Metra 99-7411 Bruksanvisning

Metra Inte kategoriserad 99-7411

Läs nedan 📖 manual på svenska för Metra 99-7411 (2 sidor) i kategorin Inte kategoriserad. Denna guide var användbar för 2 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF

Sida 1/2

99-7411

INSTALLATION

INSTRUCTIONS

APPLICATIONS

CAR PAGE

NISSAN

300ZX 1984-87.......................................................1-2

KIT COMPONENTS

TOOLS REQUIRED

Cutting tool

Wrench

Phillips screwdriver

(4) Phillips Pan-head

Screws

(4) Speed Clips

KIT FEATURES

Shaft and

DIN unit

provisions

Radio Housing

1-800-221-0932 www.metraonline.com

rev. 250701

1 2

3 4

Locate the factory wiring harness in the

dash. Metra recommends using the

proper mating adaptor and making

connections as shown. (Isolate and

individually tape off the ends of any

unused wires to prevent electrical short

circuit).

Re-connect the battery terminal and test the unit

for proper operation. Mount the factory radio

housing to the sub-dash with (4) Phillips screws

previously removed in step #1.

A) Strip wire ends back ½"

B) Twist ends together

C) Solder

D) Tape

Disconnect the negative battery terminal to prevent an accidental short circuit. Remove the

ashtray and (2) screws exposed. Remove (2) screws above the climate controls. Unclip the

radio trim bezel and remove. Remove (4) Phillips screws securing the factory radio housing,

pull the housing assembly out and disconnect the wiring. Remove the screws securing the

factory radio to the factory radio housing and remove.

2-SHAFT HEAD UNITS: Snap the Faceplate onto the the front of the Radio Housing. Mount

the Faceplate/Radio Housing assembly to the factory radio housing with (4) Phillips Pan-

head Screws (4) Speed Clips and supplied. Slide the aftermarket head unit into the kit and

secure with shaft nuts.

DIN HEAD UNITS: Cut and remove the shaft supports from the Faceplate. Snap the

Faceplate onto the front of the Mount the Faceplate/Radio Housing Radio Housing.

assembly to the factory radio housing with (4) Phillips Pan-head Screws and (4) Speed Clips

supplied. Slide the DIN cage into the Housing and secure by bending the metal locking tabs

down. Slide the aftermarket head unit into the cage until secure.

ALL VEHICLES

Factory radio

housing

Radio trim bezel

Produktspecifikationer

Varumärke:	Metra
Kategori:	Inte kategoriserad
Modell:	99-7411
Färg på produkten:	Wit
Vikt:	600 g
Förpackningens bredd:	82 mm
Djuppackning:	82 mm
Förpackningshöjd:	372 mm
Snäll:	Staafmixer
Lätt att städa:	Ja
Antal hastigheter:	2
Avtagbar bricka:	Nee
Tillgångar:	350 W
Innehåll behållare/burk:	- l
Delar som tål diskmaskin:	Nee
Pulsfunktion:	Ja
Paket innehåll:	Removable filler cap