Kicker DX400.4 Bruksanvisning

Kicker bilradio DX400.4

Läs nedan 📖 manual på svenska för Kicker DX400.4 (28 sidor) i kategorin bilradio. Denna guide var användbar för 8 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Sida 1/28
DX AMPLIFIER
D
LIVIN’ LOUD
2011 DX 4-Channel Amps RevF.indd 1
2011 DX 4-Channel Amps RevF.indd 1
2011 DX 4-Channel Amps RevF.indd 1
2011 DX 4-Channel Amps RevF.indd 12011 DX 4-Channel Amps RevF.indd 1 11/3/2010 12:19:30 PM
11/3/2010 12:19:30 PM
11/3/2010 12:19:30 PM
11/3/2010 12:19:30 PM11/3/2010 12:19:30 PM
2
DX.4-SERIES AMPLIFIERS
OWNER’S MANUAL
INSTALLATION
Mounting: Choose a structurally sound location to mount your KICKER amplifi er. Make sure there are no items
behind the area where the screws will be driven. Choose a location that allows at least 4(10cm) of open
ventilation for the amplifi er. If possible, mount the amplifi er in the climate-controlled passenger compartment. Drill
four holes using a 7/64 (3mm) bit and use the supplied #8 screws to mount the amplifi er.
Wiring: Disconnect the vehicle’s battery to avoid an electrical short. Then, connect the ground wire to the
amplifi er. Make the ground wire short, 24(60cm) or less, and connect it to a paint-and-corrosion-free, solid,
metal area of the vehicle’s chassis. Adding an additional ground wire of this same gauge (or larger) between the
batterys negative post and the vehicle chassis is recommended.
PERFORMANCE
Authorized KICKER Dealer:
Purchase Date:
Model Number:
Serial Number:
Model: DX200.4 DX400.4
RMS Power
@ 14.4V, 4 stereo, 1% THD+NΩ
@ 14.4V, 2 stereo, 1% THD+NΩ
@ 14.4V, 4 mono, 1% THD+NΩ
25W x 4
50W x 4
100W x 2
50W x 4
100W x 4
200W x 2
Length, in. (cm) 10-1/4” (26) 16-1/8” (41)
Electronic Crossover 18dB/Octave High Pass Fixed
@ 100Hz, 18dB/Octave Low
Pass Fixed @ 80Hz
12dB/Octave, variable
50Hz-200Hz, selectable
HI, LO and OFF
Bass Boost Selectable 0/9dB @ 40Hz Variable 0–12dB @ 40Hz
Speci cations common to all models:
Height, in. (mm) 2-1/4(57)
Width, in. (mm) 8-5/16” (211)
Frequency Response ± 1dB 20Hz–20KHz
Signal-to-noise Ratio >95dB, A-weighted, re: rated power
Input Sensitivity Low Level: 125mV–5V
High Level: 250mV10V
Pro Tip: To get the best performance from your new KICKER Amplifi er and extend the warranty by 1 year, use
genuine KICKER accessories and wiring.
MODEL: DX200.4 / DX400.4
2011 DX 4-Channel Amps RevF.indd 2
2011 DX 4-Channel Amps RevF.indd 2
2011 DX 4-Channel Amps RevF.indd 2
2011 DX 4-Channel Amps RevF.indd 22011 DX 4-Channel Amps RevF.indd 2 11/3/2010 12:19:51 PM
11/3/2010 12:19:51 PM
11/3/2010 12:19:51 PM
11/3/2010 12:19:51 PM11/3/2010 12:19:51 PM
3
AMP1
AMP2
12V
GND REM +12V
Model External Fuse
(sold separately)
Power/Ground Wire KICKER Wiring Kit
DX200.4 1 x 50 Ampere 8 Gauge PK8, ZCK84
DX400.4 1 x 80 Ampere 4 Gauge PK4, CK44, ZCK44
The DX amplifi er has dual input sensitivity differential RCA inputs which will receive either high or low level signals
from your car stereo’s source unit. A high-level signal can be run from the source unit’s speaker outputs to the
stereo RCA input on the end panel of the amplifi er using the KICKER ZISL as shown (make sure you set the DX
amplifi ers input level switch to “HI”). Alternatively, the signal can be delivered to the amplifi er using the low-level
RCA outputs on the source unit. Set the input level switch on the end panel of the amplifi er to “LO”. Either input
method will provide a low-level output signal at the RCA output, which effectively passes the audio signal to
another amplifi er or component. Keep the audio signal cable away from factory wiring harnesses and other
power wiring. If you need to cross this wiring, cross it at a 90 degree angle.
source unit
high-level speaker
outputs
to amplifi er
shield
+
core conductor
battery
external fuse
remote turn-on
(see page 5)
bare-metal
chassis ground
18”
(45cm)
24”
(60cm)
Install a fuse within 18” (45cm) of the battery and in-line with the power cable connected to your amplifi er. If you
ever need to remove the amplifi er from the vehicle after it has been installed, the ground wire should be the last
wire disconnected from the amplifi er--just the opposite as when you installed it.
KICKER ZISL
source unit high-level
speaker outputs
OR to amplifi er
2011 DX 4-Channel Amps RevF.indd 3
2011 DX 4-Channel Amps RevF.indd 3
2011 DX 4-Channel Amps RevF.indd 3
2011 DX 4-Channel Amps RevF.indd 32011 DX 4-Channel Amps RevF.indd 3 11/3/2010 12:19:51 PM
11/3/2010 12:19:51 PM
11/3/2010 12:19:51 PM
11/3/2010 12:19:51 PM11/3/2010 12:19:51 PM

Produktspecifikationer

Varumärke: Kicker
Kategori: bilradio
Modell: DX400.4

Behöver du hjälp?

Om du behöver hjälp med Kicker DX400.4 ställ en fråga nedan och andra användare kommer att svara dig




bilradio Kicker Manualer

bilradio Manualer

Nyaste bilradio Manualer