Jablotron JA-80W Bruksanvisning
Läs nedan 📖 manual på svenska för Jablotron JA-80W (1 sidor) i kategorin Säkerhet. Denna guide var användbar för 3 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare
Sida 1/1
JA-80W wireless combined PIR + MW detector 1 MLI51101
JA-80W wireless combined PIR + MW detector
The JA-80W is a component of Jablotron’s Oasis alarm system. It is
designed to detect human body movement inside buildings. A high immunity to
false alarms is reached thanks to the combination of PIR and microwave (MW)
detection. The PIR part, if triggered, starts the MW detection to confirm PIR
activation. Only then is the triggering transmitted.
Installation
Installation shall only be undertaken by technicians holding a certificate
issued by an authorized distributor. There should be no obstacles blocking the
detector’s “view” of the protected area. Keep the detector away from metal
objects which could interfere with radio communication and the MW field.
8
Description: 1. DIP-switch; 2. MW part connector; 3.PCB tab; 4. tamper-switch; 5.
PIR sensor; 6. front cover tab; 7. MW sensitivity setting; 8. MW detector
1. Open the detector cover by pressing the tab (6) and remove the PCB
which is held by an internal tab (3) Avoid touching the internal PIR
element or damaging the antenna.
2. Punch screw holes through the rear plastic cover according to the
installation point, either for a corner or for a flat wall At least one screw
should penetrate the tamper-sensitive section.
3. Screw the rear cover to the wall, about 2.5 meters above the floor
(vertically, with the tab down).
4. Return the PCB to its original place till the tab (3) clicks..
5. Leave the battery disconnected and the cover open and then follow the
control panel or receiver manual. The basics of enrollment are:
• Enter enrollment mode on the control panel by keying in “1” in
Service mode.
• Install a battery into the detector to activate enrollment.
• Exit enrollment mode by pressing “#”
6. Close the detector cover till the tab clicks. The supplied screw can secure
the tab.
7. After installing a battery into the detector, allow three minutes for
stabilization. During this period the LED is continuously lit.
Notes:
To enroll a detector after having already connected a battery, first disconnect
the battery, and press and release the tamper switch to discharge any
remaining charge to get the device ready for enrollment.
The detector can also be enrolled by entering the serial number – the last
eights numbers of the barcode, which is placed inside the detector.
To follow the EN 50131-2-4 the tab must be secured by the supplied screw.
DIP switch Setting
Switch no.1: DEL / INS: OFF (DEL) provides entrance & exit delays for
detectors installed in a building entrance route. The ON (INS) allows the
detector to instantly trigger alarm activation if the control panel is armed.
DIP switch no.1 only has an effect if the detector has a natural reaction
assigned to it in the OASiS control panel. It also has no effect when used with
a UC-8x or AC-8x receiver.
Switch no.2: PIR NORM / HIGH: selection of immunity to false alarms.
The OFF (NORM) position combines very good immunity with fast sensor
reactions. The ON (HIGH) position gives increased immunity with a slower
reaction time and is only used for problematic installations.
Switch no.3: MW NORM / HIGH sets the time period after PIR detection in
which the MW detection is active. The position OFF – 1 s, ON – 2 s
Switch no.4: MW NORM / TEST. The position OFF is for the standard function
of the detector. The MW detection is triggered by the PIR detection part for one or
two seconds according to switch no.3. The position ON - MW detection works
continuously for testing purposes (walk test).
Testing the detector
15 minutes after closing the detector cover, the LED indicators show detector
activation. A short flash of the red light indicates PIR detection and a long flash
(2 sec) indicates MW confirmation of the movement.
For the proper functioning of the detector, it is essential to set the MW
detection field according to the place which should be monitored. For setting
up, switch the fourth DIP switch to the TEST position. Sensitivity (monitoring
range) can be adjusted by a potentiometer on the MW detection part located
inside the front cover of the detector. Turning clockwise increases the
sensitivity (range). Avoid selecting too high a sensitivity as the detection can
cover e.g. nearby rooms. Generally the MW detection field should be the same
as the PIR detection one. After setting up, switch the DIP switch back to
NORM position.
To save battery energy, the PIR detector switches to battery-save mode 15
minutes after the cover is closed. During battery-save mode the PIR sensor still
always watches out for movement. The first movement detected and consecutively
confirmed by the MW part is then signaled to the control panel instantly, and for the
next 5 minutes the PIR sensor ignores any further movement. After these 5
minutes, the PIR sensor then returns to watching out for movement until re-
triggered.
Battery replacement
The detector regularly checks its battery conditions. If battery voltage is
too low, then the report is sent to the control panel to inform the user or
installer. The detector continues to work and each detected movement is
confirmed by a brief LED flash. The battery should be replaced within two
weeks by a qualified technician in SERVICE mode.
After battery replacement, test the functioning of the detector. Expired
batteries should not be thrown into the garbage, but disposed of according
to local regulations.
Removing the detector from the system
If a detector is removed, the control panel reports the removal. The detector
has to be deleted from its address in the control panel before intentional
removal.
Detection characteristics
Technical parameters
Power supply: Lithium battery type LS(T)14500 (3.6V / 2,4 Ah AA)
Typical battery lifetime: approx. 2 years (DIP switch 3: NORM)
Communication band: 868 MHz, Oasis Protocol
Communication range: approx. 300m (open area)
Recommended installation height: 2.0 to 2.5 m above floor level
PIR detection angle/detection range: 110° / 12 m (with basic lens)
MW detection range / frequency 0.5 to 20 m / 9.35 GHz
Operational environment according to EN 50131-1 II. indoor general
Operational temperature range -10 to +40 °C
EN 50131-1, EN 50131-2-4, EN 50131-5-3 classification: grade 2
Dimensions, weight 110 x 60 x 55 mm, 140 g
Complies with ETSI EN 300220, ETSI EN 300 440-1, EN 50130-4, EN 55022, EN 60950-1
Can be operated according to ERC REC 70-03
Operation requires notification national telecommunication offices of Finland, France, Italy,
Serbia and Montenegro, Spain, Sweden, UK
JABLOTRON ALARMS a.s. hereby declares that the
JA-80W is in compliance with the essential requirements
and other relevant provisions of Directive 99/5/EC. The
original of the conformity assessment can be found at
www.jablotron.com, Technical Support section
Note: Although this product does not contain any harmful
materials we suggest you return the product to the dealer or
directly to the producer after use.
Produktspecifikationer
| Varumärke: | Jablotron |
| Kategori: | Säkerhet |
| Modell: | JA-80W |
Behöver du hjälp?
Om du behöver hjälp med Jablotron JA-80W ställ en fråga nedan och andra användare kommer att svara dig
Säkerhet Jablotron Manualer
11 September 2024
10 September 2024
10 September 2024
10 September 2024
10 September 2024
10 September 2024
10 September 2024
8 September 2024
6 September 2024
6 September 2024
Säkerhet Manualer
- Säkerhet Bosch
- Säkerhet Panasonic
- Säkerhet Honeywell
- Säkerhet Siemens
- Säkerhet Abus
- Säkerhet Alecto
- Säkerhet Alphatronics
- Säkerhet Aritech
- Säkerhet Prestigio
- Säkerhet Airbolt
- Säkerhet Brennenstuhl
- Säkerhet Hikvision
- Säkerhet Nedis
- Säkerhet Yale
- Säkerhet Tevion
- Säkerhet Eminent
- Säkerhet Blaupunkt
- Säkerhet Ezviz
- Säkerhet Trust
- Säkerhet Elro
- Säkerhet Doro
- Säkerhet Axa
- Säkerhet Optex
- Säkerhet Axis
- Säkerhet Theben
- Säkerhet Maginon
- Säkerhet Velleman
- Säkerhet Smartwares
- Säkerhet Easymaxx
- Säkerhet Profile
- Säkerhet Marquant
- Säkerhet Jacob Jensen
- Säkerhet Trebs
- Säkerhet Ednet
- Säkerhet Fenton
- Säkerhet Eufy
- Säkerhet Perel
- Säkerhet Steinel
- Säkerhet Somfy
- Säkerhet Goliath
- Säkerhet Devolo
- Säkerhet Lamax
- Säkerhet Audiovox
- Säkerhet Netgear
- Säkerhet Nest
- Säkerhet Grothe
- Säkerhet LevelOne
- Säkerhet Unitron
- Säkerhet Netatmo
- Säkerhet Goobay
- Säkerhet Switel
- Säkerhet Bticino
- Säkerhet Topcraft
- Säkerhet First Alert
- Säkerhet Sygonix
- Säkerhet Nemef
- Säkerhet Dahua
- Säkerhet Powerfix
- Säkerhet Foscam
- Säkerhet BRK
- Säkerhet Bavaria
- Säkerhet Juwel
- Säkerhet Hagenuk
- Säkerhet Technaxx
- Säkerhet Waeco
- Säkerhet Logicom
- Säkerhet Jupiter Pro
- Säkerhet Xavax
- Säkerhet Marmitek
- Säkerhet Elkron
- Säkerhet Orbis
- Säkerhet Niko
- Säkerhet Gira
- Säkerhet Jung
- Säkerhet Basetech
- Säkerhet Interlogix
- Säkerhet Dnt
- Säkerhet Trendnet
- Säkerhet Fito
- Säkerhet Urmet
- Säkerhet Iget
- Säkerhet Ranex
- Säkerhet Wanscam
- Säkerhet Easy Home
- Säkerhet Geemarc
- Säkerhet Satel
- Säkerhet Dymond
- Säkerhet Notifier
- Säkerhet Friedland
- Säkerhet Plustek
- Säkerhet Golmar
- Säkerhet Grandstream
- Säkerhet Batavia
- Säkerhet Storage Options
- Säkerhet Provision ISR
- Säkerhet NetworX
- Säkerhet Bitron Video
- Säkerhet Eden
- Säkerhet Monacor
- Säkerhet Zmodo
- Säkerhet Elro-Flamingo
- Säkerhet Electronics Line
- Säkerhet One2track
- Säkerhet HUMANTECHNIK
- Säkerhet PIR Alarm
- Säkerhet Heidemann
- Säkerhet Directed Electronics
- Säkerhet Oplink
- Säkerhet BML
- Säkerhet Unitec
- Säkerhet Muller
- Säkerhet Home8
- Säkerhet AVTech - Velleman
- Säkerhet Galaxy
- Säkerhet Sonic Alert
- Säkerhet I-onik
- Säkerhet Smartalarm
- Säkerhet GE Security
- Säkerhet Microtech
- Säkerhet Nor-tec
- Säkerhet Entrya
- Säkerhet Kopp
- Säkerhet Tegui
- Säkerhet Stobo
- Säkerhet Kompernass
- Säkerhet Iiquu
- Säkerhet Storex
- Säkerhet Powermax
- Säkerhet Woonveilig
- Säkerhet Mikros
- Säkerhet V-Tac
- Säkerhet Bolyguard
- Säkerhet Indexa
- Säkerhet Skytronic
- Säkerhet Paradox
- Säkerhet Flamingo FA15RF
- Säkerhet SecuFirst
- Säkerhet BRK DICON
- Säkerhet FBII
- Säkerhet FlinQ
- Säkerhet Dericam
- Säkerhet Myfox
- Säkerhet Kocom
- Säkerhet RISCO Group
- Säkerhet SmartHome
- Säkerhet Bellman
- Säkerhet Protector
- Säkerhet I-Tel
- Säkerhet Home Protector
- Säkerhet Ksenia
- Säkerhet Mr Safe
- Säkerhet Epine
- Säkerhet Inner Range
- Säkerhet Dedicated Micros
- Säkerhet Visonic
- Säkerhet PROmax
- Säkerhet Y-cam
- Säkerhet Selvag
- Säkerhet Voxx
- Säkerhet Fracarro
- Säkerhet Guardall
- Säkerhet Xena
- Säkerhet Smanos
- Säkerhet One Concept
- Säkerhet QuattSecure
- Säkerhet NetBotz
- Säkerhet Securitas
Nyaste Säkerhet Manualer
12 Januari 2025
7 Januari 2025
7 Januari 2025
24 Oktober 2024
22 Oktober 2024
21 Oktober 2024
20 Oktober 2024
20 Oktober 2024
Axis Camera Station S9001 Mk II Desktop Terminal Bruksanvisning
19 Oktober 2024
18 Oktober 2024