Audiovox PRO-9056TW Pursuit Series Bruksanvisning

Audiovox Säkerhet PRO-9056TW Pursuit Series

Läs nedan 📖 manual på svenska för Audiovox PRO-9056TW Pursuit Series (2 sidor) i kategorin Säkerhet. Denna guide var användbar för 2 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Sida 1/2
128-8856
1 of 2
Single Channel Remote
Car Starter
Model PRO-9056TW
Owner’s Manual
FEATURES :
1 Programmable RF Transmitters, 1 Programmable RF Transceiver
Single Channel Receiver (capable of accepting 4 transmitters)
External Superheterodyne Receiver Antenna w/PushButton Switch &
Orange LED
On-Board Start Relay
On-Board Accessory Relay
On-Board Ignition 1 Relay
On-Board Ignition 2 Relay
Ignition 2 Relay Selectable On or Off During Cranking
On-Board Parking Light Relay
Ignition 3 / Shock By-Pass / GM VAT Output (relay required)
Tach Signal Learning Circuit
Two ( + ) and Two ( - ) Safety Shutdown Circuits
Alarm By-Pass Output
Accessory Outputs
(Pulse Before & After Start, During Crank & After Shut Down)
Selectable Steady or Flashing Parking Lights for Run Indication
Selectable 5, 10, 15, 20 Minute Run Time
Optional Door Unlock Feature For Vehicles Equipped With Power Doors
(Only operational while running under control of the remote start unit.)
128-8856
2 of 2
2
© 2010 Audiovox Electronics Corp., 150 Marcus Blvd., Hauppauge, NY 11788 128-8856
REMOTE STARTING THE VEHICLE
This will not start the vehicle if any one of the following situations exists:
The vehicle's hood lid is opened.
The gear shift selector is not in Park.
The brake pedal is depressed.
The safety control switch is in the Off position.
1) To start the vehicle, press and release the transmitter button two times within
2 seconds. The vehicle will start and remain running for the
pre-programmed time up to a 60 minute run cycle. As a
visual indication, the parking lights will flash or remain on
depending on the setting by your installation center. Addi-
tionally if the two way transceiver shown on the right is used,
the transceiver will play a melody when the vehicle is started,
and the Orange LED surrounding the transceiver button will
flash every ten seconds while the vehicle is running.
2) When you arrive at the vehicle, turn the ignition key to the
ON position (not the spring loaded start position), then step
on the brake pedal to disengage the remote starter. The
vehicle will continue to run, but now on its own power.
NOTE: The engine will stop running before the pre-programmed
run cycle has expired if you perform any one of the following
functions:
-Press the button on the keychain transmitter two times within 2 seconds
-Depress the brake pedal
-Open the vehicle's hood
-Move the safety control switch to the Off position.
PUSH-BUTTON LED RECEIVER VALET/OVERRIDE/SAFETY CONTROL SWITCH
The Push-Button LED switch located in the receiver allows you to temporarily disable the remote
starting function of the system. This recommended whenever the vehicle is being serviced. To place
the system in the service mode:
1) With the system disarmed/unlocked, and the ignition switch off, Press and Hold the Push-Button
switch found on the windshield receiver, in.
2) Turn the ignition switch on, off, on, off, on, off.
3) The Orange LED begins to flash two short flashes followed by one long flash and continues this
pattern until the unit is returned to the normal mode of operation.
The above action puts the unit into the Remote Start Override/Service mode and will not start from
the RF transmittor or any other input, Posse or otherwise.
To Exit Remote Start Override Mode
1) With the system disarmed, Press and Hold the Push-Button switch found on the windshield
receiver, in.
2) Turn the ignition switch on, off, on, off, on, off.
3) The LED turns off indicating that the Remote Start unit is fully functional once again.
UNLOCKING THE VEHICLE:
If you have electric door lock, and the Optional Unlock feature was added, with the vehicle running
under command of the remote start unit, press and hold the transmitter button for 3 seconds until
the doors unlock.
TELEMATIC UPGRADE:
This system has the ability to have a telematic upgrade module connected to it. This is an upgrade that
can give you control of certain functions of your vehicle from a Telephone, or in some cases a
computer interface. Please check with your installation center for most recent Telematic Upgrades. If
you had a Telematic Upgrade installed, the manual supplied with the upgrade unit will provide a
operator's manual advising of the features of the system and means available to control these
features of your vehicle.
.FUNCTION SETTING CHART To be completed by installer
Run Time 5 Min 10 Min 15 Min 20 Min
Lights Pulse Steady

Produktspecifikationer

Varumärke: Audiovox
Kategori: Säkerhet
Modell: PRO-9056TW Pursuit Series

Behöver du hjälp?

Om du behöver hjälp med Audiovox PRO-9056TW Pursuit Series ställ en fråga nedan och andra användare kommer att svara dig




Säkerhet Audiovox Manualer

Säkerhet Manualer

Nyaste Säkerhet Manualer