Metra DP-7414 Bruksanvisning

Läs nedan 📖 manual på svenska för Metra DP-7414 (8 sidor) i kategorin Inte kategoriserad. Denna guide var användbar för 5 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Sida 1/8
Metra. The World’s Best Kits.® MetraOnline.com © COPYRIGHT 2023 METRA ELECTRONICS CORPORATION REV. 1/12/23 INSTDP-7414
I N S TA L L AT I O N I N S T R U C T I O N S
DP-7414
Attention! With the key out of the ignition,
disconnect the negative battery terminal
before installing this product. Ensure that all
installation connections are secure before
cycling the ignition to test this product.
KIT FEATURES
ISO DDIN radio provision
Textured
KIT COMPONENTS
A) Radio housing • B) Climate control trim panel • C) Radio brackets • D) Climate control bracket set #1 E) Climate control bracket set #2 • F) Climate control cable clamp bottom
(2) • G) Climate control cable clamp top (2) • H) #8 x 3/8” Phillips screws (8) • I) #6 x 7/8” Phillips screws (4) • J) Speed clips (2) • K) Metal panel clips (4) • L) Plastic panel clips (2)
TOOLS REQUIRED
• Panel removal tool • Phillips screwdriver
• Socket wrench
TABLE OF CONTENTS
Dash Disassembly ...............................................2-3
Kit Preparation .......................................................4
Kit Assembly ......................................................5-6
WIRING & ANTENNA CONNECTIONS
(sold separately)
Wiring Harness:
Visit metraonline.com for audio/
video and steering wheel control interface options.
Antenna Adapter: Not required
A B
GF
C
H I J K L
D E
Nissan Sentra 2000-2006
Visit for more detailed information about the product and up-to-date vehicle MetraOnline.com
specific applications
386.257.1187
|
MetraOnline.com
2
DASH DISASSEMBLY
1. Open the storage compartment above
the radio, and pull out on the lip
of the compartment to remove the
compartment/AC vent assembly.
(Figure A)
2. Below the climate control, unclip and
remove the trim panel around the
pocket. (Figure B)
(Figure A) (Figure C)
(Figure B) (Figure D)
101.1
101.1
1 2 3 4
3. Disconnect the (2) climate control cables
from under the dash on the driver’s side
above the accelerator pedal.
Note: Observe the route that the cables
take through the dash so you can put
them back in the same place in Kit
Assembly (Figure C, D)
Continued on the next page
REV. 1/12/2023 INSTDP-7414 3
(Figure F)
DASH DISASSEMBLY (CONT.)
101.1
1
2
3 4
(Figure E)
3. Remove (4) screws securing the radio/
climate-control/pocket assembly (two
on top, two on bottom), then unplug
and remove the entire assembly.
(Figure E)
5. Remove (4) Phillips screws securing the
climate control to the sub dash.
(Figure F)
6. Twist the climate control inside the dash
cavity and pull out to remove.
Note: Observe the route that the cables
take through the dash so you can put
them back in the same place in
Kit Assembly.
Continue to Kit Preparation

Produktspecifikationer

Varumärke: Metra
Kategori: Inte kategoriserad
Modell: DP-7414

Behöver du hjälp?

Om du behöver hjälp med Metra DP-7414 ställ en fråga nedan och andra användare kommer att svara dig




Inte kategoriserad Metra Manualer

Inte kategoriserad Manualer

Nyaste Inte kategoriserad Manualer