SIIG CE-MT0812-S1 Bruksanvisning
Läs nedan 📖 manual på svenska för SIIG CE-MT0812-S1 (8 sidor) i kategorin Wandstöd. Denna guide var användbar för 3 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare
Sida 1/8
04-0541A
TV Size: 32" - 55”
Max load capacity: 121lbs/55kg
Wall distance: 0.43/11mm
Universal Mounting Pattern
Ultra-Thin LED/LCD TV Mount - 32" to 55"
IMPORTANT: If you don't understand the installation instructions, please consult an
installation specialist
Ultra-Thin LED/LCD TV Wall Mount
Material: 2.0mm Cold Rolled Steel Plate
Installation Instructions
1
Caution
A G
B H
C I
D J
E K
F L
(×4) M8×16 screw
(×4) M6×16 screw
(×4) M8×80 bolt
(×4) M5×35 screw (×4) Concrete anchor
(×4) M8×35 screw (x2) Sponge sticker
(×4) M6×35 screw (×4) M8 spacer
When mounting to a wall that contains wood studs, confirm dead center of the wood stud prior to installation, it is
recommended that the wood studs be a minimum of 16" apart.
It is recommended that two people perform the installation. Injury and/or damage can result from dropping or
mishandling the display.
INSTALLATION AND OPERATING INSTRUCTIONS
Do not install near heater, fireplace, air conditioning, in direct sunlight, or any other heat producing source.
Failure to do so may result in damage to the display and could increase the risk of fire.
The wall structure must be capable of supporting at least the maximum load capacity as indicated. If not, the
wall must be reinforced. Proper installation procedure by yourself or a qualified service technician, as outlined in
the installation instructions, must be adhered to. Failure to do so could result in serious personal injury.
Recommended mounting surfaces: wood stud and solid-flat concrete. If the mount is to be installed on any
surface other than wood studs or concrete, use suitable hardware (not included but commercially available).
Prior to the installation of this product, the installation instructions should be read and completely understood.
The installation instructions must be read to prevent personal injury and property damage. Keep these
installation instructions in an easily accessible location for future reference.
CAUTION: The maximum load capacity is 121 lbs. Use with products exceeding the maximum load capacity may
cause serious injury. See apparatus instructions.
Do not install on a structure that is prone to vibration, movement or chance of impact. Failure to do so could
result in damage to the display and/or damage to the mounting surface.
Hardware Kit
(×4) M5×16 screw (×4) M6 washer
(x4) M5 washer
2
1
2
3
4
5
3
4
5
7
8
a) Wood Stud Installation
You should mark two positions total.
Stud finder for drywall installation
NOTE: When mounting to wood studs, the two wood studs must be a minimum of 16" apart.
Use a high-quality electronic stud finder (commercially available) to locate dead center of two studs and mark
their locations with a pencil.
Step 1: Wall Plate Installation
1
2With the help of an assistant, and using a bubble level to ensure the wall plate is level, position the wall plate
against the wall in the desired mounting location.
Mark the right and the left positions of the small horizontal slots that are in alignment with the studs.
Tools Required
Phillips head screw driver
Tighten the bolt with the 1/2" socket or 1/2" open-end wrench by turning clockwise until tight.
For each location, insert bolt (I) into the wall.
Pre-drill a 3/16" hole to a depth of approximately 3" in the wall stud at each marked location.
Level
1/2" socket & socket wrench and/or 1/2" open-end wrench
Drill, 3/16" (5mm) drill bit for wood stud installation and 3/8" (10mm) masonry drill bit for concrete/brick installation
CAUTION: Do not release the wall plate until it is properly mounted and secured to the wall.
6Place the wall plate against the wall and line up the mounting slots with the drilled holes. Check the bubble level
to verify that the wall plate is level.
CAUTION: Do not over-tighten bolts - doing so may cause unnecessary damage to the wall.
3
Produktspecifikationer
| Varumärke: | SIIG |
| Kategori: | Wandstöd |
| Modell: | CE-MT0812-S1 |
Behöver du hjälp?
Om du behöver hjälp med SIIG CE-MT0812-S1 ställ en fråga nedan och andra användare kommer att svara dig
Wandstöd SIIG Manualer
20 September 2024
20 September 2024
20 September 2024
20 September 2024
20 September 2024
20 September 2024
20 September 2024
20 September 2024
20 September 2024
20 September 2024
Wandstöd Manualer
- Wandstöd IKEA
- Wandstöd Philips
- Wandstöd Pioneer
- Wandstöd Ag Neovo
- Wandstöd Silvercrest
- Wandstöd Nedis
- Wandstöd Thomson
- Wandstöd Gembird
- Wandstöd Pyle
- Wandstöd Manta
- Wandstöd Vivanco
- Wandstöd Meliconi
- Wandstöd Logik
- Wandstöd Tripp Lite
- Wandstöd Techly
- Wandstöd GoGEN
- Wandstöd Marquant
- Wandstöd Steren
- Wandstöd Digitus
- Wandstöd Dahua Technology
- Wandstöd Insignia
- Wandstöd Sanus
- Wandstöd Peerless-AV
- Wandstöd Vogels
- Wandstöd Fellowes
- Wandstöd Deltaco
- Wandstöd Goobay
- Wandstöd Clas Ohlson
- Wandstöd Essentiel B
- Wandstöd One For All
- Wandstöd Newstar
- Wandstöd Chief
- Wandstöd Titan
- Wandstöd Monacor
- Wandstöd Ultimate Support
- Wandstöd StarTech.com
- Wandstöd La Vague
- Wandstöd Duronic
- Wandstöd B-tech
- Wandstöd Speaka
- Wandstöd Crimson
- Wandstöd Schwaiger
- Wandstöd Gravity
- Wandstöd Kanto
- Wandstöd Mitsai
- Wandstöd V7
- Wandstöd Karma
- Wandstöd Bretford
- Wandstöd MantelMount
- Wandstöd Bauhn
- Wandstöd CGV
- Wandstöd Crest
- Wandstöd SunBriteTV
- Wandstöd Best Buy
- Wandstöd My Wall
- Wandstöd Mount-It!
- Wandstöd Ridem
Nyaste Wandstöd Manualer
15 Oktober 2024
14 Oktober 2024
14 Oktober 2024
13 Oktober 2024
5 Oktober 2024
5 Oktober 2024
3 Oktober 2024
2 Oktober 2024
1 Oktober 2024
1 Oktober 2024