Hoffman A12R106HCLO Bruksanvisning

Hoffman Eluttag A12R106HCLO

Läs nedan 📖 manual på svenska för Hoffman A12R106HCLO (2 sidor) i kategorin Eluttag. Denna guide var användbar för 3 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Sida 1/2
© 2013 Pentair Equipment Protection PH 763 422 2211 • hoffmanonline.com 87567803Rev. B P/N 23155002
Repainting Homan Standard Paint
Check with the paint manufacturer to insure the paint you are applying is compatible
with the paint on the Homan product.
Homan uses the following TGIC polyester powder coating nishes on standard
catalog items:
1. ANSI 61 Gray
2. RAL 7035
3. White
Refer to homanonline.com for the specic paint nish of the product that you
propose to repaint. When in doubt, consult your local Homan distributor.
IMPORTANT: For best adhesion results, correct surface preparation before
repainting is essential.
GENERAL: All Homan TGIC polyester powder coated nishes can be repainted.
IMPORTANT: For best renishing results, always follow the specic instructions
provided by your paint manufacturer.
1. Surface Preparation: Generally the following surface preparation can be used.
A. Thoroughly sand all enclosure surfaces with 180 grit sandpaper. If sanding marks
are objectionable, nish sanding with 220 or 240 grit sandpaper.
B. Wet wipe all surfaces with a solvent to remove any possible contaminants.
C. Apply two or three medium to light coats of paint. Allow two or three minutes
ash o between coats.
D. Allow paint to cure adequately. Consult with your paint manufacturer for proper
cure time and hardness prior to testing the paint for adhesion. Air dry enamels
may require signicantly longer cure times over some powders.
2. Paints to use: Various types of paint exhibit greater adhesion qualities than others
when applied over polyester powder. Below is a list of nishes that exhibit very good
adhesion properties.
Two-component epoxies
• Some two-component polyurethanes
• Alkyd baking enamels
- To avoid discoloration of alkyd nishes do not bake at temperatures
exceeding 150°F.
NOTICE: Always test the repainting process on an inconspicuous area prior to use.

Produktspecifikationer

Varumärke: Hoffman
Kategori: Eluttag
Modell: A12R106HCLO

Behöver du hjälp?

Om du behöver hjälp med Hoffman A12R106HCLO ställ en fråga nedan och andra användare kommer att svara dig




Eluttag Hoffman Manualer

Eluttag Manualer

Nyaste Eluttag Manualer