Kicker ZX350.4 Bruksanvisning

Kicker bilradio ZX350.4

Läs nedan 📖 manual på svenska för Kicker ZX350.4 (28 sidor) i kategorin bilradio. Denna guide var användbar för 3 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/28

ZX AMPLIFIER

ZX350.4

ZX650.4

English Version

Versión Español

Amplificador del la Serie ZX.4

Deutsche Version

Stereoverstärker der ZX.4-Serie

Version Francaise

Amplificateur de série ZX.4

LIVIN’ LOUD

2011 ZX 350.4 650.4 RevC.indd 1

2011 ZX 350.4 650.4 RevC.indd 12011 ZX 350.4 650.4 RevC.indd 1 11/5/2010 1:13:34 PM

11/5/2010 1:13:34 PM

11/5/2010 1:13:34 PM11/5/2010 1:13:34 PM

2ZX AMPLIFIERS

ZX.4-SERIES AMPLIFIERS Owner’s Manual

INSTALLATION

Mounting: Choose a structurally sound location to mount your KICKER ampliﬁ er. Make sure there are no items

behind the area where the screws will be driven. Choose a location that allows at least 4” (10cm) of open

ventilation for the ampliﬁ er. If possible, mount the ampliﬁ er in the climate-controlled passenger compartment. Drill

four holes using a 7/64” (3mm) bit and use the supplied #8 screws to mount the ampliﬁ er.

Wiring: Disconnect the vehicle’s battery to avoid an electrical short. Then, connect the ground wire to the

ampliﬁ er. Make the ground wire short, 24” (60cm) or less, and connect it to a paint-and-corrosion-free, solid,

metal area of the vehicle’s chassis. Adding an additional ground wire of this same gauge (or larger) between the

battery’s negative post and the vehicle chassis is recommended.

The ZX ampliﬁ er has dual input sensitivity differential RCA inputs which will receive either high or low level signals

from your car stereo’s source unit. A high-level signal can be run from the source unit’s speaker outputs to the

stereo RCA input on the end panel of the ampliﬁ er using the KICKER ZISL as shown (make sure you set the ZX

ampliﬁ er’s input level switch to “HI”). Alternatively, the signal can be delivered to the ampliﬁ er using the low-level

RCA outputs on the source unit. Set the input level switch on the end panel of the ampliﬁ er to “LO”. Keep the

audio signal cable away from factory wiring harnesses and other power wiring. If you need to cross this wiring,

cross it at a 90 degree angle.

PERFORMANCE

Authorized KICKER Dealer:

Purchase Date:

Model Number:

Serial Number:

Model: ZX350.4 ZX650.4

RMS Power, all channels driven

@ 14.4V, 4 stereo, 1% THD+NΩ

@ 14.4V, 2 stereo, 1% THD+NΩ

@ 14.4V, 4 mono, 1% THD+NΩ

60W x 4

90W x 4

175W x 2

120W x 4

160W x 4

325W x 2

Length 13-1/2” (342mm) 20” (507mm)

Speciﬁ cations common to all models:

Height 2-1/8” (54mm)

Width 9-5/8” (244mm)

Frequency Response ± 1dB 20Hz–20kHz

Signal-to-noise Ratio >95dB, A-weighted, re: rated power

Input Sensitivity Low Level: 125mV–5V

High Level: 250mV–10V

Selectable Electronic Crossover Variable HI, LO, or OFF (bypass) | 50–200Hz, 12dB/octave

Bass Boost Variable 0–18dB @ 40Hz

Pro Tip: To get the best performance from your new KICKER Ampliﬁ er and extend the warranty by 1 year, use

genuine KICKER accessories and wiring.

MODEL: ZX350.4 / ZX650.4

2011 ZX 350.4 650.4 RevC.indd 2

2011 ZX 350.4 650.4 RevC.indd 22011 ZX 350.4 650.4 RevC.indd 2 11/5/2010 1:13:53 PM

11/5/2010 1:13:53 PM

11/5/2010 1:13:53 PM11/5/2010 1:13:53 PM

Model External Fuse Power/Ground Wire KICKER Wiring Kit

ZX350.4 1 x 60 Ampere 8 Gauge PK8, CK8, ZCK8

ZX650.4 1 x 100 Ampere 4 Gauge PK4, CK4, ZCK4

source unit

high-level speaker

outputs

to ampliﬁ er

shield

–

core conductor

GND REM +12V

12V

battery

external fuse

protection LED

remote turn-on

(see page 5)

bare-metal

chassis ground

18”

(45cm)

24”

(60cm)

AMP1

L+ L- R+ R-

AMP2

L+ L- R+ R-

L+ BRIDGE WIRING R-

AMP2

L LR R

L+ L- R+ R- L+ L- R+ R-

signal in

FOUR CHANNEL OPERATION

minimum impedance of 2 ohms per channel

Install a fuse within 18” (45cm) of the battery and in-line with the power cable connected to your ampliﬁ er. If you

ever need to remove the ampliﬁ er from the vehicle after it has been installed, the ground wire should be the last

wire disconnected from the ampliﬁ er--just the opposite as when you installed it.

KICKER ZISL

source unit high-level

speaker outputs

OR to ampliﬁ er

2011 ZX 350.4 650.4 RevC.indd 3

2011 ZX 350.4 650.4 RevC.indd 32011 ZX 350.4 650.4 RevC.indd 3 11/5/2010 1:13:54 PM

11/5/2010 1:13:54 PM

11/5/2010 1:13:54 PM11/5/2010 1:13:54 PM

Produktspecifikationer

Varumärke:	Kicker
Kategori:	bilradio
Modell:	ZX350.4
Färg på produkten:	Zwart
Snäll:	Zender
Anslutningsteknik:	Bedraad
Maximal videoupplösning:	1920 x 1200 Pixels
Harmoniserad systemkod (HS):	84733080
Könskoppling:	Mannelijk/Vrouwelijk
Anslutning 1:	USB, DVI-D
Anslutning 2:	RJ-45
Antal RJ-45-portar (mottagare):	1