Metra 99-7625B Bruksanvisning

Läs nedan 📖 manual på svenska för Metra 99-7625B (12 sidor) i kategorin Inte kategoriserad. Denna guide var användbar för 6 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Sida 1/12
METRA. The World’s best kits.metraonline.com © COPYRIGHT 2016 METRA ELECTRONICS CORPORATION
REV. 4/4/2016 INST99-7625B
Installation instructions for part 99-7625B
CAUTION!
All accessories, switches, climate controls panels, and
especially air bag indicator lights must be connected before cycling
the ignition. Also, do not remove the factory radio with the key in the
on position, or while the vehicle is running.
ISO DIN radio provision with pocket
ISO DDIN radio provision
Painted matte black
A) Radio trim panel with HVAC controls • B) Radio brackets • C) Upper keypad • D) Pocket
• E) (2) Panel clips • F) (6) #8 x 3/8” Phillips screws • Axxess interface and harness (not shown)
KIT FEATURES
KIT COMPONENTS
WIRING & ANTENNA CONNECTIONS (sold separately)
Wiring Harness: • Included with kit
Antenna Adapter: • 40-NI12
• Phillips screwdriver • Panel removal tool
Torx driver
TOOLS REQUIRED
(without NAV, with auto climate)
A CB D E F
Dash Disassembly ..............................................2-3
Kit Assembly
– Pre-Assembly 4 ......................................................
ISO DIN radio provision......................................... 5
ISO DDIN radio provision 6 ......................................
Axxess Interface installation ...........................7-12
Table of Contents
99-7625B
Dash Disassembly
1. Slide the shifter boot down and
remove clip holding shifter knob
and remove shifter knob.
(Figure A)
2. Unclip and remove shifter boot trim
panel. (Figure B)
3. Remove (2) screws at the bottom
of the radio/climate control panel
and remove panel. (Figure C)
4. Remove (2) screws at the bottom
of the factory display panel and
remove panel with the vents.
(Figure D)
Continued on next page
(Figure A) (Figure C)
(Figure B) (Figure D)
99-7625B
Dash Disassembly
(Figure E) (Figure F) (Figure G)
5. Remove the (4) Philips screws
securing the factory controls in the
panel removed in step 4 and save
for Kit Assembly. (Figure E)
6. Remove (4) Phillips screws
securing the radio chassis and
a/c amp bracket assembly then
remove the assembly from the
dash. (Figure F)
7. Remove (2) Torx screws securing
the a/c amp module to the radio
chassis/ bracket assembly and
save for Kit Assembly. (Figure G)
Continue to kit assembly

Produktspecifikationer

Varumärke: Metra
Kategori: Inte kategoriserad
Modell: 99-7625B

Behöver du hjälp?

Om du behöver hjälp med Metra 99-7625B ställ en fråga nedan och andra användare kommer att svara dig




Inte kategoriserad Metra Manualer

Inte kategoriserad Manualer

Nyaste Inte kategoriserad Manualer