AXESS AXVI-2004 Bruksanvisning

Läs nedan 📖 manual på svenska för AXESS AXVI-2004 (4 sidor) i kategorin Inte kategoriserad. Denna guide var användbar för 2 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Sida 1/4
AXVI-2004
I N S T A L L A T I O N I N S T R U C T I O N S
AxxessInterfaces.com © COPYRIGHT 2020 METRA ELECTRONICS CORPORATION REV. 1/22/20 INSTAXVI-2004
Product Info
INTERFACE FEATURES
INTERFACE COMPONENTS
TOOLS & INSTALLATION ACCESSORIES REQUIRED
• Crimping tool and connectors, or solder gun,
solder, and heat shrink • Tape • Wire cutter
• Zip ties
TABLE OF CONTENTS
Connections ............................................................2
Installation .............................................................2
Programming .........................................................3
Adjustments ...........................................................3
Chevrolet Corvette Data Interface
1997-2004
Provides accessory power (12-volt 10-amp)
Retains R.A.P. (retained accessory power)
High level speaker input
Retains amplified door woofers
Micro-B USB updatable
• AXVI-2004 interface • AXVI-2004 harness package* • Differential converter
* Consists of (2) harnesses
2
CONNECTIONS INSTALLATION
From the AXVI-2004 harness to the aftermarket radio:
Connect the wire to the ground wire.Black
Connect the Yellow wire to the battery wire.
Connect the wires (qty. 2) to the accessory wire.Red
Connect the wire to the amp turn on wire.Blue/White
Connect the wire to the illumination wire (If applicable)Orange
Connect the wire to the front right positive speaker output.Gray
Connect the Gray/Black wire to the front right negative speaker output.
Connect the wire to the front left positive speaker output.White
Connect the wire to the front left negative speaker output.White/Black
Connect the wire to the rear right positive speaker output.Purple
Connect the wire to the rear right negative speaker output.Purple/Black
Connect the wire to the rear left positive speaker output.Green
Connect the wire to the rear left negative speaker output.Green/Black
Differential converter:
1. Connect the 12-pin speaker harness
from the AXVI-2004 harness into the
differential converter.
2. Connect the 8-pin harness from the
AXVI-2004 harness package into the
differential converter, and then to the
wiring harness in the vehicle.
AXVI-2004 interface:
3. Connect the 12-pin power harness from
the AXVI-2004 harness into the
AXVI-2004 interface.
4. Connect the AXVI-2004 harness to the
wiring harness in the vehicle.
Attention! There are two identical 12-pin harnesses from the AXVI-2004 harness, one with power
wires, and one with speaker wires.
Res et
LED
OUTPUT
INPUT
I N T E G R A T E
LD XSVI-GM5-AX-
TO XSVI
XSVI-2004 INTERF EAC
RADIO CONNECTIONS
DIFFERENTIAL NVERTERCO
VEHICLE NNECTORSCO
1
3
2
3
REV. 1/22/2020 INSTAXVI-2004
Audio Level Adjustment
1. Turn the volume of the radio up 3/4 of the way.
2. With a small flat-blade screwdriver, adjust the (4) potentiometers clockwise to raise the
audio level; counterclockwise to lower.
3. Once at a desired level, audio level adjustment is complete.
PROGRAMMING ADJUSTMENTS
1. Cycle the key on and wait until the radio comes on.
Note: If the radio doesn’t come on within 60 seconds, cycle the key off then unplug the
interface. Check all connections, reconnect the interface, and then try again.
2. Cycle the key off. If the driver’s door is closed, open and close the door. Cycle the key back on.
3. Test all functions of the installation for proper operation, before reassembling the dash.
Note: The LED in the differential convertor is inoperable.
Attention! If the interface loses power for any reason, the following steps will need to be
performed again.

Produktspecifikationer

Varumärke: AXESS
Kategori: Inte kategoriserad
Modell: AXVI-2004

Behöver du hjälp?

Om du behöver hjälp med AXESS AXVI-2004 ställ en fråga nedan och andra användare kommer att svara dig




Inte kategoriserad AXESS Manualer

Inte kategoriserad Manualer

Nyaste Inte kategoriserad Manualer