Zagg ID8RGK-BBG Bruksanvisning

Zagg Tangentbord ID8RGK-BBG

Läs nedan 📖 manual på svenska för Zagg ID8RGK-BBG (24 sidor) i kategorin Tangentbord. Denna guide var användbar för 11 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Sida 1/24
Rugged Book
Keyboard Instructions
See the important Health and Safety information on page 6 before using this product.
*WARRANTY REGISTRATION
Your ZAGG® Rugged Book comes with a one-year manufacturer’s warranty. In order to activate the warranty,
you must register your Rugged Book as well as keep your purchase receipt. If you purchased your ZAGG
Rugged Book from ZAGG.com, ZAGG® has already registered it and has a copy of your proof of purchase.
NEED MORE HELP? PLEASE SEE OUR FAQ SECTION AT: www.ZAGG.com/faq
INSERTING/REMOVING YOUR TABLET
To insert your tablet into the Rugged Book open the Book’s
case and remove it from the keyboard (to do this pull the case
up and away from the keyboard). Then, line up your tablet with
the holes in the case. Make sure the camera hole is aligned
properly as well as the opening for your charging cable. When
everything is aligned, set the bottom half of your tablet in the
cover and apply light pressure to ensure its properly settled.
Snap the top half of your tablet into the cover. Check all
corners to make sure they have seated properly.
When your tablet is secure in the case, you can connect it to
the keyboard by placing it in the magnetic trough. Powerful
magnets will secure it in place, but will also allow you to
remove your tablet any time it benefits you.
To easily remove your tablet from the case, separate the case
from the keyboard, and then gently roll the rubber overmold
away from the edges while pressing the tablet from behind.
Grasp your tablet’s exposed side and lift/pull away from the
Rugged Book.
1
POWERING ON AND OFF
To turn your Rugged Book on, press the Power button. A green
LED on the battery key will illuminate briefly while the keyboard
powers up. To turn your Rugged Book
off, press and hold the Power button
for three seconds. A red LED will flash,
indicating your Rugged Book has
turned off.
PAIRING YOUR ZAGG Rugged Book
Pairing your Rugged Book with your tablet is easy. It should only need to be
paired once, using the following directions. If the connection between your
tablet and Rugged Book is ever lost, repeat these steps.
1. Access the Bluetooth settings on your tablet.
2. Press and hold the Bluetooth button for three
seconds. A blue LED under the Power key will
flash until your Rugged Book and tablet
are paired.
3. Your tablet will display “ZAGG Rugged Book”
as an available device. Select this option to
complete pairing.
2
CHARGING
Your Rugged Book features a powerful lithium polymer battery that lasts for up
to two years of normal use between charges*. It comes with a charging cable
you can use to charge your keyboard quickly and conveniently. To charge your
Rugged Book, follow these steps:
1. Plug the micro USB connector into the charging port.
2. Plug the regular USB connector into any USB outlet.
3. A red LED under the Power button will illuminate to indicate your Rugged
Book is charging. Wait until this light turns off, indicating a full charge. It
usually takes 2-4 hours to completely charge your Rugged Book.
4. Remove the micro USB connector and enjoy your Rugged Book for up to
two years before you need to charge it again.
* Normal use is approximately one hour of use per day without the backlit feature. Using the backlit feature will impact
battery life and will require more frequent charging.
CHARGING PORT

Produktspecifikationer

Varumärke: Zagg
Kategori: Tangentbord
Modell: ID8RGK-BBG

Behöver du hjälp?

Om du behöver hjälp med Zagg ID8RGK-BBG ställ en fråga nedan och andra användare kommer att svara dig




Tangentbord Zagg Manualer

Tangentbord Manualer

Nyaste Tangentbord Manualer