Salton BS1442 Bruksanvisning
Salton
Vakuumförseglingsmaskiner
BS1442
Läs nedan 📖 manual på svenska för Salton BS1442 (12 sidor) i kategorin Vakuumförseglingsmaskiner. Denna guide var användbar för 3 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare
Sida 1/12
Instruction Booklet
Model BS1442
smartsealer
TM
bag sealer
2
DESCRIPTION OF PARTS
1. Heat Pad
2. Heat Wire
3. Battery Cover
4. Battery Chamber
5. Bag Cutter
6. Press Bar
IMPORTANT SAFEGUARDS
When using appliances basic safety precautions should always be followed
including the following:
• Read all instructions.
• Do not touch hot surfaces. NEVER TOUCH THE HEATING WIRE OR TOUCH
ANOTHER PERSON WITH THE HEATING WIRE. INJURY MAY OCCUR AS A
RESULT.
• Do not place on or near a hot gas or electric burner, or in a heated oven.
• Close supervision is necessary when any appliance is used by or near children.
• Never store in a drawer or con ned area when the batteries are installed in the
Sealer. If the Heat Pad is depressed, the unit will turn-on and cause a potential
re hazard and will certainly be damaged.
• The Bag Sealer is equipped with a Bag Opener. The blade of the Bag Opener
is very sharp. Be sure to keep the Bag Sealer out of the reach of small children
whose small ngers might be able to reach the blade.
• This appliances is for . Do not use appliance for other than Household Use Only
its intended use.
1
2
3
4
6
5
SAVE THESE INSTRUCTIONS
The Salton SmartsealerTM is portable as it can be operated by installing two ‘AA’
Alkaline batteries. Open the Battery Cover by sliding your thumb nail under the
Battery Cover and lift. Install the batteries and snap the Battery Cover back on.
The Salton SmartsealerTM has a built in magnetic bottom so it can be stored on the
front of your refrigerator, convenient and ready to use.
ABOUT THE SALTON SMARTSEALERTM
The Salton SmartsealerTM is easy to use. However, it does take a little practice to
get used to the ‘feel of the seal’. So take the time to read the instructions below
and learn about how the Salton Smartsealer
TM works. You’ll quickly get the ‘feel
of the seal’. Always use light pressure, just enough pressure to depress the
Heat Pad using the Press Bar. The Salton Smartsealer
TM is a heat sealer, not a
pressure sealer. So press, don’t squeeze.
HOW TO USE
Install 2 ‘AA’ batteries. Take the heat sealable bag and smooth out the top of the
bags edges evenly to eliminate wrinkles. The insides of the bag’s edges must be
able to touch one another. No food, dirt, or oil should be between the inner
walls of the bag where the seal is to be made. Place the open bag to be sealed
into the Salton SmartsealerTM. Hold the bag in one hand and the Sealer in the other
hand. Preheat the SmartsealerTM by holding down the Press Bar until it engages
the Heat Pad. Hold the Press Bar in this position for 3 seconds, before you start to
move the sealer across the bag to be sealed as this preheats the Heat Wire, then
begin to make the seal. The Salton Smartsealer
TM only needs to be preheated one
time per use. Use light pressure. Press don’t squeeze.
3
Produktspecifikationer
| Varumärke: | Salton |
| Kategori: | Vakuumförseglingsmaskiner |
| Modell: | BS1442 |
Behöver du hjälp?
Om du behöver hjälp med Salton BS1442 ställ en fråga nedan och andra användare kommer att svara dig
Vakuumförseglingsmaskiner Salton Manualer
11 Oktober 2024
Vakuumförseglingsmaskiner Manualer
- Vakuumförseglingsmaskiner Klarstein
- Vakuumförseglingsmaskiner Trisa
- Vakuumförseglingsmaskiner Jata
- Vakuumförseglingsmaskiner Vivax
- Vakuumförseglingsmaskiner Caso
Nyaste Vakuumförseglingsmaskiner Manualer
14 Oktober 2024
13 Oktober 2024
31 Juli 2024
28 Juli 2024
24 Juli 2024
24 Juli 2024