BSS Audio Soundweb 3088 Bruksanvisning

Läs nedan 📖 manual på svenska för BSS Audio Soundweb 3088 (8 sidor) i kategorin Inte kategoriserad. Denna guide var användbar för 2 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Sida 1/8
3088 Signal Processor
Installation Guide
Soundweb 3088 Installation Guide
2
Important Safety Information - Read this carefully
This equipment has been tested and found to comply with the following
European and international Standards for Electromagnetic Compatibility and
Electrical Safety:
Radiated Emissions (EU): EN55013 (1996)
RF Immunity (EU): EN55013-2 (1996)
Electrical Safety (EU): EN60065 (1998)
Electrical Safety (USA): UL6500/ETL (2000)
Electrical Safety (CAN): CAN/CSA-E60065-00 (1994)
Before using the apparatus, read these instructions. Follow all instructions, heed them
and keep them in a safe place.
* Clean only with a dry cloth.
* Do not block any of the ventilation openings. Install in accordance with the manufac-
turers instructions.
* Do not place objects filled with liquid on this apparatus.
* Do not defeat the safety purpose of the grounding type plug. A grounding plug has two
blades and a third grounding prong. The third prong is provided for your safety. When
the provided plug does not fit into your outlet, consult an electrician for replacement
of the obsolete outlet.
* Protect the power cord from being walked upon or pinched, particularly at plugs,
convenience receptacles and the point where they exit from the apparatus.
* Only use attachments/accessories specified by the manufacturer.
* Unplug this apparatus during lightning storms or when not in use for a long time.
WARNING - TO REDUCE THE RISK OF FIRE OR SHOCK, DO NOT EXPOSE THIS
APPARATUS TO RAIN OR MOISTURE.
DO NOT REMOVE COVERS. NO USER SERVICEABLE PARTS INSIDE - REFER
SERVICING TO QUALIFIED SERVICE PERSONNEL.
THIS EQUIPMENT MUST BE EARTHED.
IT SHOULD NOT BE NECESSARY TO REMOVE ANY PROTECTIVE EARTH OR SIGNAL
CABLE SHIELD CONNECTIONS TO PREVENT GROUND LOOPS. ANY SUCH
DISCONNECTIONS ARE OUTSIDE THE RECOMMENDED PRACTICE OF BSS AUDIO
AND WILL RENDER THE EMC OR SAFETY CERTIFICATION VOID.
For continued compliance with international EMC regulations, it is important that all
cables be screened, and connected as follows:
 Audio cable screens to their 3088 connector ground.
 Control cable screens to the ground screws adjacent to the connector.
Soundweb 3088 Installation Guide
3
Mechanical Installation
If the unit is likely to undergo extreme vibration through extensive road trucking and
touring, it must be supported at the rear and/or sides to lessen the stress on the front
mounting flange. Use either a ready-built rack tray or mount the 3088 unit between other
units. Damage caused by insufficient support is not covered by the warranty.
To prevent cosmetic damage to the front panel finish, use protective plastic cups under the
rack mounting bolts.
Front Panel LED Functions
Input Monltorlng
Each channel has 3 LED indicators showing:
Clip
Illuminated = excessive signal level.
Signal
Illuminated = signal is present on this channel input.
Phantom
Illuminated = phantom power is active for this Mic channel.
Scrolling from right to left = recovery mode, the device's firmware
needs reloading.
DSP Clip
Illuminated = indicates that the processed signal is clipping internally.
Comms
Activity
Flashing Yellow =indicates data transfer. The flashing is not
regular, but is dependent on the rate of transfer.
Flashing Red = indicates bad data.

Produktspecifikationer

Varumärke: BSS Audio
Kategori: Inte kategoriserad
Modell: Soundweb 3088

Behöver du hjälp?

Om du behöver hjälp med BSS Audio Soundweb 3088 ställ en fråga nedan och andra användare kommer att svara dig




Inte kategoriserad BSS Audio Manualer

Inte kategoriserad Manualer

Nyaste Inte kategoriserad Manualer