use a powder measure, replace the lids on both the powder hopper and powder can

after the powder hopper has been filled.

• When using a powder measure, settle the powder in the powder hopper before charging any

cases. Throw and check the weight of at least ten charges. This will assure you that the correct

powder charge is being thrown.

• When you finish a reloading session, pour any remaining powder back into its original factory

container. This will preserve the identity and shelf life of the powder.

• DO NOT smoke while reloading.

RECORD KEEPING

• Keep complete records of reloads. Apply a descriptive label to each box showing the date

produced, and the primer, powder and bullet used. Labels for this purpose are packed with

SPEER bullets. Never        attempt to guess at the identity of your ammunition.

INTRODUCTION

The Partner Press was specifically designed for the beginning reloader. With the Partner you can

reload your favorite rifle and pistol ammo – from the magnums down to .17 caliber. Because of the

patented RCBS compound leverage system and block “O” frame you can easily full-length size

cases with less effort than other presses need to neck size. The standard / -14 top thread allows the

use of many RCBS accessories.

The primer arm on the Partner Press is equipped with interchangeable primer plugs and sleeves

for seating large and small primers. The primer arm swings out of the way when not in use.

RELOADING DIE

HANDLE

PRIMER ARM

SHELL HOLDER

Produktspecifikationer

Varumärke:	RCBS
Kategori:	Inte kategoriserad
Modell:	Partner Press
Färg på produkten:	Zwart
Vikt:	2300 g
Bredd:	357 mm
Djup:	300 mm
Höjd:	61.7 mm
Användarmanual:	Ja
Husmaterial:	Metal, Plastic
Typ av anslutningskontakt:	3,5 mm
Anslutningsteknik:	Docking
Ethernet LAN:	Ja
Typ av strömkälla:	DC
Integrerad minneskortläsare:	Nee
Inkluderar AC-adapter:	Ja
Antal USB 2.0-portar:	3
VGA (D-Sub) port(ar):	1
Antal HDMI-portar:	1
Mikrofon, linjeingång:	Ja
Antal Ethernet LAN (RJ-45)-portar:	1
Monteringsalternativ för kabellås:	Ja
Hörlursutgångar:	1
Certifiering:	MIL-STD 810G 514.5\nSAE J1455\nCE, FCC
Anslutning för nätadapter:	Ja
VESA montering:	Ja
Hållbarhetscertifikat:	RoHS
Typ av mat:	Extern
Varumärkeskompatibilitet:	Getac
Antal portar USB 3.2 Gen 1 (3.1 Gen 1) Typ A:	1
Spännande:	19 V
Kompatibilitet:	S410
Kompatibilitet med monteringsgränssnitt (max):	75 x 75 mm
Seriell port(ar):	1