Elba ETC-E2700 Bruksanvisning

Elba Kran ETC-E2700

Läs nedan 📖 manual på svenska för Elba ETC-E2700 (1 sidor) i kategorin Kran. Denna guide var användbar för 8 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Sida 1/1
1. Install the intake (A) on the wall.
2. Put the tape(C) around the screw threaded tube, cover the rosette (B) and screw into pipeline.
3. Connect water and check if the screw has been sealed tightly.
pipeline
Before installation, please ensure that the following work
conditions are adhered to:
-Water temperature between 0 C - 90 C˚ ˚
-Water pressure between 0.05MPa 1.0MPa. Pressure reducing
valve is necessary if pressure exceeds 1.2MPa
-Avoid major pressure di erences between hot and cold water
supply
Flush pipes thoroughly before and after installation to ensure
water supply is free of any debris.
Inspect tap fitting and debugged to its best. Do not attempt to
disassemble fitting on your own.
Use thread sealant tape (PTFE) on any screw joining
connections and ensure all joints are securely tightened.
ETC-E2700
This . FIAMMA SDN. BHD. will not be held responsible for the use of superseded or voided specifications.
Fabricatoe must check for cut-out accuracy.
specification is subject to change without notice
Stainless Steel Cold Water Tap

Produktspecifikationer

Varumärke: Elba
Kategori: Kran
Modell: ETC-E2700

Behöver du hjälp?

Om du behöver hjälp med Elba ETC-E2700 ställ en fråga nedan och andra användare kommer att svara dig