BSS Audio MSR-602 Bruksanvisning

Läs nedan 📖 manual på svenska för BSS Audio MSR-602 (38 sidor) i kategorin Inte kategoriserad. Denna guide var användbar för 2 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Sida 1/38
Welcome to the
WARNING FOR YOUR PROTECTION
READ THESE INSTRUCTIONS:
KEEP THESE INSTRUCTIONS
HEED ALL WARNINGS
FOLLOW ALL INSTRUCTIONS
DO NOT USE THIS APPARATUS NEAR WATER
THE APPARATUS SHALL NOT BE EXPOSED TO DRIPPING OR SPLASHING LIQ-
UID AND NO OBJECT FILLED WITH LIQUID, SUCH AS VASES, SHALL BE
PLACED ON THE APPARATUS.
CLEAN ONLY WITH A DRY CLOTH.
DO NOT BLOCK ANY OF THE VENTILATION OPENINGS. INSTALL IN ACCOR-
DANCE WITH THE MANUFACTURER’S INSTRUCTIONS.
DO NOT INSTALL NEAR ANY HEAT SOURCES SUCH AS RADIATORS, HEAT
REGISTERS, STOVES, OR OTHER APPARATUS (INCLUDING AMPLIFIERS)
THAT PRODUCE HEAT.
ONLY USE ATTACHMENTS/ACCESSORIES SPECIFIED BY THE MANUFACTUR-
ER.
UNPLUG THIS APPARATUS DURING LIGHTNING STORMS OR WHEN UNUSED
FOR LONG PERIODS OF TIME.
Do not defeat the safety purpose of the polarized or grounding-type
plug. A polarized plug has two blades with one wider than the other.
A grounding type plug has two blades and a third grounding prong.
The wide blade or third prong are provided for your safety. If the
provided plug does not fit your outlet, consult an electrician for
replacement of the obsolete outlet.
Protect the power cord from being walked on or pinched particular-
ly at plugs, convenience receptacles, and the point where they exit
from the apparatus.
Use only with the cart stand, tripod bracket, or table specified by the
manufacture, or sold with the apparatus. When a cart is used, use
caution when moving the cart/apparatus combination to avoid injury
from tip-over.
Refer all servicing to to qualified service personnel. Servicing is
required when the apparatus has been damaged in any way, such as
power-supply cord or plug is damaged, liquid has been spilled or
objects have fallen into the apparatus, the apparatus has been
exposed to rain or moisture, does not operate normally, or has been
dropped.
POWER ON/OFF SWITCH: For products provided with a power switch,
the power switch DOES NOT break the connection from the mains.
MAINS DISCONNECT: The plug shall remain readily operable. For rack-
mount or installation where plug is not accessible, an all-pole mains
switch with a contact separation of at least 3 mm in each pole shall
be incorporated into the electrical installation of the rack or building.
FOR UNITS EQUIPPED WITH EXTERNALLY ACCESSIBLE FUSE RECEPTACLE:
Replace fuse with same type and rating only.
MULTIPLE-INPUT VOLTAGE: This equipment may require the use of a dif-
ferent line cord, attachment plug, or both, depending on the available
power source at installation. Connect this equipment only to the
power source indicated on the equipment rear panel. To reduce the
risk of fire or electric shock, refer servicing to qualified service per-
sonnel or equivalent.
This Equipment is intended for rack mount use only.
SAFETY INSTRUCTIONS
NOTICE FOR CUSTOMERS IF YOUR UNIT IS EQUIPPED
WITH A POWER CORD.
WAR N I N G: T H IS AP P LI A N C E M US T B E E A RT H ED.
CONNECT ONLY TO A MAINS SOCKET OUTLET WITH
PROTECTIVE EARTHING CONNECTION.
The cores in the mains lead are coloured in accordance with
the f wing code:ollo
GREEN and YELLOW - Earth BLUE - Neutral BROWN - Live
As colours of the cores in the mains lead of this appliance may
not correspond with the coloured markings identifying the ter-
minals in your plug, proceed as follows:
The core which is coloured green and yellow must be con-
nected to the terminal in the plug marked with the letter E,or
with the earth symbol, or coloured green, or green and yellow.
The core which is coloured blue must be connected to the
terminal marked N or coloured black.
The core which is coloured brown must be connected to the
terminal marked L or coloured red.
This equipment may require the use of a different line cord,
attachment plug, or both, depending on the available power
source at installation. If the attachment plug needs to be
changed, refer servicing to qualified service personnel who
should refer to the table below. The green/yellow wire shall be
connected directly to the units chassis.
WARNING: If the ground is defeated, certain fault conditions in
the unit or in the system to which it is connected can result in
full line voltage between chassis and earth ground. Severe injury
or death can then result if the chassis and earth ground are
touched simultaneously.
LIVE
E
NEUTRAL
EARTH GND
CONDUCTOR
L
N
BROWN
BLUE
GREEN/YEL
BLACK
Normal Alt
WIRE COLOR
WHITE
GREEN
The symbols shown above are internationally
accepted symbols that warn of potential hazards
with electrical products. The lightning flash with
arrowpoint in an equilateral triangle means that
there are dangerous voltages present within the
unit. The exclamation point in an equilateral trian-
gle indicates that it is necessary for the user to
refer to the owner’s manual.
These symbols warn that there are no user ser-
viceable parts inside the unit. Do not open the
unit. Do not attempt to service the unit yourself.
Refer all servicing to qualified personnel. Opening
the chassis for any reason will void the manufactur-
er’s warranty. Do not get the unit wet. If liquid is
spilled on the unit, shut it off immediately and take
it to a dealer for service. Disconnect the unit dur-
ing storms to prevent damage.
C A U T I O N
A T T E N T I O N :
R I S Q U E D E C H O C E L E C T R I Q U E - N E P A S O U V R I R
W A R N I N G :
T O R E D U C E T H E R I S K O F F I R E O R E L E C T R I C
S HO C K D O N O T E X P O S E T H I S E Q U I P M E N T T O R A I N O R MO I S T U R E
R I S K O F E L E C T R I C S HO C K
D O N O T O P E N
IMPORTANT SAFETY INSTRUCTIONS
U.K. MAINS PLUG WARNING
A molded mains plug that has been cut off from the cord is
unsafe. Discard the mains plug at a suitable disposal facili-
ty. NEVER UNDER ANY CIRCUMSTANCES SHOULD YOU INSERT A
DAMAGED OR CUT MAINS PLUG INTO A 13 AMP POWER SOCKET.
Do not use the mains plug without the fuse cover in place.
Replacement fuse covers can be obtained from your local
retailer. Replacement fuses are 13 amps and MUST be ASTA
approved to BS1362.
IMPORTANT SAFETY INSTRUCTIONS
ELECTROMAGNETIC
COMPATIBILITY
This unit conforms to the Product
Specifications noted on the Declaration
of Conformity. Operation is subject to
the following two conditions:
• this device may not cause harmful
interference, and
• this device must accept any interfer-
ence received, including interference
that may cause undesired operation.
Operation of this unit within significant
electromagnetic fields should be avoided.
• use only shielded interconnecting
cables.
Manufacturer's Name: BSS Audio
Manufacturer's Address:8760 S. Sandy Parkway
Sandy, Utah 84070, USA
declares that the product:
Product name: MSR602II and 604II
Note: Product name may be suffixed by
the letters-EU.
Product option: None
conforms to the following Product Specifications:
Safety: IEC 60065 (2001)
EMC: EN 61000-3-2:1995
EN 55013:1990
EN 50082-1:1992
Supplementary Information:
The product herewith complies with the
requirements of the Low Voltage Directive
73/23/EEC and the EMC Directive 89/336/EEC
as amended by Directive 93/68/EEC.
Director of Engineering, BSS Audio
8760 S. Sandy Parkway
Sandy, Utah 84070, USA
Date: May 22, 2006
Revised: October 27, 2006
European Contact:
Your local BSS Audio Sales and Service Office or
Harman Music Group
8760 South Sandy Parkway
Sandy, Utah 84070, USA
Ph: (801) 566-8800
Fax: (801) 566-7005
BSS MSR 602II and 604II
The BSS MSR602 requires a standard 19
inch rack width and single rack-space for
mounting.
In order to ensure proper ventilation and
cooling it is to be mounted with one
empty rack-space above and one empty
rack-space below the unit.

Produktspecifikationer

Varumärke: BSS Audio
Kategori: Inte kategoriserad
Modell: MSR-602

Behöver du hjälp?

Om du behöver hjälp med BSS Audio MSR-602 ställ en fråga nedan och andra användare kommer att svara dig




Inte kategoriserad BSS Audio Manualer

Inte kategoriserad Manualer

Nyaste Inte kategoriserad Manualer