Dexford WS 2200 Bruksanvisning

Dexford Väderstation WS 2200

Läs nedan 📖 manual på svenska för Dexford WS 2200 (3 sidor) i kategorin Väderstation. Denna guide var användbar för 3 personer och betygsatt med 4.5 stjärnor i genomsnitt av 2 användare

Ladda ner PDF
Sida 1/3
User’s manual
Weather station with wireless outdoor sensor
WS-2200
Overview:
Indoor unit:
1. Display:
Shows time, indoor and outdoor temperature and
weather forecast.
2. button :SNOOZE / LIGHT
Snooze button for the alarm function.
Also turns on the display lighting.
3. button :ALARM SET
For checking and setting the wake-up alarm.
4. button:CH/+
Selection button when using multiple outdoor units
and the ‘+’ button during setup.
5. button:MEM/-
Memory button when checking min and max val-
ues and the ‘-’ button during setup.
6. DISPLAY SET button:
Function setup button.
7. switch:°C / °F
To switch the temperature display between
degrees Celsius and degrees Fahrenheit.
8. button:SENSOR
To pair the indoor unit with the outdoor unit.
9. button:RCC
To turn the DCF receiver on or off.
10. RESET button:
To restart the indoor unit in case of a (possible)
error.
11. Battery compartment.
Outdoor unit:
1. Monitor-LED:
Illuminates as soon as the outdoor unit is sending
measurement data to the indoor unit.
2. switch:CH 1.2.3
To set the outdoor unit to a different channel.
3. button:RESET
To restart the outdoor unit in case of a (possible)
error.
4. Suspension eye:
Provision to suspend the outdoor unit from a wall.
5. Battery compartment.
Power supply:
Indoor unit:
Slide down the battery cover at the rear of the unit
and insert 2 AA 1.5V batteries according to the mark-
ings inside the battery compartment. Slide the battery
cover back onto the indoor unit.
The indoor unit will now start a 1 minute scan to
search for the outdoor unit. Therefore, you’ll need to
insert the batteries into the outdoor unit within that
minute.
Outdoor unit:
Slide down the battery cover at the rear of the unit,
slide the CH switch to the position ‘1’ and insert 2 AA
1.5V batteries according to the markings inside the
battery compartment. Slide the battery cover back
onto the outdoor unit.
Weak battery warning:
As soon as the batteries of the outdoor unit become
exhausted, the symbol will illuminate on the
display of the indoor unit.
Now please replace the batteries of the outdoor unit.
The indoor unit does not provide a battery warning.
Replace the batteries of this unit as soon as the
display becomes dim or weak.
Pairing the indoor unit / outdoor unit:
Automatically:
As soon as you insert the batteries into the indoor
unit, the indoor unit will start a 1 minute scan to
search for the signal of the outdoor unit. Therefore,
if you insert the batteries into the outdoor unit within
that minute and the units will ‘nd’ each other, they
will be automatically paired and the display of the
indoor unit will show the temperature transmitted by
the outdoor unit.
Manually:
If the units cannot be paired automatically, or after
replacing the batteries, you can pair the outdoor unit
(again) with the indoor unit as follows:
1. use a sharp object to briey press the RESET
button on the rear of the indoor unit
2. use a sharp object to briey press the RESET
button on the rear of the outdoor unit
3. the units will nd each other (again) after several
seconds and the indoor unit will display the tem-
perature transmitted by the outdoor unit.
Clock:
Introduction
The WS-2200 is provided with a built-in DCF receiver
which receives the DCF time signal from Frankfurt.
This signal ensures that the clock shows the time
very accurately, provided a strong enough signal is
being received.
Automatically:
As soon as you insert the batteries into the indoor unit,
the clock will start searching for the DCF radio signal
for the time while the antenna symbol is ashing.
After several seconds or minutes the WS-2200 will
start showing the correct time. In extreme cases, it can
take over a day before the DCF time is shown.
Manually:
If the clock cannot receive the radio signal or cannot
receive it well enough, you can set the clock manually
as follows:
1. press and hold the DISPLAY SET button for
2 seconds, 12Hr or 24Hr will appear in the display
2. use +/- to set the time format, then briey press
the DISPLAY SET button
3. use +/- to set the hours and then briey press the
DISPLAY SET button
4. use +/- to set the minutes and then briey press
the DISPLAY SET button
5. use +/- to set the seconds to 0 (this allows you to
have the clock run synchronously with your own
clock) and then briey press the DISPLAY SET
button
6. use +/- to set the hour difference compared to the
DCF time. E.g. for use in the Benelux select ‘0’
and then briey press the DISPLAY SET button
The clock is now set manually.
When the DCF receiver is enabled and a strong
signal is being received, the receiver will overwrite
the clock display.
Switching the DCF receiver on/off:
You can turn off the DCF receiver as follows, allowing
you to have only the time and date shown on the
display according to your programming:
• turn off: press and hold the button at the RCC
rear of the indoor unit for 4 seconds until the
antenna symbol disappears.
You can turn the receiver back on as follows:
• button at the rear of turn on: briey press the RCC
the indoor unit until the antenna symbol starts
ashing
‘DST’ in the display.
‘DST’ stands for Daylight Saving Time.
‘DST’ illuminates when the displayed time is the
daylight saving time.
1 2 3 4
1
2
3 6
54
7
8 9
10
11
43 3 M Hz
THER MO SE NSO R
RESET CH 1 2 3
Alarm
Setting & turning on the wake-up alarm:
1. press and hold the button for ALARM SET
2 seconds
2. use +/- to set the hours and briey press the
ALARM SET button
3. use +/- to set the minutes and briey press the
ALARM SET button, the alarm time is now saved
(and is also activated immediately)
Switching on/off:
Briey press 2x the ALARM SET button. When
the wake-up alarm is currently enabled, “ ” will be
shown; if “ ” is not illuminated, the alarm is disabled.
Operation:
• As soon as the set time is reached, the alarm will
sound for up to 120 seconds.
• Press the button to stop the alarm ALARM SET
signal earlier or press the but-SNOOZE/ LIGHT
ton to enable the snooze function; the wake-up
alarm will then sound again after 5 minutes.
• The alarm is repeated daily.
Temperature display
Use the switch at the rear of the indoor unit °C / °F
to display the temperature in degrees Celsius or in
degrees Fahrenheit.
The symbol is followed by the indoor temperature.
Behind that the outdoor unit is shown from out-
door unit 1.
Use the button at the rear of the indoor unit to CH
display the temperature from outdoor unit 2 or 3 or
press and hold the for 2 seconds to automatically CH
start scrolling through all channels. Briey press the
CH button to stop this scan.
See also chapter ‘ ’.Expansion
Max/min temperature:
Briey press the MEM button to check the maximum
temperature measured, press the button again MEM
for the minimum temperature.
Press and hold the button for 3 seconds to MEM
delete the MAX and MIN values. Also after replacing
the batteries of pressing the button, the MAX RESET
and MIN values are deleted.
Ice alarm:
As soon as the outdoor temperature falls within a
range of +3°C and -2°C, the - symbol starts ash
ing in the display.
Weather forecast:
The WS-2200 can predict the weather for the
following 12 to 24 hours based on the changes in air
pressure and shows this forecast using the following
icons:
Remarks:
• the accuracy of a forecast based on air pressure
is 70% to 75%; please keep in mind that a correct
display of the weather forecast is not guaranteed.
• the prediction is based on the coming 12 to 24
hours and does not necessarily represent the cur-
rent weather conditions.
• the ‘Sunny’ forecast shown at night means an
open weather type.
• the ‘Rainy’ prediction during winter, usually means
snow.
Expansion:
You can register up to 3 outdoor units to the indoor
unit to have the temperature measured at 3 different
locations (e.g. in your greenhouse, pet room, differ-
ent bedrooms, etc.). You can order additional outdoor
via the Alecto customer service at phone number 073
6411 355 (Netherlands) or 03 238 5666 (Belgium) or
via the internet at www.alecto.info
Registering additional outdoor units:
1. slide down the battery cover at the rear of the
new outdoor unit and insert 2 AA 1.5V batter-
ies according to the markings inside the battery
compartment.
2. just above the batteries at the rear of the outdoor
unit, slide the ‘ ’ channel switch to position 2 or CH
position 3.
3. slide the battery cover back onto the outdoor unit.
4. at the now repeatedly and briey press the CH
rear of the indoor unit until or illuminates
(depending on whether you’ve selected ‘ ’ or CH-2
‘CH-3’ in the outdoor unit) and then briey press
the button.SENSOR
5. the indoor unit will now start searching for the out-
door unit and as soon as the units nd each other,
the temperature will be shown on the display of
the indoor unit.
Reset/System error:
If the WS-2200 shows a possible error, you may have
to reset the indoor and outdoor unit.
1. use a sharp object to press the reset button at the
rear of the indoor unit.
2. use a sharp object to press the reset button at
the rear of the outdoor unit (for this, you’ll need to
briey remove the battery cover from the outdoor
unit).
The indoor and outdoor units will then be reset and a
new pairing scan will start. After several seconds, you
can continue using the WS-2200.
If you still have no connection or sound, please
contact the customer service of Alecto via the phone
number 073 6411 355 (Netherlands) or 03 238 5666
(Belgium) or via internet www.alecto.nl
Specications:
Indoor unit:
measurement range: -40°C ~ 70°C (-40°F ~ 158°F)
recommended operating temperature:
0°C ~ 45°C (32°F ~ 113°F)
resolution: 0.1°C / 0.1°F
DCF receiver: DCF-77
power supply: 2x 1.5V battery, size AA
battery lifespan: 1 year
dimensions: 84(W)x141(H)x47(D)mm
weight: 186g (batt incl.)
amount of outdoor units to register: max 3
Outdoor unit:
measurement range: -40°C ~ 70°C (-40°F ~ 158°F)
recommended operating temperature:
-20°C ~ 55°C (-4°F ~ 131°F)
resolution: 0,1°C / 0,1°F
power supply: 2x 1,5V battery, size AA (*)
battery lifespan: 1 year
dimensions: 65(W)x100(H)x35(D)mm
weight: 75g (batt incl.)
*: for long-term use at temperatures below 0°C,
we recommend using Lithium batteries which you
can order via the Alecto customer service at phone
number 073 6411 355 (Netherlands) or 03 238 5666
(Belgium) or via the internet at www.alecto.nl.
Radio:
transmission frequency: 433MHz
channels: 3
reception interval: 60-64sec.
range: 50m
Symbol :
Only illuminates: no outdoor unit is registered
on this channel.
ashing: the indoor unit is searching
for the outdoor unit.
remains lit: the indoor unit is connected
to the outdoor unit
Declaration of conrmity
The declaration of conformity is
available on the website
WWW.ALECTO.NL
Environment:
At the end of its lifespan, this product should not be
discarded as normal domestic waste, but is must be
taken to a collection point for the recycling of electric
and electronic equipment.
Don’t throw away exhausted batteries, take
them to your local depot for small chemical
waste.
5 6 7 8
Sunny partly
cloudy
cloudy rainy
ver1.2
Service Help
WWW.ALECTO.NL
SERVICE@ALECTO.NL
NL 073 6411 355
(Lokaal tarief)
BE 03 238 5666
(Lokaal tarief)
(Tarif local)
DE 0180 503 0085
Lokale Festnetzkosten
Hesdo, Australiëlaan 1
5232 BB, ‘s-Hertogenbosch
The Netherlands

Produktspecifikationer

Varumärke: Dexford
Kategori: Väderstation
Modell: WS 2200

Behöver du hjälp?

Om du behöver hjälp med Dexford WS 2200 ställ en fråga nedan och andra användare kommer att svara dig


Väderstation Dexford Manualer

Dexford

Dexford SPA-WS 100 Bruksanvisning

14 September 2024
Dexford

Dexford PCWS 4600 Bruksanvisning

14 September 2024
Dexford

Dexford WSRC 2257 Bruksanvisning

13 September 2024
Dexford

Dexford WS 2200 Bruksanvisning

13 September 2024
Dexford

Dexford WSRC 3500 Bruksanvisning

13 September 2024
Dexford

Dexford RRCW 4700 Bruksanvisning

13 September 2024
Dexford

Dexford RAC 4700 Bruksanvisning

13 September 2024
Dexford

Dexford WS 4880 Bruksanvisning

12 September 2024
Dexford

Dexford RAC 4618 Bruksanvisning

12 September 2024

Väderstation Manualer

Nyaste Väderstation Manualer

Ascot

Ascot GT-WS-07s Bruksanvisning

20 Oktober 2024
Ventus

Ventus K0382 Bruksanvisning

18 Oktober 2024
Hyundai

Hyundai WSP 3080 Bruksanvisning

15 Oktober 2024
La Crosse Technology

La Crosse Technology V61 Bruksanvisning

8 Oktober 2024
Cresta

Cresta WX580M Bruksanvisning

6 Oktober 2024
Sencor

Sencor SWS 65 Bruksanvisning

5 Oktober 2024
Irox

Irox JKR-1 Bruksanvisning

5 Oktober 2024
TFA

TFA 30.5002 Bruksanvisning

5 Oktober 2024
TFA

TFA WeatherHub 30.3306.02 Bruksanvisning

4 Oktober 2024
Jung

Jung WS10R Bruksanvisning

4 Oktober 2024